4.7 Article

Ammonia/syngas MILD combustion by a novel burner

Related references

Note: Only part of the references are listed.
Article Thermodynamics

Experimental and modeling study on the ignition delay times of ammonia/methane mixtures at high dilution and high temperatures

Jiacheng Liu et al.

Summary: Ammonia is a promising clean fuel due to its carbon-free nature and high hydrogen density, but its low reactivity and potential high NOx emissions limit its applications. Blending methane into ammonia enhances its reactivity, while lean combustion is an effective approach to control NOx emissions. This study developed a comprehensive kinetic model for ammonia/methane mixtures and found that it performs better than existing models.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2023)

Article Energy & Fuels

Experimental study and mechanism analysis of the NOx emissions in the NH3 MILD combustion by a novel burner

Haiyang Shi et al.

Summary: NH3 MILD combustion can significantly reduce NOx emissions, and the impact of NH3 flow rate and equivalence ratio on NO emissions in NH3 MILD combustion were analyzed in detail.
Article Chemistry, Physical

Carbon abatement cost of hydrogen based synthetic fuels-A general framework exemplarily applied to the maritime sector

Jonas Wahl et al.

Summary: This paper develops a techno-economic and cross-sectoral framework for quantifying the carbon-abatement-cost of hydrogen based synthetic-fuels in energy-related sectors. The framework uses Monte Carlo simulations and probability distributions to overcome specific boundary conditions and provide generally applicable results. The validated framework reveals a carbon-abatement cost of $661/tCO2median, highlighting the financial gap hindering the market uptake of synthetic fuels. However, the framework also identifies a potential reduction to $553/tCO2median through the quantification of financial interest benefits.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2022)

Article Chemistry, Applied

Combustion regimes and fuel-NO mechanism of CH4/NH3 jet diffusion flames in hot O2/CO2 co-flow

Zhenghong Zhao et al.

Summary: This paper numerically evaluates the effects of co-flow oxygen concentration and temperature on the combustion regimes and fuel-NO mechanism of CH4/NH3 jet diffusion flames in MILD-oxy combustion. The results show that the appropriate co-flow oxygen concentration and temperature can achieve low-NOx emissions and reduce nitrogen oxide formation.

FUEL PROCESSING TECHNOLOGY (2022)

Article Thermodynamics

Ammonia/Methane combustion: Stability and NOx emissions

Giovanni Battista Ariemma et al.

Summary: Ammonia is considered a valuable energy vector in the shift towards Renewable Energy Sources. This study investigates the combustion characteristics of ammonia/methane blends under MILD Combustion conditions, revealing that the use of blends expands the operational range of the system but leads to higher NOx emissions.

COMBUSTION AND FLAME (2022)

Article Thermodynamics

Evolution of N2O production at lean combustion condition in NH3 /H2 /air premixed swirling flames

S. Mashruk et al.

Summary: In the development of ammonia-hydrogen blends as potential substitutes for fossil fuels, the impact of different conditions on the production of NOX, especially N2O, has been evaluated. It was found that increasing ammonia content in the fuel can decrease NO and NO2 emissions but increase N2O emissions. High ammonia content also leads to increased unreacted ammonia fractions, potentially affecting flame stability and temperature.

COMBUSTION AND FLAME (2022)

Article Thermodynamics

Nitrogen oxide emissions analyses in ammonia/hydrogen/air premixed swirling flames

Syed Mashruk et al.

Summary: Ammonia/hydrogen fuel blends show promise in the development of a hydrogen economy, with advantages in storage cost and combustion properties compared to pure hydrogen or pure ammonia. This study investigates the nitrogen oxide emissions trends for these blends and identifies the optimal fuel fractions and equivalence ratios for reducing emissions.

ENERGY (2022)

Article Energy & Fuels

Flame stability and emissions characteristics of liquid ammonia spray co-fired with methane in a single stage swirl combustor

Ekenechukwu C. Okafor et al.

Summary: This study successfully conducted liquid ammonia spray combustion under preheated air conditions, demonstrating that preheated air can enhance the dispersion and evaporation of the liquid droplets, thereby reducing spray height and achieving stable combustion of liquid ammonia spray alone.
Article Thermodynamics

Thermo-chemical manifold reduction for tabulated chemistry modeling. Temperature and dilution constraints for smooth combustion reactors

Giancarlo Sorrentino et al.

Summary: New scenarios for energy systems emphasize the importance of designing innovative combustion systems with high levels of internal dilution and preheating. Proper modeling tools considering multiple physical phenomena under distributed ignition are crucial for the large-scale utilization of these concepts. Tabulated chemistry methods provide viable solutions for representing thermo-chemical patterns in combustion systems with internal recirculation.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Influence of water addition on MILD ammonia combustion performances and emissions

G. B. Ariemma et al.

Summary: The use of ammonia as an alternative energy carrier poses challenges related to combustion stability and NOx emissions. New combustion modes like MILD Combustion and strategies like water addition to reactants have been explored to address these challenges and improve combustion performance.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Influence of wall heat loss on the emission characteristics of premixed ammonia-air swirling flames interacting with the combustor wall

Ekenechukwu C. Okafor et al.

Summary: The study investigates the influence of wall heat loss on ammonia-air swirling flames, finding that heat loss strongly affects the flames, leading to flame quenching and increased emissions of unburned NH3, while also promoting the extension of fuel-rich stabilization limit.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Effects of OH concentration and temperature on NO emission characteristics of turbulent non-premixed CH4/NH3/air flames in a two-stage gas turbine like combustor at high pressure

Kapuruge Don Kunkuma Amila Somarathne et al.

Summary: This study investigated the effects of OH concentration and temperature on NO emissions in turbulent, non-premixed methane/ammonia/air swirl flames at high pressure. Utilizing far-rich equivalence ratios could significantly reduce NO emissions from CH4/NH3 flames. Local flame characteristics were found to be qualitatively similar to NH3/air flames, but temperatures and OH concentrations decreased gradually with NH3 substitution.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

An experimental and modeling study of ammonia with enriched oxygen content and ammonia/hydrogen laminar flame speed at elevated pressure and temperature

Krishna Prasad Shrestha et al.

Summary: This study experimentally investigated the laminar flame speeds of ammonia and ammonia-hydrogen blends under different temperature, pressure, and oxygen content conditions, and developed a new kinetic model for predicting the oxidation mechanisms, considering the formation and reduction of nitrogen oxides. The results showed that the laminar flame speed increases with increasing initial temperature, fuel hydrogen content, or oxidizer oxygen content, but decreases with increasing initial pressure. The proposed kinetic model predicts the same trends as experiments and highlights the importance of N2H2 formation under rich conditions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Experimental and kinetic modeling study on NH3/syngas/air and NH3/bio-syngas/air premixed laminar flames at elevated temperature

Shangkun Zhou et al.

Summary: Ammonia (NH3) plays a crucial role in large-scale storage and long-distance transportation of renewable energy. Co-firing with syngas and bio-syngas, along with increasing the initial temperature of reactants, are effective methods to enhance the reactivity of NH3 flames. However, current kinetic models lack accuracy in temperature dependence, indicating a need for further research in this area.

COMBUSTION AND FLAME (2021)

Article Chemistry, Physical

Rich-Quench-Lean model comparison for the clean use of humidified ammonia/hydrogen combustion systems

S. Mashruk et al.

Summary: Ammonia and hydrogen are zero-carbon fuels with high potential for gas turbine technologies, but nitrogen oxide emissions pose a major challenge. Rich-Quench-Lean systems with humidified atmospheres are promising solutions for reducing emissions through recombination of species and lower combustion temperatures.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Energy & Fuels

Modeling of syngas composition obtained from fixed bed gasifiers using Kuhn-Tucker multipliers

Jordan Amaro et al.

Summary: This work developed a predictive model for syngas composition from biomass gasification in fixed bed gasifiers, which showed better estimates compared to experimental results and other models.
Article Chemistry, Physical

Numerical investigation of the effects of H2/CO/syngas additions on laminar premixed combustion characteristics of NH3/air flame

Zhiqiang Chen et al.

Summary: This study systematically investigated the laminar premixed combustion characteristics of NH3/air flame with various H-2/CO/SYN addition loadings, and found that H-2 has the greatest effects on increasing laminar burning velocities and net heat release rates, while CO significantly improves the adiabatic flame temperatures. The addition of H-2/CO/SYN can accelerate NH3 decomposition rates and promote the generation of radicals, showing a positive linear correlation with laminar burning velocities.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Energy & Fuels

Experimental and Kinetic Investigation of Stoichiometric to Rich NH3/H2/Air Flames in a Swirl and Bluff-Body Stabilized Burner

Goncalo P. Pacheco et al.

Summary: Ammonia is considered a promising fuel for decarbonization in the power sector due to its lack of carbon and ability to produce energy with zero CO2 emissions. However, challenges such as low reactivity, low flame speed, and formation of nitrogen oxides and ammonia slip exist during its combustion. The use of rich-to-lean combustion approaches can help mitigate NOx formation and improve combustion efficiency, as investigated experimentally and computationally in this study.

ENERGY & FUELS (2021)

Article Energy & Fuels

Emission analysis of the CH4/NH3/air co-firing fuels in a model combustor

Meng Zhang et al.

Summary: This study investigates the combustion performances and emission characteristics of co-firing CH4/NH3/air flame in a swirl combustor, and finds that low combustion efficiency and significant increase in NOX emissions occur in high eta NH3 flames when blending a small amount of ammonia. The co-firing flames produce large amount of NOx at lean conditions.
Article Chemistry, Physical

Stability limits and NO emissions of premixed swirl ammonia-air flames enriched with hydrogen or methane at elevated pressures

Abdulrahman A. Khateeb et al.

Summary: Increasing pressure widens the range of stable equivalence ratios for pure ammonia-air flames. There is a critical ammonia fraction above which the range of stable equivalence ratios suddenly widens, regardless of pressure. The critical ammonia fraction increases with pressure and is larger for ammonia-hydrogen than for ammonia-methane.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Thermodynamics

Exploration on laminar flame propagation of ammonia and syngas mixtures up to 10 atm

Bowen Mei et al.

COMBUSTION AND FLAME (2020)

Article Thermodynamics

Development of a wide range-operable, rich-lean low-NOx combustor for NH3 fuel gas-turbine power generation

Osamu Kurata et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Article Energy & Fuels

Fuel rich ammonia-hydrogen injection for humidified gas turbines

M. Gutesa Bozo et al.

APPLIED ENERGY (2019)

Review Thermodynamics

Science and technology of ammonia combustion

Hideaki Kobayashi et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

Article Thermodynamics

Experimental and numerical study of the laminar burning velocity of CH4-NH3-air premixed flames

Ekenechukwu C. Okafor et al.

COMBUSTION AND FLAME (2018)

Review Thermodynamics

Modeling nitrogen chemistry in combustion

Peter Glarborg et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2018)

Review Thermodynamics

Ammonia for power

A. Valera-Medina et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2018)

Review Thermodynamics

Flameless combustion and its potential towards gas turbines

Andre A. V. Perpignan et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2018)

Article Chemistry, Physical

Experimental investigation of stabilization and emission characteristics of ammonia/air premixed flames in a swirl combustor

Akihiro Hayakawa et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Chemistry, Physical

Porous medium based burner for efficient and clean combustion of ammonia-hydrogen-air systems

Hadi Nozari et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Thermodynamics

Performances and emission characteristics of NH3-air and NH3-CH4-air combustion gas-turbine power generations

Osamu Kurata et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)

Article Energy & Fuels

Ammonia-methane combustion in tangential swirl burners for gas turbine power generation

Agustin Valera-Medina et al.

APPLIED ENERGY (2017)

Article Energy & Fuels

Study on using hydrogen and ammonia as fuels: Combustion characteristics and NOx formation

Jun Li et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2014)

Article Chemistry, Physical

Ammonia as hydrogen carrier for transportation; investigation of the ammonia exhaust gas fuel reforming

Wentao Wang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)

Review Green & Sustainable Science & Technology

Assessment of utility energy storage options for increased renewable energy penetration

Annette Evans et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2012)

Article Chemistry, Multidisciplinary

Effects of nitrogen dilution for coal synthetic gas fuel on the flame stability and NOx formation

Chan Lee et al.

KOREAN JOURNAL OF CHEMICAL ENGINEERING (2009)

Article Chemistry, Physical

Using ammonia as a sustainable fuel

C. Zamfirescu et al.

JOURNAL OF POWER SOURCES (2008)