4.8 Article

Alkaline membrane water electrolysis performance improvement from high ionic strength anolyte

Related references

Note: Only part of the references are listed.
Article Chemistry, Physical

Design and operating principles for high-performing anion exchange membrane water electrolyzers

Andrew W. Tricker et al.

Summary: Anion-exchange-membrane water electrolyzers (AEMWEs) have the potential to produce clean hydrogen using low-carbon renewable electricity efficiently and at a lower cost compared to existing technologies. This study overcomes the challenges faced by AEMWEs by integrating a reference electrode in the membrane-electrode assembly, which helps identify the dominant factors affecting the polarization behavior of the anode and cathode. By adjusting the electrode properties and operating strategies, such as using a more hydrophobic and optimal loaded cathode, a high porosity anode, and operating with a dry cathode, a high-performing and durable PGM-free AEMWE was achieved with negligible degradation over 500 hours.

JOURNAL OF POWER SOURCES (2023)

Article Chemistry, Multidisciplinary

Increasing the Electrolyte Salinity to Improve the Performance of Anion Exchange Membrane Water Electrolyzers

Ruggero Rossi et al.

Summary: Direct operation of anion exchange membrane water electrolyzers with near-neutral pH feeds faces challenges in performance and stability. However, the addition of low concentrations of alkali metal salts improved performance and stability. Increasing the salinity of near-neutral pH solutions represents a cost-effective strategy to improve the performance of AEMWE compared to ultrapure electrolytes.

ACS SUSTAINABLE CHEMISTRY & ENGINEERING (2023)

Article Electrochemistry

KOH vs Deionized Water Operation in Anion Exchange Membrane Electrolyzers

Noor Ul Hassan et al.

Summary: Anion exchange membrane water electrolyzers (AEMELs) have potential advantages over proton exchange membrane electrolyzers (PEMELs), but the methodology for switching between salt solution and deionized water and the impact of residual salt on cell performance are unclear. This paper studies the transition from salt to deionized water in AEMELs and suggests that a large volume of deionized water is required to achieve optimal performance during the transition.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2022)

Article Electrochemistry

Self-Adhesive Ionomers for Alkaline Electrolysis: Optimized Hydrogen Evolution Electrode

Hui Min Tee et al.

Summary: Hydrogen produced through low-temperature water electrolysis using anion exchange membranes combines the benefits of liquid-electrolyte alkaline electrolysis and solid-polymer proton exchange membrane electrolysis. The study found that using cathode ionomers with high ion exchange capacity improved cathode durability, and using ionomers soluble in the spray-coated cathode ink further improved durability and reduced voltage.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2022)

Article Electrochemistry

Ionomer Optimization for Water Uptake and Swelling in Anion Exchange Membrane Electrolyzer: Hydrogen Evolution Electrode

Garrett Huang et al.

Summary: Green hydrogen produced through anion exchange membrane water electrolysis is a promising, low-cost chemical storage solution that requires a balance between ionic conductivity, water uptake, and ionomer swelling in the ACI to improve the performance of AEM-based devices. Higher IEC ACIs with light crosslinking are preferred in the HER electrode to fine-tune water uptake and ionomer swelling for optimal cell performance and reduced operating voltages.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)

Review Green & Sustainable Science & Technology

Current status of water electrolysis for energy storage, grid balancing and sector coupling via power-to-gas and power-to-liquids: A review

Alexander Buttler et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2018)

Article Chemistry, Physical

Minimising the ohmic resistance of an alkaline electrolysis cell through effective cell design

Robert Phillips et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Electrochemistry

Review-Identifying Critical Gaps for Polymer Electrolyte Water Electrolysis Development

Ugljesa Babic et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2017)

Article Electrochemistry

Zero-Gap AlkalineWater Electrolysis Using Ion-Solvating Polymer Electrolyte Membranes at Reduced KOH Concentrations

Mikkel Rykaer Kraglund et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)

Article Chemistry, Physical

Nickel nitride as an efficient electrocatalyst for water splitting

Menny Shalom et al.

JOURNAL OF MATERIALS CHEMISTRY A (2015)

Article Chemistry, Physical

Ni/Fe electrodes prepared by electrodeposition method over different substrates for oxygen evolution reaction in alkaline medium

F. J. Perez-Alonso et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

Review Chemistry, Physical

A comprehensive review on PEM water electrolysis

Marcelo Carmo et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)

Article Chemistry, Physical

Co-modification of Ni-based type Raney electrodeposits for hydrogen evolution reaction in alkaline media

I. Herraiz-Cardona et al.

JOURNAL OF POWER SOURCES (2013)

Article Chemistry, Physical

A comparison of cathodes for zero gap alkaline water electrolysers for hydrogen production

Derek Pletcher et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2012)

Article Engineering, Electrical & Electronic

Hydrogen Production From Water Electrolysis: Current Status and Future Trends

Alfredo Ursua et al.

PROCEEDINGS OF THE IEEE (2012)

Article Chemistry, Physical

Electrochemical performances of PEM water electrolysis cells and perspectives

P. Millet et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2011)

Article Chemistry, Physical

Nickel based electrocatalysts for oxygen evolution in high current density, alkaline water electrolysers

Xiaohong Li et al.

PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2011)

Review Thermodynamics

Recent progress in alkaline water electrolysis for hydrogen production and applications

Kai Zeng et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2010)