4.7 Article

Investigation of wear and corrosion characteristics of PTFE/TiN composite coating on SS-304 fabricated by two-step sputtering technique

Related references

Note: Only part of the references are listed.
Article Chemistry, Physical

Structural and corrosion resistance properties of sputtered zirconium nitride thin films as electrode material for supercapacitor

Shangtao Zhang et al.

Summary: The study found that the magnetron sputtered zirconium nitride thin films have homogeneous and dense surfaces with low roughness; increasing nitrogen partial pressure leads to a higher content of Zr3N4 in the films; ZrN0.4 exhibits the best corrosion resistance in Na2SO4 solution, attributed to lower density of pin-hole defects and a dense passive layer of ZrO2.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Article Chemistry, Physical

Corrosion behavior of a non-equiatomic CoCrFeNiTi high-entropy alloy: A comparison with 304 stainless steel in simulated body fluids

Qingqing Lu et al.

Summary: Through comparison of the corrosion resistance in Hank's simulated body fluids between Co40Fe35Cr16Ni8Ti1 high-entropy alloy and 304 stainless steel, it is found that the former shows higher corrosion resistance due to the rich content of Cr and Ni elements in the passive film, while the latter performs poorly under the same conditions.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Article Chemistry, Physical

Effect of ceramic types on the microstructure and corrosion behavior of titanium matrix composites produced by selective laser melting

Jianbo Jin et al.

Summary: The corrosion resistance of two composite materials produced by SLM was studied, and it was found that the Ti-2.5TiN composite exhibited better corrosion resistance in the early corrosion stage, while the Ti-2.5TiB composite showed better corrosion resistance in the later corrosion stage.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Article Chemistry, Physical

Microwave-assisted titanium nitride coating processing using nitride powders in ambient atmosphere

Nozomi Iizuka et al.

Summary: This study investigated the microwave-assisted method of depositing hard and smooth TiN coatings on a titanium-aluminum-vanadium alloy substrate using TiN powders as raw materials. The results showed that the optimized temperature for synthesizing a hard and smooth TiN film was 900 degrees C, with a hardness of 697 HV.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Article Engineering, Electrical & Electronic

Tuning the wettability of highly transparent Nb2O5 nano-sliced coatings to enhance anti-corrosion property

Ashwani Kumar et al.

Summary: This study investigated the temperature-dependent optical, wetting, and corrosion properties of niobium oxide (Nb2O5) coatings deposited on glass and stainless steel substrates. The nano-sliced Nb2O5 film deposited at 200 degrees Celsius on stainless steel exhibited excellent optical properties, transparency, wetting behavior, and material protection compared to other samples.

MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2021)

Article Materials Science, Ceramics

Corrosion behavior of pulse laser deposited 2D nanostructured coating prepared by self-made h-BN target in salinity environment

Ankit Kumar et al.

Summary: In this study, a hexagonal boron nitride (h-BN) target was prepared using non-toxic starting materials, and a corrosion-resisting h-BN nano-sheet coating was fabricated using pulse laser deposition technique. The coated substrates showed significantly reduced corrosion rates and promising anti-corrosion properties in a saline environment.

CERAMICS INTERNATIONAL (2021)

Article Materials Science, Multidisciplinary

Comparative Investigation on Corrosion Resistance of Stainless Steels Coated with Titanium Nitride, Nitrogen Titanium Carbide and Titanium-Diamond-like Carbon Films

Jia Lou et al.

Summary: The study compared the corrosion resistance of TiN, TiCN, and Ti-DLC films on 316L stainless steel. TiCN and Ti-DLC films showed significantly improved corrosion resistance due to TiC crystals, while TiN had the lowest corrosion resistance. Among them, Ti-DLC film demonstrated the most suitable corrosion protection for 316L SS substrates, especially in electrolytes with high Cl- and H+ concentrations.

COATINGS (2021)

Article Chemistry, Physical

Selective laser melting of Ti-TiN composites: Formation mechanism and corrosion behaviour in H2SO4/HCl mixed solution

Yu Zhao et al.

Summary: Electrochemical measurements and microstructural analysis were conducted to study the corrosion behavior and formation mechanism in Ti-TiN composites produced by SLM and CP-Ti. Compared to CP-Ti, the Ti-TiN composites exhibit higher corrosion resistance.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

Article Materials Science, Multidisciplinary

Characterization of HfO2 Optical Coatings Deposited by MF Magnetron Sputtering

Artur Wiatrowski et al.

COATINGS (2019)

Article Engineering, Electrical & Electronic

Effect of annealing parameters on optoelectronic properties of highly ordered ZnO thin films

Gaurav Malik et al.

MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2019)

Article Materials Science, Multidisciplinary

Corrosion Resistance Behavior of Single-Layer Cathodic Arc PVD Nitride-Base Coatings in 1M HCl and 3.5 pct NaCl Solutions

Akeem Yusuf Adesina et al.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2017)

Article Chemistry, Physical

Some remarks on the solid surface tension determination from contact angle measurements

Anna Zdziennicka et al.

APPLIED SURFACE SCIENCE (2017)

Article Polymer Science

Structure and properties of polytetrafluoroethylene (PTFE) fibers

Ruiliu Wang et al.

E-POLYMERS (2017)

Article Energy & Fuels

Experimental investigation of effect of temperature and pressure on contact angle of four Iranian carbonate oil reservoirs

Adel Najafi-Marghmaleki et al.

JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING (2016)

Article Materials Science, Multidisciplinary

Models for nanoindentation of compliant films on stiff substrates

Yang Li et al.

JOURNAL OF MATERIALS RESEARCH (2015)

Article Materials Science, Biomaterials

Wettability modification of human tooth surface by water and UV and electron-beam radiation

Gaby E. Tiznado-Orozco et al.

MATERIALS SCIENCE & ENGINEERING C-MATERIALS FOR BIOLOGICAL APPLICATIONS (2015)

Article Physics, Multidisciplinary

Corrosion Properties of CrAlN and TiAlN Coatings Deposited by Thermoreactive Deposition Process

O. Cegil et al.

ACTA PHYSICA POLONICA A (2014)

Article Chemistry, Physical

Synthesis of TiN from FeTiO3 by microwave-assisted carbothermic reduction-nitridation

Juanjian Ru et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

Article Materials Science, Multidisciplinary

Corrosion and tribocorrosion behavior of Ti/TiN PVD coating on 316L stainless steel substrate in Ringer's solution

S. A. Naghibi et al.

MATERIALS CHEMISTRY AND PHYSICS (2014)

Article Nanoscience & Nanotechnology

Marine Corrosion Protective Coatings of Hexagonal Boron Nitride Thin Films on Stainless Steel

Esam Husain et al.

ACS APPLIED MATERIALS & INTERFACES (2013)

Article Spectroscopy

A complete and self-consistent evaluation of XPS Spectra of TiN

Dominik Jaeger et al.

JOURNAL OF ELECTRON SPECTROSCOPY AND RELATED PHENOMENA (2012)

Article Nanoscience & Nanotechnology

Syntheses and mechanical properties of quaternary Cr-Mo-Si-N coatings by a hybrid coating system

Seung Gyun Hong et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)

Article Materials Science, Multidisciplinary

Pure and Nb2O5-doped TiO2 amorphous thin films grown by dc magnetron sputtering at room temperature:: Surface and photo-induced hydrophilic conversion studies

M. Suchea et al.

MATERIALS SCIENCE AND ENGINEERING B-SOLID STATE MATERIALS FOR ADVANCED TECHNOLOGY (2007)

Review Biotechnology & Applied Microbiology

Biofilms: strategies for metal corrosion inhibition employing microorganisms

Rongjun Zuo

APPLIED MICROBIOLOGY AND BIOTECHNOLOGY (2007)

Article Materials Science, Multidisciplinary

The electrochemical corrosion behavior of TiN and (Ti,AI)N coatings in acid and salt solution

Y Li et al.

CORROSION SCIENCE (2003)

Article Materials Science, Multidisciplinary

Corrosion behavior of TiN-coated 304 stainless steel

WJ Chou et al.

CORROSION SCIENCE (2001)

Article Materials Science, Multidisciplinary

EIS comparison on corrosion performance of PVD TiN and CrN coated mild steel in 0.5 N NaCl aqueous solution

C Liu et al.

CORROSION SCIENCE (2001)

Article Engineering, Biomedical

Corrosion behavior of titanium nitride coated Ni-Ti shape memory surgical alloy

D Starosvetsky et al.

BIOMATERIALS (2001)

Article Materials Science, Ceramics

Wettability and corrosion of TiN, TiN-BN and TiN-AlN by liquid steel

A Amadeh et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2001)