Related references
Note: Only part of the references are listed.The defect evolution in 1-D shocked tantalum single crystals
B. Pang et al.
JOURNAL OF MATERIALS SCIENCE (2021)
Investigating active slip planes in tantalum under compressive load: Crystal plasticity and slip trace analyses of single crystals
Hojun Lim et al.
ACTA MATERIALIA (2020)
The Effects of Orientation on the Shock Induced Microstructures of Single Crystal Tantalum
G. Whiteman et al.
SHOCK COMPRESSION OF CONDENSED MATTER - 2019 (2020)
Uniaxial compression of single crystal and polycrystalline tantalum
G. Whiteman et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
The defect evolution in shock loaded tantalum single crystals
B. Pang et al.
ACTA MATERIALIA (2018)
Orientation dependent spall strength of tantalum single crystals
Eric N. Hahn et al.
ACTA MATERIALIA (2018)
The Effects of Prior Cold Work on the Shock Response of Copper
J. C. F. Millett et al.
JOURNAL OF DYNAMIC BEHAVIOR OF MATERIALS (2018)
Deformation and failure in extreme regimes by high-energy pulsed lasers: A review
Tane P. Remington et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Simulation of shock wave propagation in single crystal and polycrystalline aluminum
J. T. Lloyd et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2014)
Evaluation of Micro-Pillar Compression Tests for Accurate Determination of Elastic-Plastic Constitutive Relations
Huiyang Fei et al.
JOURNAL OF APPLIED MECHANICS-TRANSACTIONS OF THE ASME (2012)
The Effect of Crystallographic Orientation on the Mechanical Behavior of Cu6Sn5 by Micropillar Compression Testing
Ling Jiang et al.
JOURNAL OF ELECTRONIC MATERIALS (2012)
Thermomechanical behavior of single crystalline tantalum in the static and dynamic regime
D. Rittel et al.
MECHANICS OF MATERIALS (2009)
Modeling the microstructural evolution of metallic polycrystalline materials under localization conditions
C. A. Bronkhorst et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2007)
Computational design of recovery experiments for ductile metals
NK Bourne et al.
PROCEEDINGS OF THE ROYAL SOCIETY A-MATHEMATICAL PHYSICAL AND ENGINEERING SCIENCES (2005)
A generalized self-consistent polycrystal model for the yield strength of nanocrystalline materials
B Jiang et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2004)
Equation-of-state measurements for aluminum, copper, and tantalum in the pressure range 80-440 GPa, (0.8-4.4 Mbar)
WJ Nellis et al.
JOURNAL OF APPLIED PHYSICS (2003)
Share Paper
