☆ 4.7 Article

Microstructure and mechanical properties of a novel polycrystalline Ni3Al-based intermetallic alloy

INTERMETALLICS (2023)

Related references

Note: Only part of the references are listed.

Article Engineering, Industrial

Microstructure and mechanical properties of twin wire and arc additive manufactured Ni3Al-based alloy

Meng Zhang et al.

Summary: Ni3Al-based alloy was successfully prepared by adjusting the feeding speed of Ni and Al wires in T-WAAM, leading to changes in microstructure and mechanical properties with increasing build height. The alloy at the bottom showed optimal mechanical properties, with tensile strength of 817.3 MPa and elongation of 20.9%. The study also found that the mechanical properties of the deposited alloy were equivalent to commercially available Ni3Al-based alloys IC218 and IC221M.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2022)

Add to Collection

Article Nanoscience & Nanotechnology

Solidification microstructure and tensile deformation mechanisms of selective electron beam melted Ni3Al-based alloy at room and elevated temperatures

Y. Yao et al.

Summary: Selective electron beam melting (SEBM) was used to process crack-free Ni3Al-based IC21 alloy with similar to 85% gamma'-volume fraction. The segregation of Si to low melting point liquid films enhances the susceptibility to solidification cracking in IC21 produced by SEBM. Tensile specimens extracted from the crack-free IC21 samples exhibit superior properties at room temperature and 1000 degrees C, with different deformation mechanisms observed at these temperatures.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Impact of crystallography at Ni/NiAl interfaces on the nucleation of Ni3Al

M. Seyring et al.

Summary: The early stages of phase formation at (Ni)/NiAl interfaces with different crystallographic configurations were studied, revealing the formation of Ni3Al phase in two layers with specific crystallographic relationships with adjoining phases. The growth kinetics of Ni3Al showed variations with majority maintaining Kurdjumov-Sachs orientation relationships, while the second layer exhibited cube-on-cube orientation relationships towards the (Ni) phase. The observed formation of large Al-enriched (Ni) grains at the (Ni)/Ni3Al interface was interpreted as diffusion-induced recrystallization.

ACTA MATERIALIA (2021)

Add to Collection

Review Chemistry, Physical

Microstructural evolution and creep mechanisms in Ni-based single crystal superalloys: A review

Wanshun Xia et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Add to Collection

Review Materials Science, Multidisciplinary

A review of composition evolution in Ni-based single crystal superalloys

Wanshun Xia et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)

Add to Collection

Article Chemistry, Physical

Effect of aging temperature on the secondary γ′ precipitation in a model Ni based single crystal superalloy

Chuang He et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Add to Collection

Article Chemistry, Physical

Influences of solution cooling rate on microstructural evolution of a multiphase Ni3Al-based intermetallic alloy

Jing Wu et al.

INTERMETALLICS (2019)

Add to Collection

Article Nanoscience & Nanotechnology

Formation and widening mechanisms of envelope structure and its effect on creep behavior of a multiphase Ni3Al-based intermetallic alloy

Jing Wu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

Add to Collection

Article Nanoscience & Nanotechnology

Precipitation of intersected plate-like γ′ phase in β and its effect on creep behavior of multiphase Ni3Al-based intermetallic alloy

Jing Wu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

Add to Collection

Article Nanoscience & Nanotechnology

Effect of annealing treatment on microstructure evolution and creep behavior of a multiphase Ni3Al-based superalloy

Jing Wu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Compositional variations for small-scale gamma prime (γ′) precipitates formed at different cooling rates in an advanced Ni-based superalloy

Y. Q. Chen et al.

ACTA MATERIALIA (2015)

Add to Collection

Article Chemistry, Physical

Effect of B and Cr on elastic strength and crystal structure of Ni3Al alloys under high pressure

S. V. Raju et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2015)

Add to Collection

Review Chemistry, Physical

Applications of Ni3Al Based Intermetallic Alloys-Current Stage and Potential Perceptivities

Pawel Jozwik et al.

MATERIALS (2015)

Add to Collection

Article Materials Science, Multidisciplinary

Optimal precipitate shapes in nickel-base γ-γ′ alloys

J. S. Van Sluytman et al.

ACTA MATERIALIA (2012)

Add to Collection

Article Materials Science, Multidisciplinary

Evolution of microstructure and twin density during thermomechanical processing in a γ-γ′ nickel-based superalloy

N. Bozzolo et al.

ACTA MATERIALIA (2012)

Add to Collection

Article Chemistry, Physical

Influence of solution heat treatment on microstructure and stress rupture properties of a Ni3Al base single crystal superalloy IC6SX

Ping Li et al.

INTERMETALLICS (2011)

Add to Collection

Article Nanoscience & Nanotechnology

The effect of Re and Ru on γ/γ′ microstructure, γ-solid solution strengthening and creep strength in nickel-base superalloys

A. Heckl et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)

Add to Collection

Article Nanoscience & Nanotechnology

Improvement of stress-rupture property by Cr addition in Ni-based single crystal superalloys

J. Y. Chen et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)

Add to Collection

Article Engineering, Multidisciplinary

Effect of dendrite arm spacing and the γ' phase size on stress rupture properties of Ni3Al-base single crystal superalloy IC6SX

Jiang LiWu et al.

SCIENCE CHINA-TECHNOLOGICAL SCIENCES (2010)

Add to Collection

Article Chemistry, Physical

Microstructure evolution and mechanical properties' improvement of NiAl-Cr(Mo)-Hf eutectic alloy during suction casting and subsequent HIP treatment

L. Y. Sheng et al.

INTERMETALLICS (2009)

Add to Collection

Article Materials Science, Multidisciplinary

Creep behaviour of Ni-base single-crystal superalloys with various γ′ volume fraction

T Murakumo et al.

ACTA MATERIALIA (2004)

Add to Collection

Article Nanoscience & Nanotechnology

Solution heat treatment response of a third generation single crystal Ni-base superalloy

GE Fuchs

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)

Add to Collection

Article Chemistry, Physical

Advances in processing of Ni3Al-based intermetallics and applications

VK Sikka et al.

INTERMETALLICS (2000)

Add to Collection

© Peeref 2019-2024. All rights reserved.