Journal
POLYMER TESTING
Volume 124, Issue -, Pages -Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.polymertesting.2023.108051
Keywords
Recycling; Multiple injection; PP impact Copolymer; Agglomeration and deformation; Thermo -mechanical degradation
Ask authors/readers for more resources
The influence of multiple injection on the structural and mechanical properties of impact copolymers (ICP) was studied. Thermo-mechanical degradation caused chemical changes and altered the crystallinity of the ICPs. The deformation of dispersed ethylene-propylene copolymer (EPC) particles was affected by the degradation, resulting in agglomeration and reduced dispersity. This had a negative effect on the mechanical properties, particularly the Izod impact strength.
The influence of multiple injection on the structural and mechanical properties of PP impact copolymers (ICP) has been investigated, mainly focusing on the deformation of dispersed ethylene-propylene copolymer (EPC) particles in ICPs. Various properties of recycled ICPs throughout repetitive injection processes have been compared. The thermo-mechanical degradation by heat and shear stress imposed on ICPs several times via multiple injection triggered chemical changes, such as the generation of C--C and C--O bonds and chain scission in ICPs. These changes alter the crystallinity of the ICPs by shortening the chain length and narrowing the molecular weight distribution. To determine the effect of multiple injection on the deformation of EPC particles, the intrinsic viscosities (IV) of the polypropylene (PP) matrix and dispersed EPC were measured. Degradation by multiple injection was greater for PP than for EPC, thereby increasing the viscosity ratio (IVEPC/IVPP). At a high viscosity ratio, the PP matrix could not effectively transfer shear stress to the dispersed EPC particles, causing the EPC particles to agglomerate and become larger with poor dispersity. Regarding the mechanical properties, the agglomeration of EPC exerted a significant negative effect on the Izod impact strength. Finally, numerical cal-culations in the injection mold flow region confirmed that the re-injected product required a higher shear stress than the virgin product.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available