4.7 Article

Thermal cycle performance of thermocline storage: numerical and experimental exergy analysis

Related references

Note: Only part of the references are listed.
Article Thermodynamics

Thermo-economic evaluation of PCM layer thickness change on the performance of the hybrid heat storage tank for concentrating solar power plants

Karem Elsayed Elfeky et al.

Summary: This research examines the impact of increasing the thickness of the phase change material layer on the thermal and economic behavior of a hybrid sensible-latent heat storage system used in solar power plants. The study compares different configurations in terms of cost and efficiency and finds that the 15% PCM - 70% SHS - 15% PCM configuration is the most viable choice due to its optimized efficiency, reduced thermocline area, and comparatively low cost.

ENERGY (2022)

Article Energy & Fuels

Experimental investigation of the impact of fluid distribution on thermocline storage performance

Q. Falcoz et al.

Summary: The influence of fluid distribution on packed bed thermocline storage is minimal. The packed bed quickly homogenizes radial temperature, and different distributors have little effect on the longitudinal temperature profiles.

JOURNAL OF ENERGY STORAGE (2022)

Article Thermodynamics

Influence of geometrical dimensions and particle diameter on exergy performance of packed-bed thermal energy storage

Krzysztof Rusin et al.

Summary: The expansion of renewable energy infrastructure necessitates the development of energy storage technology. A system using post-mining mine shafts for adiabatic compressed air energy storage has been proposed. A numerical analysis validated by experimental data was conducted to analyze the performance of heat storage tanks. The study found that the slenderness of the storage tank affects its efficiency.

ENERGY (2022)

Article Thermodynamics

Thermocline thermal energy storage optimisation combining exergy and life cycle assessment

D. Le Roux et al.

Summary: Thermocline thermal energy storage is a promising solution for recovering waste heat in industrial plants. This paper aims to optimize the shape of a thermal energy storage to minimize environmental impacts and maximize exergy efficiency. Applying a particle swarm optimization algorithm and adjusting exergy and environmental weighting factors can lead to changes in the tank shape.

ENERGY CONVERSION AND MANAGEMENT (2021)

Article Green & Sustainable Science & Technology

Experimental and numerical investigation of the impact of operating conditions on thermocline storage performance

S. Vannerem et al.

Summary: Thermocline storage performance was studied using a numerical model and validated with experimental results, showing the impact of interstitial fluid velocity on storage performance. Numerical simulations revealed an optimal velocity, while experiments demonstrated a decrease in storage performance at lower and higher velocities.

RENEWABLE ENERGY (2021)

Article Thermodynamics

Assessing the use of copper slags as thermal energy storage material for packed-bed systems

Ignacio Calderon-Vasquez et al.

Summary: The study evaluates the potential of using copper slags as filler material in thermocline tanks, demonstrating their high thermal capacity and ability to create steeper thermoclines. This allows for higher energy density stored and lower exergy loss rates compared to other byproducts under similar storage dimensions.

ENERGY (2021)

Article Thermodynamics

Cycle cut-off criterion effect on the performance of cascaded, sensible, combined sensible-latent heat storage tank for concentrating solar power plants

Karem Elsayed Elfeky et al.

Summary: Thermocline thermal energy storage technology benefits from its composite design and use of inexpensive filler materials, but suffers from low capacity and utilization ratio when integrated with concentrating solar power plants. By changing the charge/discharge cut-off values, the thermal performance of different TES tank configurations can be significantly improved, with the sensible-latent heat storage configuration showing the highest capacity ratio, utilization ratio, recovered energy, and overall efficiency.

ENERGY (2021)

Article Thermodynamics

Numerical simulation of a 50 MWe parabolic trough power plant integrating a thermocline storage tank

T. Fasquelle et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

Proceedings Paper Thermodynamics

Comparison between experimental and numerical results of a packed-bed thermal energy storage system in continuous operation

Mario Cascetta et al.

ATI 2018 - 73RD CONFERENCE OF THE ITALIAN THERMAL MACHINES ENGINEERING ASSOCIATION (2018)

Proceedings Paper Green & Sustainable Science & Technology

Modelling and Operation Strategies of DLR's Large Scale Thermocline Test Facility (TESIS)

Christian Odenthal et al.

INTERNATIONAL CONFERENCE ON CONCENTRATING SOLAR POWER AND CHEMICAL ENERGY SYSTEMS (SOLARPACES 2016) (2017)

Article Green & Sustainable Science & Technology

Experimental investigation of cycling behaviour of pilot-scale thermal oil packed-bed thermal storage system

A. Bruch et al.

RENEWABLE ENERGY (2017)

Review Energy & Fuels

Heat transfer fluids for concentrating solar power systems - A review

K. Vignarooban et al.

APPLIED ENERGY (2015)

Proceedings Paper Thermodynamics

Experimental investigation of a packed bed thermal energy storage system

Mario Cascetta et al.

33RD UIT (ITALIAN UNION OF THERMO-FLUID DYNAMICS) HEAT TRANSFER CONFERENCE (2015)

Proceedings Paper Energy & Fuels

Numerical simulation of single-and dual-media thermocline tanks for energy storage in concentrating solar power plants

C. Mira-Hernandez et al.

PROCEEDINGS OF THE SOLARPACES 2013 INTERNATIONAL CONFERENCE (2014)

Proceedings Paper Energy & Fuels

Study of thermocline tank performance in dynamic processes and stand-by periods with an analytical function

Rocio Bayon et al.

PROCEEDINGS OF THE SOLARPACES 2013 INTERNATIONAL CONFERENCE (2014)

Article Energy & Fuels

Second-law analysis of molten-salt thermal energy storage in thermoclines

Scott M. Flueckiger et al.

SOLAR ENERGY (2012)

Article Thermodynamics

Implications of the modelling of stratified hot water storage tanks in the simulation of CHP plants

A. Campos Celador et al.

ENERGY CONVERSION AND MANAGEMENT (2011)