☆ 4.7 Article

Effect of replacing M (M=Cu, Zn) with Fe on the properties of high entropy (MgCoNiZnCu)O

JOURNAL OF ALLOYS AND COMPOUNDS (2023)

Related references

Note: Only part of the references are listed.

Article Materials Science, Multidisciplinary

Anhydrous MgCO3: Controllable synthesis of various morphology based on hydrothermal carbonization

Yunhua Lu et al.

Summary: A novel, simple and efficient method for synthesizing anhydrous MgCO3 (AMC) using ascorbic acid (ASA) as a CO2 source and crystal modifier has been developed based on hydrothermal carbonization. Furan derivatives, aldehydes and ketones from ascorbic acid unexpectedly act as structure-directing agents. The effects of ASA pH values, reaction time and concentrations and types of Mg2+ were systematically investigated, resulting in the successful preparation of pure AMC with different morphologies.

MATERIALS RESEARCH EXPRESS (2023)

Add to Collection

Article Nanoscience & Nanotechnology

Surface Phase Conversion in a High-Entropy Layered Oxide Cathode Material

Qinfeng Zheng et al.

Summary: High-entropy layered oxides, which have two-dimensional ion transport channels, are potentially interesting cathode materials for lithium-ion batteries. However, the reported high-entropy layered oxides exhibit fast capacity fading in initial cycles and are thus not practically valuable.

ACS APPLIED MATERIALS & INTERFACES (2023)

Add to Collection

Article Materials Science, Ceramics

Design and fabrication of high-entropy oxide anchored on graphene for boosting kinetic performance and energy storage

Hongchen Guo et al.

Summary: The research successfully prepared HEO@G composite material, providing high capacity and cycling stability for lithium-ion batteries, and deeply analyzed the influence of graphene on the electrochemical properties of the composite electrode.

CERAMICS INTERNATIONAL (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Co3O4-based fluffy tubes structure used as anode material for lithium-ion battery

X. T. Zhang et al.

Summary: A distinctive structure combining multi-walled nanotubes (MWCNTs) with Co3O4 was synthesized, showing potential application in lithium ion batteries. Secondary carbon nanotubes formed on the surface increased conductivity and the material exhibited high cyclical stability after carbonization and oxidation treatment.

MATERIALS LETTERS (2022)

Add to Collection

Article Engineering, Chemical

A Spinel (FeNiCrMnMgAl)3O4 High Entropy Oxide as a Cycling Stable Anode Material for Li-Ion Batteries

Yu Zheng et al.

Summary: In this study, a six-component high entropy oxide anode material was prepared and exhibited excellent electrochemical performance. Through in-situ and ex-situ characterization techniques, important findings about the lithium storage behavior and phase change mechanism were obtained, providing new insights for better understanding of anode materials.

PROCESSES (2022)

Add to Collection

Article Chemistry, Physical

Crystal growth, structure and thermal properties of anhydrous zinc carbonate (ZnCO3)

Wen Liang et al.

Summary: Carbonate materials are being increasingly used in the development of flame retardants due to their ability to sequester inorganic carbon. Anhydrous zinc carbonate (ZnCO3) has been identified as a suitable candidate for flame retardancy. This study synthesized ZnCO3 single crystals under high-pressure-temperature conditions and characterized their structural and thermal properties. The results showed that the synthesized ZnCO3 is an anhydrous phase with good flame retardancy.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Acoustic Emission Monitoring of High-Entropy Oxyfluoride Rock-Salt Cathodes during Battery Operation

Simon Schweidler et al.

Summary: In this study, the degradation behavior of a high-entropy oxyfluoride cathode material in lithium cells was investigated in situ using acoustic emission monitoring. The results showed that the initial cycle was the most acoustically active stage, and the formation and propagation of cracks in the electrode were found to be the primary cause of acoustic activity.

COATINGS (2022)

Add to Collection

Article Nanoscience & Nanotechnology

Insights for the New Function of N,N-Dimethylpyrrolidone in Preparation of a High-Voltage Spinel LiNi0.5Mn1.5O4 Cathode

Chao Gao et al.

Summary: In this study, spinel LNMO with good dispersion was synthesized using the solid-state method with the addition of NMP, which effectively refined and optimized the particle size while suppressing aggregation. LNMO prepared with NMP exhibited higher discharge voltage and capacity compared to traditional LNMO, showcasing the potential benefits of using NMP in electrode material synthesis for lithium ion batteries.

ACS APPLIED MATERIALS & INTERFACES (2021)

Add to Collection

Article Physics, Applied

Long-range magnetic ordering in rocksalt-type high-entropy oxides

Marco Polo Jimenez-Segura et al.

APPLIED PHYSICS LETTERS (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Evidence for Jahn-Teller compression in the (Mg, Co, Ni, Cu, Zn)O entropy-stabilized oxide: A DFT study

Zs. Rak et al.

MATERIALS LETTERS (2018)

Add to Collection

Article Materials Science, Multidisciplinary

Metal ion-mediated structure and properties of alpha-Fe2O3 nanoparticles

Dong Yan et al.

MATERIALS RESEARCH BULLETIN (2018)

Add to Collection

Article Nanoscience & Nanotechnology

A new class of high-entropy perovskite oxides

Sicong Jiang et al.

SCRIPTA MATERIALIA (2018)

Add to Collection

Article Multidisciplinary Sciences

High entropy oxides for reversible energy storage

Abhishek Sarkar et al.

NATURE COMMUNICATIONS (2018)

Add to Collection

Article Multidisciplinary Sciences

High-entropy high-hardness metal carbides discovered by entropy descriptors

Pranab Sarker et al.

NATURE COMMUNICATIONS (2018)

Add to Collection

Article Materials Science, Multidisciplinary

Colossal dielectric constant in high entropy oxides

David Berardan et al.

PHYSICA STATUS SOLIDI-RAPID RESEARCH LETTERS (2016)

Add to Collection

Article Multidisciplinary Sciences

Exceptional damage-tolerance of a medium-entropy alloy CrCoNi at cryogenic temperatures

Bernd Gludovatz et al.

NATURE COMMUNICATIONS (2016)

Add to Collection

Article Chemistry, Multidisciplinary

Design and synthesis of micron-sized spherical aggregates composed of hollow Fe2O3 nanospheres for use in lithium-ion batteries

Jung Sang Cho et al.

NANOSCALE (2015)

Add to Collection

Article Multidisciplinary Sciences

Entropy-stabilized oxides

Christina M. Rost et al.

NATURE COMMUNICATIONS (2015)

Add to Collection

Article Chemistry, Multidisciplinary

Preparation of nanostructure CuO/ZnO mixed oxide by sol-gel thermal decomposition of a CuCO3 and ZnCO3: TG, DTG, XRD, FESEM and DRS investigations

Mohammad Hossein Habibi et al.

JOURNAL OF INDUSTRIAL AND ENGINEERING CHEMISTRY (2014)

Add to Collection

Article Materials Science, Coatings & Films

Structure and properties of two Al-Cr-Nb-Si-Ti high-entropy nitride coatings

Ming-Hsiao Hsieh et al.

SURFACE & COATINGS TECHNOLOGY (2013)

Add to Collection

Review Chemistry, Multidisciplinary

Functional Materials for Rechargeable Batteries

Fangyi Cheng et al.

ADVANCED MATERIALS (2011)

Add to Collection

Article Chemistry, Physical

Effects of Crystalline Phase and Particle Size on the Properties of Plate-Like Fe2O3 Nanoparticles during γ- to α-Phase Transformation

Shilin Liu et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2011)

Add to Collection

Article Chemistry, Physical

Analysis of XPS spectra of Fe2+ and Fe3+ ions in oxide materials

Toru Yamashita et al.

APPLIED SURFACE SCIENCE (2008)

Add to Collection

Review Chemistry, Physical

Template-directed materials for rechargeable lithium-ion batteries

Fangyi Cheng et al.

CHEMISTRY OF MATERIALS (2008)

Add to Collection

© Peeref 2019-2024. All rights reserved.