SDS-capped 1-pyrenecarboxaldehyde nanoprobe for selective detection of Cu2+ ion from water samples: Spectroscopic approach

Sodium dodecyl sulfate (SDS)-capped 1-pyrenecarboxaldehyde nanoparticles (PyalNPs) were prepared using a reprecipitation method in an aqueous medium and exhibited red-shifted aggregation-induced enhanced emission (AIEE). The dynamic light scattering (DLS) examination showed narrower particle size distribution with an average particle size of 41 nm, whereas similar to 34.5 mV zeta potential value indicate the negative surface charge and good stability of nanoparticles (NPs) in an aqueous medium. The AIEE was seen at lambda(max) = 473 nm in a fluorescence spectrum of a PyalNP suspension. In the presence of Cu2+ ions, the fluorescence of PyalNPs quenches very significantly, even in the presence of other metal ions like Ba2+, Ca2+, Cd2+, Co2+, Al3+, Fe2+, Hg2+, Ni2+ and Mg2+. The changes in the fluorescence lifetime of PyalNPs in the presence of Cu2+ ions suggested that the type of quenching was dynamic. The fluorescence quenching data for the NPs suspension fitted well into a typical Stern-Volmer relationship in the concentration range 1.0-25 mu g/ml of Cu2+ ions. The estimated value of the correlation coefficient R-2 = 0.9877 was close to 1 and showed the linear relationship between quenching data and Cu2+ ion concentration. The limit of detection (LOD) was found to be 0.94 ng/ml and is far below the tolerable intake limit value of 1.3 mu g/ml accepted by the World Health Organization for Cu2+ ions in drinking water. The fluorescence quenching approach for a SDS-capped Pyal nanosuspension for copper ion quantification is of high specificity and coexisting ions were found to interfere very negligibly. The developed method was successfully applied for the estimation of copper ions in river water samples.

Automated summary

Sodium dodecyl sulfate (SDS) capped 1-pyrenecarboxaldehyde nanoparticles (PyalNPs) were prepared using a reprecipitation method in an aqueous medium, exhibiting good stability and fluorescence quenching ability. The fluorescence quenching approach proved to be effective for the quantification of Cu2+ ions in water samples with minimal interference from other metal ions.