In-situ EBSD observation and simulation of free surface roughening and ductile failure in the ultra-thin ferritic stainless steel sheet

Surface roughening is one of the most fundamental issues which greatly affects the plastic deformation and ductile fracture behavior of ultra-thin sheet materials. The present study investigated the influence of free surface roughening on the micromechanical failure in the ultra-thin ferritic stainless steel (FSS) sheet for bipolar plate in proton exchange membrane (PEM) fuel cell under in-situ tensile deformation. The microstructural evolution during uniaxial tension was monitored using in-situ electron backscatter diffraction (EBSD) technique. Then the initial microstructure was directly mapped onto the finite element mesh of representative volume element (RVE) in the crystal plasticity finite element (CPFE) simulation. The CPFE model was incorporated with the microscopic ductile fracture criterion in terms of plastic energy dissipation in order to simulate the initiation of ductile fracture caused by the free surface roughening. The in-situ EBSD observations reveal that the microstructure of the ultra-thin FSS sheet exhibits heterogeneous plastic deformation and strain localization on the surface at the large deformation owing to the considerable free surface roughening. The CPFE simulations well reproduce the stress/strain heterogeneity and the local hotspots of the ductile fracture initiation. It reveals that the increase of surface roughness with the deformation results in the increased inhomogeneity of thickness which accelerates the strain localization, consequently the premature necking and failure in the ultra-thin steel sheet. Due to the free surface roughening which can facilitate strain localization, the initiation of ductile fracture is obviously observed in both the ridges and valleys in the free surface and its propagation along the pronounced localization band through the thickness, leading to material failure. The good correlation of free surface roughening to the onset of plastic instability and ductile fracture further advances the insight into the micromechanical failure during plastic deformation of the ultra-thin FSS sheet for bipolar plate in PEM fuel cell.

Automated summary

This study investigates the influence of surface roughening on the micromechanical failure of ultra-thin ferritic stainless steel (FSS) sheet. The results show that an increase in surface roughness accelerates strain localization and leads to premature failure of the material due to the increased inhomogeneity of thickness.