4.6 Article

The Enhancement of CO2 and CH4 Capture on Activated Carbon with Different Degrees of Burn-Off and Surface Chemistry

Journal

MOLECULES
Volume 28, Issue 14, Pages -

Publisher

MDPI
DOI: 10.3390/molecules28145433

Keywords

activated carbon; adsorption; defective surface; GCMC; perfect surface

Ask authors/readers for more resources

In this study, activated carbon derived from longan seeds and commercial activated carbon were compared for the adsorption of methane and carbon dioxide. The activated carbon from longan seeds showed a greater adsorption capacity due to its larger surface area and micropore volume. The degree of burn-off was found to enhance the adsorption of carbon dioxide, while the presence of hydroxyl groups on the carbon surfaces had opposite effects on the adsorption of carbon dioxide and methane. The findings of this study will contribute to advancements in gas separation technologies and provide insights for addressing climate change and greenhouse gas emissions.
Activated carbon derived from longan seeds in our laboratory and commercial activated carbon are used to investigate the adsorption of methane (CH4) and carbon dioxide (CO2). The adsorption capacity for activated carbon from longan seeds is greater than commercial activated carbon due to the greater BET area and micropore volume. Increasing the degree of burn-off can enhance the adsorption of CO2 at 273 K from 4 mmol/g to 4.2 and 4.8 mmol/g at 1000 mbar without burn-off, to 19 and 26% with burn-off, respectively. This is because an increase in the degree of burn-off increases the surface chemistry or concentration of functional groups. In the investigation of the effect of the hydroxyl group on the adsorption of CO2 and CH4 at 273 K, it is found that the maximum adsorption capacity of CO2 at 5000 mbar is about 6.4 and 8 mmol/g for cases without and with hydroxyl groups contained on the carbon surfaces. The opposite behavior can be observed in the case of methane, this is due to the stronger electrostatic interaction between the hydroxyl group and carbon dioxide. The simulation results obtained from a Monte Carlo simulation method can be used to support the mechanism in this investigation. Iron oxide is added on carbon surfaces with different concentrations to reveal the effects of ferric compounds on the adsorption of CO2. Iron at a concentration of about 1% on the surface can improve the adsorption capacity. However, excessive amounts of iron led to a limited adsorption capacity. The simulation result shows similar findings to the experimental data. The findings of this study will contribute to the progress of gas separation technologies, paving the way for long-term solutions to climate change and greenhouse gas emissions.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available