☆ 4.5 Article

Characterization of flux pump-charging of high-temperature superconducting coils using coupled numerical models

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2023)

Related references

Note: Only part of the references are listed.

Article Engineering, Electrical & Electronic

Thin Shell Model of a Coated Conductor With a Ferromagnetic Substrate

Leonid Prigozhin et al.

Summary: This research presents a simple model to describe the electromagnetic response of coated conductors with magnetic substrates. The model utilizes a quasistatic thin shell approximation and an infinitely thin approximation for the superconducting layer. A dimensionless parameter is used to characterize the magnetic substrate, and a Chebyshev spectral method is derived for numerical solution. The influence of the magnetic substrate on superconducting current and ac losses is investigated.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2023)

Add to Collection

Article Engineering, Electrical & Electronic

Impact of Magnet Number on the DC Output of a Dynamo-Type HTS Flux Pump

Pengbo Zhou et al.

Summary: Based on a two-dimensional segregated H-formulation finite-element method model, this study numerically investigates the impact of the number of permanent magnets (PMs) mounted on the rotor on the performance of the high-temperature superconducting flux pump. It is found that the increase in PM number does not always lead to an increase in the dc output voltage (V-DC). Instead, there is a certain threshold value, determined by the size of the PMs and the rotor, above which the dc output voltage begins to decrease continuously. Furthermore, with further increase in PM number, the dc output voltage may disappear and then increase with the opposite polarity. This phenomenon is attributed to the change in the magnetic field profile applied to the HTS stator when increasing the number of PMs, suggesting an optimal value for PM number to achieve the best performance.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2023)

Add to Collection

Article Engineering, Electrical & Electronic

An Integrated Methodology to Assess AC Losses in the kHz Range Using the FEM and Partial Element Equivalent Circuit

Gabriel dos Santos et al.

Summary: This article introduces a new method that solves AC losses issue using T-A formulation and lumped parameters in the electrical circuit, and compares multiple formulations. The results show that the proposed technique has significant advantages in both efficiency and cost compared to the T-A 2-D formulation.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2022)

Add to Collection

Review Crystallography

High Temperature Superconducting Flux Pumps for Contactless Energization

Zezhao Wen et al.

Summary: This paper summarizes the latest advances in the field of high-temperature superconducting flux pumps, clarifies their working mechanisms, commonly adopted modeling approaches, and provides objective analyses of their applicability. It also specifies the primary challenges for implementing high-temperature superconducting flux pumps and proposes suggestions for improving this wireless excitation technology.

CRYSTALS (2022)

Add to Collection

Article Physics, Applied

Coupling electromagnetic numerical models of HTS coils to electrical circuits: multi-scale and homogeneous methodologies using the T-A formulation

Pengbo Zhou et al.

Summary: Numerical simulation is an effective tool for predicting the electromagnetic behavior of superconductors. A new model based on the finite element method can accurately evaluate the behavior of complex high-temperature superconductor systems and can be applied to large-scale HTS applications. By comparing computation results and efficiency, it is found that the new model can improve computation efficiency without compromising accuracy, which is of great value for designing and optimizing large-scale HTS devices.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2022)

Add to Collection

Article Physics, Applied

Multi-objective optimization for the superconducting bias coil of a saturated iron core fault current limiter using the T-A formulation

G. dos Santos et al.

Summary: In response to the increasing short-circuit levels in transmission and distribution systems, fault current limiters (FCL) have emerged as a potential solution. Studies on the saturated iron core superconducting fault current limiter (SIC-SFCL) topology have shown promising results, with an optimal geometry proposed for the superconducting coil using a multi-objective optimization method. The research also highlights the need for a more detailed study focusing on the optimization of the DC bias superconducting coil of the SIC-SFCL.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2021)

Add to Collection

Article Physics, Applied

A coupling method of the superconducting devices modeled by finite element method with the lumped parameters electrical circuit

G. dos Santos et al.

Summary: This study introduces a methodology for coupling superconducting devices in FEM to lumped parameters composing the power system, with a case study presented to apply the proposed methodology. The research analyzes the behavior of the superconducting coil under different conditions, such as the influence of self and external fields on its critical current density, DC-biased coil voltage drop, and superconducting resistance.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2021)

Add to Collection

Article Multidisciplinary Sciences

3D modeling of a superconducting dynamo-type flux pump

Asef Ghabeli et al.

Summary: The paper presents a 3D model of an HTS flux pump, which helps clarify the mechanism of the dynamo and uncover its unnoticed characteristics.

SCIENTIFIC REPORTS (2021)

Add to Collection

Article Engineering, Electrical & Electronic

Modelling the Frequency Dependence of the Open-Circuit Voltage of a High-Tc Superconducting Dynamo

Mark D. Ainslie et al.

Summary: This study investigates the frequency dependence of a high-Tc superconducting dynamo and proposes a new explanation for the observed phenomenon. Numerical analysis utilizing a finite-element model is used to study the impact of rotation frequency and temperature on the dynamo's open-circuit DC voltage.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2021)

Add to Collection

Article Physics, Applied

Modeling the charging process of a coil by an HTS dynamo-type flux pump

Asef Ghabeli et al.

Summary: The high-T-c superconducting dynamo generates a DC voltage using the nonlinear resistivity of an HTS tape when exposed to a varying magnetic field. Two numerical models were used to examine the process of charging a coil by the dynamo, showing excellent agreement with an analytical method. The models captured the dynamic behavior of the charging process, including current ripples that could cause AC loss in the HTS dynamo.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2021)

Add to Collection

Article Physics, Applied

Modeling of airgap influence on DC voltage generation in a dynamo-type flux pump

Asef Ghabeli et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2020)

Add to Collection

Article Physics, Applied

Maximising the current output from a self-switching kA-class rectifier flux pump

Jianzhao Geng et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2020)

Add to Collection

Article Engineering, Electrical & Electronic

A Contactless Self-Regulating HTS Flux Pump

Pengbo Zhou et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2020)

Add to Collection

Article Engineering, Electrical & Electronic

Modeling of Stator Versus Magnet Width Effects in High-Tc Superconducting Dynamos

Ratu Mataira et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2020)

Add to Collection

Article Physics, Applied

A new benchmark problem for electromagnetic modelling of superconductors: the high-Tcsuperconducting dynamo

Mark Ainslie et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2020)

Add to Collection

Article Physics, Applied

Real-time simulation of large-scale HTS systems: multi-scale and homogeneous models using the T-A formulation

Edgar Berrospe-Juarez et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2019)

Add to Collection

Article Physics, Applied

Origin of the DC output voltage from a high-Tc superconducting dynamo

R. C. Mataira et al.

APPLIED PHYSICS LETTERS (2019)

Add to Collection

Article Physics, Applied

A kilo-ampere level HTS flux pump

Jianzhao Geng et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2019)

Add to Collection

Article Physics, Applied

Superconducting flux pumps

T. A. Coombs

JOURNAL OF APPLIED PHYSICS (2019)

Add to Collection

Article Physics, Applied

Magnetizing high-Tc superconducting coated conductor stacks using a transformer-rectifier flux pumping method

Heng Zhang et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2018)

Add to Collection

Article Physics, Applied

Modeling methodology for a HTS flux pump using a 2D H-formulation

Jianzhao Geng et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2018)

Add to Collection

Article Engineering, Electrical & Electronic

An Overview of Flux Pumps for HTS Coils

T. A. Coombs et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2017)

Add to Collection

Article Physics, Applied

An efficient 3D finite element method model based on the T-A formulation for superconducting coated conductors

Huiming Zhang et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2017)

Add to Collection

Article Engineering, Electrical & Electronic

Study on the Excitation of a Bi-2223 Small Superconducting Coil by a Pulse-Type Magnetic Flux Pump

Zhiming Bai et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2017)

Add to Collection

Article Physics, Applied

finite element model for simulating second generation high temperature superconducting coils/stacks with large number of turns

Fei Liang et al.

JOURNAL OF APPLIED PHYSICS (2017)

Add to Collection

Article Computer Science, Interdisciplinary Applications

3D computation of non-linear eddy currents: Variational method and superconducting cubic bulk

Enric Pardo et al.

JOURNAL OF COMPUTATIONAL PHYSICS (2017)

Add to Collection

Article Physics, Applied

Anomalous open-circuit voltage from a high-Tc superconducting dynamo

C. W. Bumby et al.

APPLIED PHYSICS LETTERS (2016)

Add to Collection

Article Engineering, Electrical & Electronic

Through-Wall Excitation of a Magnet Coil by an External-Rotor HTS Flux Pump

Chris W. Bumby et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2016)

Add to Collection

Article Physics, Applied

An HTS flux pump operated by directly driving a superconductor into flux flow region in the E-J curve

Jianzhao Geng et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2016)

Add to Collection

Article Physics, Applied

Mechanism of a high-Tc superconducting flux pump: Using alternating magnetic field to trigger flux flow

Jianzhao Geng et al.

APPLIED PHYSICS LETTERS (2015)

Add to Collection

Article Engineering, Electrical & Electronic

Linear Flux Pump Device Applied to High Temperature Superconducting (HTS) Magnets

Lin Fu et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2015)

Add to Collection

Article Physics, Applied

Electromagnetic modelling of superconductors with a smooth current-voltage relation: variational principle and coils from a few turns to large magnets

Enric Pardo et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2015)

Add to Collection

Article Physics, Applied

Impact of flux gap upon dynamic resistance of a rotating HTS flux pump

Zhenan Jiang et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2015)

Add to Collection

Article Physics, Applied

Dynamic resistance of a high-Tc superconducting flux pump

Zhenan Jiang et al.

APPLIED PHYSICS LETTERS (2014)

Add to Collection

Article Instruments & Instrumentation

A 1 kA-class cryogen-free critical current characterization system for superconducting coated conductors

N. M. Strickland et al.

REVIEW OF SCIENTIFIC INSTRUMENTS (2014)

Add to Collection

Article Physics, Applied

Calculation of alternating current losses in stacks and coils made of second generation high temperature superconducting tapes for large scale applications

Victor M. R. Zermeno et al.

JOURNAL OF APPLIED PHYSICS (2013)

Add to Collection

Proceedings Paper Physics, Particles & Fields

Design parameters for an HTS flux pump

C. Hoffmann et al.

SUPERCONDUCTIVITY CENTENNIAL CONFERENCE 2011 (2012)

Add to Collection

Article Engineering, Electrical & Electronic

Flux Pump for HTS Magnets

Christian Hoffmann et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2011)

Add to Collection

Article Engineering, Electrical & Electronic

A Newly Developed Pulse-Type Microampere Magnetic Flux Pump

Zhiming Bai et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2010)

Add to Collection

Article Engineering, Electrical & Electronic

HTS flux pump for cryogen-free HTS magnets

MP Oomen et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2005)

Add to Collection

© Peeref 2019-2024. All rights reserved.