4.6 Article

Electrical and photoresponse properties of metal-polymer-semiconductor device with TMPTA interface material

Related references

Note: Only part of the references are listed.
Article Physics, Multidisciplinary

Production of spin coated chromium oxide (CrO3) thin layers and application in the Al/p-Si metal semiconductor structures

O. Gullu et al.

Summary: A novel Al/CrO3/p-Si structure was fabricated by spin coating technique. The CrO3 thin layer was characterized using XRD, UV-vis, SEM, and AFM, showing an amorphous structure with an optical band energy of 3.96 eV. The electronic quantities of the Al/CrO3/p-Si junction were extracted using current-voltage (I-V) and capacitance-voltage data, revealing varying interfacial state concentrations under different illumination conditions. Furthermore, the photoelectric parameters of the Al/CrO3/p-Si contact were studied under 100 mW cm(-2) light illumination using I-V measurements.

PHYSICA SCRIPTA (2023)

Article Chemistry, Physical

The Influence of PVC and (PVC:SnS) Interfacial Polymer Layers on the Electric and Dielectric Properties of Au/n-Si Structure

Ali Barkhordari et al.

Summary: This study investigates the impact of PVC and SnS-doped PVC interfacial layers on the performance of Schottky barrier diodes (SBDs). The results show that these layers can improve the electrical features of the devices and a negative capacitance/dielectric phenomenon is observed at low frequencies.

SILICON (2023)

Article Engineering, Electrical & Electronic

Negative Capacitance Behavior at Low Frequencies of Nitrogen-Doped Polyethylenimine-Functionalized Graphene Quantum Dots-Based Structure

Zeynep Berktas et al.

Summary: Graphene quantum dots (GQDs) have exceptional properties, but face challenges in electronic applications. Functionalizing GQDs with nitrogen-doped polyethylenimine (PEI) enhances their performance for electronic and photovoltaic applications. In this study, capacitance/conductance-voltage measurements were carried out on PEI-functionalized GQDs to analyze their electronic properties. Negative capacitance behavior was observed in the GQDs-based structure at low frequencies. Control of interfacial charges is crucial for the development of NC devices. These findings provide insights into semiconductor device technology.

ACS APPLIED ELECTRONIC MATERIALS (2023)

Article Polymer Science

Temperature Dependent Current Transport Mechanism of Photopolymer Based Al/NOA60/p-Si MPS Device

Sadan Ozden et al.

Summary: A device based on Al/Norland Optical Adhesive 60 (NOA60)/p-Si MPS was fabricated using photopolymer. The current transport properties of the device were investigated and a good rectification ratio was observed at room temperature. The temperature-dependent study revealed an increase in barrier height and a decrease in ideality factor with increasing temperature. The Gaussian distribution model and Richardson plot were employed to calculate the barrier height.

JOURNAL OF INORGANIC AND ORGANOMETALLIC POLYMERS AND MATERIALS (2022)

Article Materials Science, Multidisciplinary

Performance of the illumination dependent electrical and photodiode characteristic of the Al/(GO:PTCDA)/p-Si structures

Sukru Karatas et al.

Summary: In this study, an Al/p-Si metal semiconductor structure with PTCDA and GO interface was fabricated and its photodiode properties were investigated. The results showed that the Al/PTCDA:GO/p-Si photodiode structures exhibited good rectifying characteristics and photoresponsitity, making them suitable for photodiode applications.

OPTICAL MATERIALS (2022)

Article Physics, Condensed Matter

Effect of interfacial native oxide on the IV characteristics of ZnO/Si (111) heterojunction

K. J. Abhishek et al.

Summary: n-ZnO/p-Si(111) heterojunctions with and without interfacial oxide layer were fabricated and their characteristics were studied. The specimen with interfacial oxide layer showed lower current response, attributed to carrier diffusion near the junction. Additionally, the ideality factor of both specimens decreased with increasing temperature.

PHYSICA B-CONDENSED MATTER (2022)

Article Engineering, Electrical & Electronic

Electrical, photoconductive, and photovoltaic characteristics of a Bi2Se3 3D insulator based metal-insulator-semiconductor diode

Richard O. Ocaya et al.

Summary: In this study, a metal-insulator-semiconductor (MIS) diode based on the Bi2Se3 3D topological insulator was fabricated and investigated. The diode exhibited high rectification ratio and fast photoresponse, making it suitable for applications as a photodiode.

SENSORS AND ACTUATORS A-PHYSICAL (2022)

Article Chemistry, Multidisciplinary

Analysis of admittance measurements of Al/Gr-PVA/p-Si (MPS) structure

D. Ata et al.

Summary: A metal-polymer-semiconductor (MPS) structure based on 5 wt% graphene doped polyvinyl alcohol thin film was fabricated, and its frequency characteristics were measured. The capacitance and conductance of the structure were found to decrease with increasing frequency, and the interface state density was estimated using various methods.

JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS (2022)

Article Chemistry, Physical

Preparation and properties of poly(MMA-co-TMPTA)/ fragrance microcapsules

Xu Ouyang et al.

Summary: Poly(MMA-co-TMPTA)/fragrance microcapsules fabricated by in-situ polymerization exhibit good thermal stability, high encapsulation efficiency, and good slow-release property, allowing the fragrance on the fabric to be retained for more than 3 months.

COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS (2021)

Article Engineering, Electrical & Electronic

Fabrication, illumination dependent electrical and photovoltaic properties of Au/BOD-Pyr/n-Si/In schottky diode

Onur Ongun et al.

Summary: A BOD-Pyr compound based on BODIPY was synthesized and its electronic and photovoltaic properties were investigated in an Au/BOD-Pyr/n-Si/In Schottky diode. Parameters such as ideality factor, barrier height, open-circuit voltage, and short-circuit current density of the diode were determined under different illumination intensities. These findings suggest potential applications of the Au/BOD-Pyr/n-Si/In diode as a photodiode in optoelectronic devices.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2021)

Article Materials Science, Multidisciplinary

Quantitative explanation of the Schottky barrier height

Raymond T. Tung et al.

Summary: This paper discusses the calculation of energy barrier height at metal-semiconductor interface, pointing out that the presence of surface dipole terms in traditional Schottky-Mott styled analyses hinders a broad understanding of the issue. The authors successfully quantitatively explain the epitaxial interfaces between metals and zinc-blende semiconductors by removing these dipole contributions using the recently developed neutral polyhedra theory based on general chemical principles.

PHYSICAL REVIEW B (2021)

Review Materials Science, Multidisciplinary

Metal oxide semiconductor-based Schottky diodes: a review of recent advances

Noorah A. Al-Ahmadi

MATERIALS RESEARCH EXPRESS (2020)

Article Engineering, Electrical & Electronic

Dielectric characterization of BSA doped-PANI interlayered metal-semiconductor structures

Nursel Karaoglan et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2019)

Article Chemistry, Multidisciplinary

Achieving current rectification ratios ≥ 105 across thin films of coordination polymer

Anupam Prasoon et al.

CHEMICAL SCIENCE (2019)

Article Materials Science, Multidisciplinary

Analysis of electronic parameters and frequency-dependent properties of Au/NiO/n-GaN heterojunctions

Varra Niteesh Reddy et al.

APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING (2018)

Article Chemistry, Physical

A Study on the Electronic Properties of SiOxNy/p-Si Interface

A. Akkaya et al.

SILICON (2018)

Article Nanoscience & Nanotechnology

Interfacial Metal-Oxide Interactions in Resistive Switching Memories

Deok-Yong Cho et al.

ACS APPLIED MATERIALS & INTERFACES (2017)

Article Engineering, Electrical & Electronic

Frequency and voltage dependence of admittance characteristics of Al/Al2O3/PVA:n-ZnSe Schottky barrier diodes

Mamta Sharma et al.

MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2016)

Article Materials Science, Multidisciplinary

Multiplexing storage using angular variation in a transmission holographic polymer dispersed liquid crystal

Eun-Hee Kim et al.

THIN SOLID FILMS (2015)

Article Materials Science, Multidisciplinary

Gel polymer electrolytes based on nanofibrous polyacrylonitrile-acrylate for lithium batteries

Dul-Sun Kim et al.

MATERIALS RESEARCH BULLETIN (2014)

Review Physics, Applied

The physics and chemistry of the Schottky barrier height

Raymond T. Tung

APPLIED PHYSICS REVIEWS (2014)

Article Chemistry, Multidisciplinary

Capacitance-voltage and conductance-voltage characteristics of Ag/n-CdO/p-Si MIS structure prepared by sol-gel method

S. Karatas et al.

JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS (2012)

Article Engineering, Electrical & Electronic

High photosensitivity and low dark current of photoconductive semiconductor switch based on ZnO single nanobelt

Bo Yuan et al.

SOLID-STATE ELECTRONICS (2011)

Article Engineering, Electrical & Electronic

SCHOTTKY DIODE-BASED MICROWAVE LIMITER WITH ADJUSTABLE THRESHOLD POWER LEVEL

S. C. Bera et al.

MICROWAVE AND OPTICAL TECHNOLOGY LETTERS (2010)

Article Materials Science, Multidisciplinary

Series resistance determination of Au/Polypyrrole/p-Si/Al structure by current-voltage measurements at low temperatures

S. Aydogan et al.

MATERIALS SCIENCE & ENGINEERING C-BIOMIMETIC AND SUPRAMOLECULAR SYSTEMS (2009)

Article Physics, Condensed Matter

Effects of chemical treatment on barrier height and ideality factors of Au/GaN Schottky diodes

M. Diale et al.

PHYSICA B-CONDENSED MATTER (2009)

Article Chemistry, Organic

Fast growing dendritic poly(ester-amines) from alternate reaction of EDA and TMPTA

DM Xu et al.

TETRAHEDRON LETTERS (2005)

Review Materials Science, Coatings & Films

Metal-organic interface and charge injection in organic electronic devices

JC Scott

JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2003)

Article Engineering, Electrical & Electronic

Effects of thin oxide in metal-semiconductor and metal-insulator-semiconductor epi-GaAs Schottky diodes

MK Hudait et al.

SOLID-STATE ELECTRONICS (2000)