☆ 4.8 Article

A Robust Wireless Power Transfer System With Self-Alignment Capability and Controllable Output Current for Automatic-Guided Vehicles

IEEE TRANSACTIONS ON POWER ELECTRONICS (2023)

Related references

Note: Only part of the references are listed.

Article Automation & Control Systems

Analysis, Design, and Validation of a Decoupled Double-Receiver Wireless Power Transfer System With Constant Voltage Outputs for Industrial Power Supplies

Heshou Wang et al.

Summary: This article investigates a magnetic coupler for a double-receiver WPT system that suppresses unwanted cross-couplings. Undesirable couplings between receivers and between the source coil and receivers are eliminated using orthometric DD coils and Q-shaped coils. The coupler design process is efficient and easily generalizable, and experimental results show high efficiency and constant output voltages.

IEEE TRANSACTIONS ON INDUSTRIAL INFORMATICS (2023)

Add to Collection

Article Automation & Control Systems

A Novel Efficient Hybrid Compensation Topology for Wireless Power Transfer

Saman Rezazade et al.

Summary: Wireless power transfer systems require compensators to improve transfer efficiency. This article compares and analyzes typical compensators, and proposes a hybrid compensation topology that can switch between different topologies. An experimental prototype is used to verify the effectiveness of the proposed hybrid compensator.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2023)

Add to Collection

Article Engineering, Electrical & Electronic

Mutual Inductance Identification of IPT System Based on Soft-Start Process

Lei Wang et al.

Summary: In this article, a general load decoupling method for wireless power transfer (WPT) system is proposed. The method considers soft-start process and battery initial voltage. A double-sided LCC topology is used to calculate the boundary conditions of load decoupling. The proposed method is experimentally verified and achieves high identification accuracy.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2022)

Add to Collection

Article Engineering, Electrical & Electronic

A Dual-Receiver Inductive Charging System for Automated Guided Vehicles

Heshou Wang et al.

Summary: This article investigates a dual-receiver inductive charging system for automated guided vehicles (AGVs). It achieves relatively load-independent constant current (CC) and constant voltage (CV) outputs through a well-organized magnetic coupling structure. The system provides small voltage and current deviation while avoiding complex control methods and additional decoupling circuits.

IEEE TRANSACTIONS ON MAGNETICS (2022)

Add to Collection

Article Engineering, Multidisciplinary

Self-Aligning Capability of IPT Pads for High-Power Wireless EV Charging Stations

Alireza Namadmalan et al.

Summary: This article studies the magnetic forces between the transmitter and receiver coils in an inductive power transfer system. The research aims to utilize these forces to align the coils and improve the efficiency of power transfer. The analysis shows that high-power IPT systems can generate enough attractive force to align the coils, even at nominal current. This self-aligning capability can be utilized to design smart charging stations for various applications.

IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS (2022)

Add to Collection

Proceedings Paper Engineering, Electrical & Electronic

A Mode-switching-based Method to Improve Misalignment Tolerance of WPT Systems

Jinwu Sun et al.

Summary: In this study, a mode-switching-based method is proposed to improve the misalignment tolerance of wireless power transfer (WPT) system. The influence of misalignment on the coupling coefficient is analyzed through simulation, and the effectiveness of the proposed method is verified using a prototype.

2022 25TH INTERNATIONAL CONFERENCE ON ELECTRICAL MACHINES AND SYSTEMS (ICEMS 2022) (2022)

Add to Collection

Article Engineering, Electrical & Electronic

Triple-Coil-Structure-Based Coil Positioning System for Wireless EV Charger

Bin Zhang et al.

Summary: A triple-coil-based coil positioning approach is proposed in this article to achieve accurate coil positioning with low electromagnetic field, using the optimization of quality factor and an RSS fingerprint positioning algorithm. Experimental results show that over 95% of tested cases in a 32 cm x 32 cm area have positioning errors less than 1.5 cm.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2021)

Add to Collection

Article Engineering, Electrical & Electronic

Analysis and Design of Cost-Effective WPT Systems With Dual Independently Regulatable Outputs for Automatic Guided Vehicles

Chenyan Zhu et al.

Summary: Recently, wireless power transfer charging systems have attracted extensive attention for their promising potential in automatic guided vehicles (AGVs) as an alternative to traditional plugging charging systems. Experimental results demonstrate the excellent stability and adjustability of the system in response to load variations, with an overall efficiency ranging from 86.22% to 90.93%.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2021)

Add to Collection

Article Engineering, Electrical & Electronic

Air-Gap-Insensitive IPT Pad With Ferromagnetic and Conductive Plates

Jin S. Choi et al.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2020)

Add to Collection

Article Engineering, Electrical & Electronic

A New Coupling Structure and Position Detection Method for Segmented Control Dynamic Wireless Power Transfer Systems

Xiaofei Li et al.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2020)

Add to Collection

Proceedings Paper Energy & Fuels

Sensorless Vehicle Position Detection in Electric Vehicle by Logistic Estimation Function of Mutual Inductance

Jirawat Sithinamsuwan et al.

2020 IEEE PELS WORKSHOP ON EMERGING TECHNOLOGIES: WIRELESS POWER TRANSFER (WOW) (2020)

Add to Collection

Article Engineering, Electrical & Electronic

A Low-Voltage and High-Current Inductive Power Transfer System With Low Harmonics for Automatic Guided Vehicles

Fei Lu et al.

IEEE TRANSACTIONS ON VEHICULAR TECHNOLOGY (2019)

Add to Collection

Article Automation & Control Systems

A Tightly Coupled Inductive Power Transfer System for Low-Voltage and High-Current Charging of Automatic Guided Vehicles

Fei Lu et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2019)

Add to Collection

Article Automation & Control Systems

Contactless Power Transfer System for AGVs

Hirokazu Matsumoto et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2018)

Add to Collection

Article Engineering, Electrical & Electronic

Maximum Efficiency Tracking for Wireless Power Transfer Systems With Dynamic Coupling Coefficient Estimation

Xin Dai et al.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2018)

Add to Collection

Article Engineering, Electrical & Electronic

Inductive Power Transfer for Massive Electric Bicycles Charging Based on Hybrid Topology Switching With a Single Inverter

Ruikun Mai et al.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2017)

Add to Collection

Article Engineering, Electrical & Electronic

3-D Coil Positioning Based on Magnetic Sensing for Wireless EV Charging

Yabiao Gao et al.

IEEE TRANSACTIONS ON TRANSPORTATION ELECTRIFICATION (2017)

Add to Collection

Article Engineering, Electrical & Electronic

Hybrid IPT Topologies With Constant Current or Constant Voltage Output for Battery Charging Applications

Xiaohui Qu et al.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2015)

Add to Collection

Article Automation & Control Systems

Development of a Single-Sided Flux Magnetic Coupler for Electric Vehicle IPT Charging Systems

Mickel Budhia et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2013)

Add to Collection

© Peeref 2019-2024. All rights reserved.