4.7 Article

Wind tunnel measurements on the effects of leading edge geometry on surface pressures and wake flow of finite blunt plate

Related references

Note: Only part of the references are listed.
Article Engineering, Mechanical

Vortex-induced vibrations of a cantilevered blunt plate: POD of TR-PIV measurements and structural modal analysis

Yann Watine et al.

Summary: The present study experimentally characterized the vortex shedding and induced vibrations of a rectangular aluminium plate immersed in water flow. The hydrodynamic properties of the wake were evaluated and the structural response of the plate was examined. Three different vibration regimes were analyzed, and the features of the first nine Proper Orthogonal Decomposition (POD) modes were studied. The study identified the control factors of the primary Karman vortices and the coexistence of different vortex shedding modes in different vibration regimes.

JOURNAL OF FLUIDS AND STRUCTURES (2023)

Article Engineering, Aerospace

Experimental Investigation of Ground Effect on the Vortical Flow Structure of a 40° Swept Delta Wing

Sergen Tumse et al.

Summary: The ground effect has a significant impact on the vortical flow characteristics of nonslender delta wings, leading to premature leading-edge vortex breakdown and complex disorganized flow structures.

JOURNAL OF AEROSPACE ENGINEERING (2022)

Article Engineering, Aerospace

Effect of ground on flow characteristics and aerodynamic performance of a non-slender delta wing

Sergen Tumse et al.

Summary: The presence of the ground affects the aerodynamic performance and vortex structure of a delta wing, leading to a decrease in the peak values of vortices and a slower formation of vortices. The lift and drag coefficients of the delta wing increase as it descends towards the ground, with a higher increase observed at lower angles of attack.

AEROSPACE SCIENCE AND TECHNOLOGY (2021)

Article Engineering, Marine

Passive control on the wake of a thin flat plate by drilling a hole from the surface

Kangfu Sun et al.

Summary: The study shows that passive control by drilling holes on a flat plate can effectively influence the vortex structure and velocity statistics distribution of the wake flow. The holes reduce the turbulence intensity of the wake and lead to a more isotropic flow. Additionally, the holes effectively disrupt large-scale vortex structures, weaken intensity peaks in velocity statistics, and reduce the alternation of vortices.

OCEAN ENGINEERING (2021)

Article Thermodynamics

Wakes of thin flat plates: Intermittency, cessation of vortex shedding and the emergence of an intermediate-wake instability

Man Mohan Rai

Summary: This study investigates the wake regions of thin flat plates with different trailing edge shapes using direct numerical simulations. The effects of reducing Reynolds number on vortex shedding processes were explored, revealing differences between circular and sharp trailing edges. Wake instabilities and broadband peaks in velocity spectra were observed, contributing significantly to the overall transport equation for streamwise normal intensity.

INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW (2021)

Article Engineering, Civil

Bimodal distribution of wind pressure on windward facades of high-rise buildings induced by interference effects

Q. S. Liang et al.

JOURNAL OF WIND ENGINEERING AND INDUSTRIAL AERODYNAMICS (2020)

Article Construction & Building Technology

Wind tunnel study of separated and reattaching flows by particle image velocimetry and pressure measurements

Z. R. Shu et al.

ADVANCES IN STRUCTURAL ENGINEERING (2019)

Review Engineering, Aerospace

Modal Analysis of Fluid Flows: An Overview

Kunihiko Taira et al.

AIAA JOURNAL (2017)

Article Engineering, Mechanical

The identification of coherent structures using proper orthogonal decomposition and dynamic mode decomposition

Qingshan Zhang et al.

JOURNAL OF FLUIDS AND STRUCTURES (2014)

Article Engineering, Civil

Effects of leading edge geometry on the vortex shedding frequency of an elongated bluff body at high Reynolds numbers

Zachary J. Taylor et al.

JOURNAL OF WIND ENGINEERING AND INDUSTRIAL AERODYNAMICS (2014)

Article Thermodynamics

POD analysis of momentumless trailing edge wake using synthetic jet actuation

M. Ben Chiekh et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2013)

Article Thermodynamics

Wall-pressure fluctuations of separated and reattaching flow over blunt plate with chord-to-thickness ratio c/d=9.0

Qing Shan Zhang et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2012)

Article Engineering, Mechanical

PIV measurement of separated flow over a blunt plate with different chord-to-thickness ratios

Liu Liu Shi et al.

JOURNAL OF FLUIDS AND STRUCTURES (2010)

Article Engineering, Civil

Bluff body aerodynamics in wind engineering

Peter A. Irwin

JOURNAL OF WIND ENGINEERING AND INDUSTRIAL AERODYNAMICS (2008)

Article Thermodynamics

Experimental study of turbulent separated and reattached flow over a finite blunt plate

M Yaghoubi et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2004)

Article Engineering, Mechanical

Self-sustained oscillations in flows around long blunt plates

K Hourigan et al.

JOURNAL OF FLUIDS AND STRUCTURES (2001)