☆ 4.7 Article

Quantifying the efficiency of reactions between silicate melts and rare earth aluminate-zirconate T/EBC materials

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2023)

Related references

Note: Only part of the references are listed.

Article Materials Science, Ceramics

Apatite and garnet stability in the Al-Ca-Mg-Si-(Gd/Y/Yb)-O systems and implications for T/EBC: CMAS reactions

Eeshani Godbole et al.

Summary: This study investigates the influence of rare earth ion radius on the stability and extent of the garnet solid solution phase. Results show a reduction in stability of silicate garnet with increasing rare earth ion radius. Different rare earth systems exhibit varied phases formation, but the extent of the garnet solid solution only slightly increases compared to apatite stability.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2022)

Add to Collection

Article Materials Science, Ceramics

Protocol for selecting exemplary silicate deposit compositions for evaluating thermal and environmental barrier coatings

Andrew R. Ericks et al.

Summary: This study presents a protocol for selecting representative silicate compositions for comparative testing of gas turbine coating materials. The protocol involves converting compositions of engine deposits and naturally occurring siliceous debris into the five major oxides and further refining them using principal component analysis and k-means clustering. The process results in four classes of possible deposits with common chemical characteristics. Key thermophysical properties of these deposits are calculated and related to the glass network connectivity. Finally, the reactions of deposits from each class with typical thermal and environmental barrier oxides are compared, considering the composition variations within each deposit class.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2022)

Add to Collection

Article Materials Science, Ceramics

Enhanced calcium-magnesium-aluminosilicate (CMAS) resistance of GdAlO3 (GAP) for composite thermal barrier coatings

Michael P. Schmitt et al.

Summary: This study compares the behavior of GZO and GAP materials in relation to CMAS degradation. The results show that GAP dissolves slower than GZO while producing an equivalent or higher amount of pore blocking apatite. GAP also induces intrinsic crystallization of the CMAS into a gehlenite phase. Moreover, GAP exhibits a thinner reaction zone and less sensitivity to CMAS loading compared to GZO, suggesting its potential as a CMAS barrier material and inclusion into composite TBCs.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2022)

Add to Collection

Article Geochemistry & Geophysics

Quantitative WDS compositional mapping using the electron microprobe

John J. Donovan et al.

Summary: The article discusses the quantification of X-ray intensity maps at the pixel level to improve accuracy, precision, and mapping throughput in electron-probe microanalysis (EPMA). The methods proposed for rigorous pixel quantification require calibration of X-ray intensities and result in significantly better accuracy compared to manual calibration curve methods.

AMERICAN MINERALOGIST (2021)

Add to Collection

Article Materials Science, Coatings & Films

Rheological and chemical interaction between volcanic ash and thermal barrier coatings

Dirk Muller et al.

Summary: Combustion temperatures in gas turbines soften and melt volcanic ash particles, while lower temperatures lead to deposition on turbine blades. The intensity of interaction depends on chemistry and structure. Studying spreading behavior on different TBCs, the highest damage potential is from interaction with basaltic melt.

SURFACE & COATINGS TECHNOLOGY (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Comparative study of EB-PVD gadolinium-zirconate and yttria-rich zirconia coatings performance against Fe-containing calcium-magnesium-aluminosilicate (CMAS) infiltration

Juan J. Gomez Chavez et al.

Summary: This study compares the CMAS infiltration resistance of GZO and 65YZ coatings produced by EB-PVD, finding that 65YZ has higher resistance and forms a thinner reaction layer due to a synergetic reaction mechanism. The formation of apatite in GZO requires more rare-earth content, leading to higher consumption of the GZO layer compared to 65YZ. The microstructural differences in the coatings may also affect the infiltration resistance and reaction kinetics.

CORROSION SCIENCE (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Effects of yttria content on the CMAS infiltration resistance of yttria stabilized thermal barrier coatings system

Juan J. Gomez Chavez et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)

Add to Collection

Article Materials Science, Ceramics

Garnet stability in the Al-Ca-Mg-Si-Y-O system with implications for reactions between TBCs, EBCs, and silicate deposits

Eeshani Godbole et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2020)

Add to Collection

Article Materials Science, Multidisciplinary

Dynamic interactions of ingested molten silicate particles with air plasma sprayed thermal barrier coatings

Edward J. Gildersleeve et al.

JOURNAL OF MATERIALS RESEARCH (2020)

Add to Collection

Article Materials Science, Ceramics

Molten silicate interactions with plasma sprayed thermal barrier coatings: Role of materials and microstructure

Edward Gildersleeve et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Interaction of yttrium disilicate environmental barrier coatings with calcium-magnesium-iron alumino-silicate melts

David L. Poerschke et al.

ACTA MATERIALIA (2018)

Add to Collection

Article Materials Science, Ceramics

Environmental-barrier coating ceramics for resistance against attack by molten calcia-magnesia-aluminosilicate (CMAS) glass: Part I, YAlO3 and gamma-Y2Si2O7

Laura R. Turcer et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2018)

Add to Collection

Article Chemistry, Physical

Phase equilibria in the calcia-gadolinia-silica system

David L. Poerschke et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2017)

Add to Collection

Article Materials Science, Ceramics

Resistance of 2ZrO2•Y2O3 top coat in thermal/environmental barrier coatings to calcia-magnesia-aluminosilicate attack at 1500°C

Amanda R. Krause et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2017)

Add to Collection

Article Materials Science, Multidisciplinary

Interaction and infiltration behavior of Eyjafjallajokull, Sakurajima volcanic ashes and a synthetic CMAS containing FeO with/in EB-PVD ZrO2-65 wt% Y2 O3 coating at high temperature

R. Naraparaju et al.

ACTA MATERIALIA (2017)

Add to Collection

Article Materials Science, Multidisciplinary

Response of molten silicate infiltrated Gd2Zr2O7 thermal barrier coatings to temperature gradients

R. Wesley Jackson et al.

ACTA MATERIALIA (2017)

Add to Collection

Article Materials Science, Multidisciplinary

Equilibrium relationships between thermal barrier oxides and silicate melts

David L. Poerschke et al.

ACTA MATERIALIA (2016)

Add to Collection

Article Geochemistry & Geophysics

A new EPMA method for fast trace element analysis in simple matrices

John J. Donovan et al.

AMERICAN MINERALOGIST (2016)

Add to Collection

Article Materials Science, Ceramics

Phase equilibria and crystal chemistry in the calcia-silica-yttria system

David L. Poerschke et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2016)

Add to Collection

Article Multidisciplinary Sciences

Volcanic ash melting under conditions relevant to ash turbine interactions

Wenjia Song et al.

NATURE COMMUNICATIONS (2016)

Add to Collection

Article Materials Science, Ceramics

Influence of Yb:Hf Ratio on Ytterbium Hafnate/Molten Silicate (CMAS) Reactivity

David L. Poerschke et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2016)

Add to Collection

Article Materials Science, Ceramics

Effects of cation substitution and temperature on the interaction between thermal barrier oxides and molten CMAS

David L. Poerschke et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2015)

Add to Collection

Article Materials Science, Ceramics

Stability and CMAS Resistance of Ytterbium-Silicate/Hafnate EBCs/TBC for SiC Composites

David L. Poerschke et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2015)

Add to Collection

Article Materials Science, Ceramics

2ZrO2•Y2O3 Thermal Barrier Coatings Resistant to Degradation by Molten CMAS: Part II, Interactions with Sand and Fly Ash

Amanda R. Krause et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2014)

Add to Collection

Article Materials Science, Ceramics

Effect of CMAS Deposits on MOCVD Coatings in the System Y2O3-ZrO2: Phase Relationships

Nadine K. Eils et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2013)

Add to Collection

Article Materials Science, Multidisciplinary

Environmental degradation of thermal-barrier coatings by molten deposits

Carlos G. Levi et al.

MRS BULLETIN (2012)

Add to Collection

Article Materials Science, Multidisciplinary

Thermal-barrier coatings for more efficient gas-turbine engines

David R. Clarke et al.

MRS BULLETIN (2012)

Add to Collection

Article Materials Science, Ceramics

High-Temperature Corrosion of EB-PVD Yttria Partially Stabilized Zirconia Thermal Barrier Coatings with an Artificial Volcanic Ash Overlay

Peter Mechnich et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2011)

Add to Collection

Article Materials Science, Ceramics

Infiltration-inhibiting reaction of gadolinium zirconate thermal barrier coatings with CMAS melts

Stephan Kraemer et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2008)

Add to Collection

Article Materials Science, Coatings & Films

Thermal properties of oxides with magnetoplumbite structure for advanced thermal barrier coatings

Narottam P. Bansal et al.

SURFACE & COATINGS TECHNOLOGY (2008)

Add to Collection

Review Multidisciplinary Sciences

Materials science - Thermal barrier coatings for gas-turbine engine applications

NP Padture et al.

SCIENCE (2002)

Add to Collection

© Peeref 2019-2024. All rights reserved.