Related references
Note: Only part of the references are listed.Electrochemical measurements used for assessment of corrosion and protection of metallic materials in the field: A critical review
Da-Hai Xia et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2022)
Improved design of available atmospheric corrosion monitoring sensor with a higher sensitivity to low NaCl deposition
Qiong Wu et al.
MATERIALS LETTERS (2022)
In-situ EIS study on the initial corrosion evolution behavior of SAC305 solder alloy covered with NaCl solution
Chuang Qiao et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2021)
Insight to corrosion mechanism of 90/10 copper-nickel alloys under different sea depths
Bing-Zhi Li et al.
MATERIALS LETTERS (2021)
Comparative investigation on copper atmospheric corrosion by electrochemical impedance and electrical resistance sensors
Shan Wan et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2021)
Temperature and NaCl deposition dependent corrosion of SAC305 solder alloy in simulated marine atmosphere
Chuang Qiao et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)
High-temperature aging time-induced composition and thickness evolution in the native oxides film on Sn solder substrate
Chuang Qiao et al.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2021)
Modeling Atmospheric Corrosion under Dynamic Thin Film Electrolyte
L. Saberi et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)
On experimental determination of cell constants for interdigitated electrodes
Arthur Dizon et al.
ELECTROCHIMICA ACTA (2020)
Microstructure induced galvanic corrosion evolution of SAC305 solder alloys in simulated marine atmosphere
Mingna Wang et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)
Design, construction, and validation for in-situ water layer thickness determination during accelerated corrosion testing
R. M. Katona et al.
CORROSION SCIENCE (2020)
Physical properties obtained from measurement model analysis of impedance measurements
Hangqi Liao et al.
ELECTROCHIMICA ACTA (2020)
Measurement of Liquid Film Thickness Using Distributed Conductance Sensor in Multiphase Slug Flow
Dayang Wang et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2020)
Monitoring of atmospheric corrosion and dewing process by interlacing copper electrode sensor
Shan Wan et al.
CORROSION SCIENCE (2019)
Galvanic Corrosion Between Coated Al Alloy Plate and Stainless Steel Fasteners, Part 1: FEM Model Development and Validation
R. S. Marshall et al.
CORROSION (2019)
Insight into the corrosion evolution of Fe-based amorphous coatings under wet-dry cyclic conditions
J. Wu et al.
ELECTROCHIMICA ACTA (2019)
Review-Electrochemical Probes and Sensors Designed for Time-Dependent Atmospheric Corrosion Monitoring: Fundamentals, Progress, and Challenges
Da-Hai Xia et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2019)
High Sensitive Capacitive Sensing Method for Thickness Detection of the Water Film on an Insulation Surface
Nan Li et al.
IEEE ACCESS (2019)
Detection of Atmospheric Corrosion of Aluminum Alloys by Electrochemical Probes: Theoretical Analysis and Experimental Tests
Da-Hai Xia et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2019)
Salt concentration dependence of ionic conductivity in ion exchange membranes
Jovan Kamcev et al.
JOURNAL OF MEMBRANE SCIENCE (2018)
Corrosion Behavior of Zinc under Thin Solution Films of Different Thicknesses
Chulaluk Somphotch et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2018)
Water film thickness imaging based on time-multiplexed near-infrared absorption
Marc Lubnow et al.
OPTICS EXPRESS (2018)
Characterization of corrosion products formed on mild steel in deoxygenated water by Raman spectroscopy and energy dispersive X-ray spectrometry
Mirjam Bajt Leban et al.
ENGINEERING FAILURE ANALYSIS (2017)
Design of instantaneous liquid film thickness measurement system for conductive or non-conductive fluid with high viscosity
Yongxin Yu et al.
AIP ADVANCES (2017)
Ni Corrosion Product Layer During Immersion in a 3.5% NaCl Solution: Electrochemical and XPS Characterization
B. I. Onyeachu et al.
PORTUGALIAE ELECTROCHIMICA ACTA (2017)
Simulating study of atmospheric corrosion of steels in a coastal industrial zone: Effect of SO32- on the formation of β-FeOOH rust particles synthesized from FeCl3 solutions
Hidekazu Tanaka et al.
CORROSION SCIENCE (2016)
Method for determining ion exchange membrane resistance for electrodialysis systems
A. H. Galama et al.
DESALINATION (2016)
An integrated modeling approach for atmospheric corrosion in presence of a varying electrolyte film
N. Van den Steen et al.
ELECTROCHIMICA ACTA (2016)
Novel method for the measurement of liquid film thickness during fuel spray impingement on surfaces
S. Henkel et al.
OPTICS EXPRESS (2016)
Humidity sensing using vertically oriented arrays of ReS2 nanosheets deposited on an interdigitated gold electrode
Aijun Yang et al.
2D MATERIALS (2016)
A Method for Determining the Corrosion Rate of a Metal under a Thin Electrolyte Film
Yanzhuo Shi et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2015)
Long-term monitoring of atmospheric corrosion at weathering steel bridges by an electrochemical impedance method
Atsushi Nishikata et al.
CORROSION SCIENCE (2014)
Formation of magnetite rust particles by reacting iron powder with artificial α-, β- and γ-FeOOH in aqueous media
Hidekazu Tanaka et al.
CORROSION SCIENCE (2014)
Kinetics of Dissolution and Recrystallization of Sodium Chloride at Controlled Relative Humidity
Marina Langlet et al.
KONA Powder and Particle Journal (2014)
Crystallization and electrical resistivity of Cu2O and CuO obtained by thermal oxidation of Cu thin films on SiO2/Si substrates
L. De Los Santos Valladares et al.
THIN SOLID FILMS (2012)
Resolving surface chemical states in XPS analysis of first row transition metals, oxides and hydroxides: Cr, Mn, Fe, Co and Ni
Mark C. Biesinger et al.
APPLIED SURFACE SCIENCE (2011)
Resolving surface chemical states in XPS analysis of first row transition metals, oxides and hydroxides: Sc, Ti, V, Cu and Zn
Mark C. Biesinger et al.
APPLIED SURFACE SCIENCE (2010)
Constant-Phase-Element Behavior Caused by Resistivity Distributions in Films I. Theory
Bryan Hirschorn et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2010)
Time of wetness in tropical climate: Considerations on the estimation of TOW according to ISO 9223 standard
F. Corvo et al.
CORROSION SCIENCE (2008)
Buried iron archaeological artefacts: Corrosion mechanisms related to the presence of Cl-containing phases
S. Reguer et al.
CORROSION SCIENCE (2007)
Application of steel thin film electrical resistance sensor for in situ corrosion monitoring
SeonYeob Li et al.
SENSORS AND ACTUATORS B-CHEMICAL (2007)
The apparent constant-phase-element behavior of an ideally polarized blocking electrode - A global and local impedance analysis
Vicky Mei-Wen Huang et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2007)
Raman imaging of ancient rust scales on archaeological iron artefacts for long-term atmospheric corrosion mechanisms study
Delphine Neff et al.
JOURNAL OF RAMAN SPECTROSCOPY (2006)
Microfluidic cells with interdigitated array gold electrodes: Fabrication and electrochemical characterization
D Daniel et al.
TALANTA (2005)
Atmospheric corrosion in subtropical areas:: influences of time of wetness and deficiency of the ISO 9223 norm
J Morales et al.
CORROSION SCIENCE (2005)
Spreading of water: Condensation effects
MER Shanahan
LANGMUIR (2001)
Estimation of the atmospheric corrosion on metal containers in industrial waste disposal
M Baklouti et al.
JOURNAL OF HAZARDOUS MATERIALS (2001)
Share Paper
