Effect of neutron irradiation on tensile properties of advanced Cu-based alloys and composites developed for fusion applications

The effect of neutron irradiation on tensile properties and fracture mode has been investigated for several advanced CuCrZr alloys in the frame of the European fusion material development program. Five material grades utilizing different strengthening principles have been exposed to neutron irradiation up to similar to 2.5 dpa (displacement per atom) in the target operational temperature range of 150-450 degrees C. The strengthening mechanisms are based on the application of: i) tungsten particles; ii) tungsten foils (laminate structure); iii) tungsten fibers; iv) Y2O3 particles; v) vanadium addition (0.22%). Neutron irradiation was performed in the BR2 material test reactor inside the fuel channel in order to maximize the fast neutron flux. The upper irradiation temperature of 450 degrees C was selected to validate the ability of the pre-selected advanced grades to sustain the high temperature irradiation, since the baseline ITER specification CuCrZr is known not to retain sufficient tensile strength above 400 degrees C in non-irradiated conditions and shows strong irradiation induced softening above 300 degrees C. Neutron irradiation at 150 degrees C caused severe embrittlement of tungsten-copper laminates as well as a considerable reduction of the total elongation of all other grades. The irradiation at 450 degrees C led to the reduction of the yield strength and ultimate tensile strength (i.e. irradiation softening) in the vanadium-doped alloy similar to CuCrZr, while all other materials preserved or increased their strength (irradiation hardening). The fracture surfaces of the tested samples were analysed to investigate the modification of the deformation mechanisms in each particular case.

Automated summary

The effect of neutron irradiation on tensile properties and fracture mode was studied for several advanced CuCrZr alloys as part of the European fusion material development program. Five different material grades, utilizing different strengthening principles, were exposed to neutron irradiation up to 2.5 dpa at temperatures ranging from 150°C to 450°C. The results showed that irradiation at 150°C caused severe embrittlement of the tungsten-copper laminates and reduced the total elongation of all other grades. Irradiation at 450°C led to irradiation softening in the vanadium-doped alloy similar to CuCrZr, while other materials exhibited irradiation hardening.