Investigation of wet etching technique for selective patterning of ferroelectric zirconium-doped hafnium oxide thin films for high-frequency electronic applications

This paper presents the area-selective wet etching (ASWE) method as a novel approach to have a selective patterning of a 6.8 nm-thick zirconium-doped hafnium oxide (HZO) thin film, to improve the performance of a metal ferroelectric metal (MFM)-like structure. According to the electromagnetic simulations of microwave phase shifters with patterned HZO thin films, it is underlined the importance to have selectively targeted areas covered with HZO instead of full-coverage wafers, to gain a further increase in the microwave performance of low-voltage tunable high-frequency components. The impact of the ASWE method on the morpho-structural properties was studied using various investigation tools in a non-destructive manner. X-ray reflectivity (XRR) has been employed at different immersion times, up to 120 s. Based on the extended Fast Fourier Transform (FFT) analysis, as well as from the simulation of the experimental curves in the framework of parallel-tempering algorithm, the determination of the etching rate became possible. X-ray diffraction (XRD), atomic force microscopy (AFM), and X-ray photoelectron spectroscopy (XPS) clearly indicated the complete removal of HZO after etching processes at 180 s. The method is fast, reliable, and low-cost, thus filling the actual gap in providing the necessary ferroelectric thin films exclusively in selected areas of interest.

Automated summary

This paper introduces the area-selective wet etching (ASWE) method as a new approach to selectively pattern a 6.8 nm-thick zirconium-doped hafnium oxide (HZO) thin film and improve the performance of a metal ferroelectric metal (MFM)-like structure. The importance of selectively covering areas with HZO instead of full-coverage wafers is emphasized for the microwave performance of low-voltage tunable high-frequency components. Various non-destructive investigation tools are used to study the impact of the ASWE method on morpho-structural properties.