☆ 4.6 Article

Theoretical calculations and electrochemical investigation of additives in aqueous methanesulfonic acid for lead electrodeposition

COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS (2023)

Related references

Note: Only part of the references are listed.

Article Chemistry, Physical

A novel bright additive for copper electroplating: electrochemical and theoretical study

Yaqiang Li et al.

Summary: A cationic additive was screened using electrochemical and theoretical calculation methods to investigate its effect on copper electrodeposition. The plating process was optimized to obtain bright copper coatings, and it was found that the coatings were nanocrystalline copper.

IONICS (2023)

Add to Collection

Article Engineering, Chemical

Green hydrometallurgical extraction of metallic lead from spent lead paste in the methanesulfonic acid system

Cong Chang et al.

Summary: This paper presents an innovative and efficient process for the hydrometallurgical recovery of lead paste, which improves the leaching efficiency of lead by converting PbSO4 in the lead paste into acid-soluble Pb3(CO3)2(OH)2 or NaPb2(CO3)2OH in Na2CO3 solution. Under optimized conditions, a dense and flat lead plate with purity greater than 99.99% can be obtained, and the total lead recovery ratio in the whole process can reach 95.28%.

SEPARATION AND PURIFICATION TECHNOLOGY (2023)

Add to Collection

Article Chemistry, Physical

In Situ Electroplating of Ir@Carbon Cloth as High-Performance Selective Oxygen Evolution Reaction Catalyst for Direct Electrolytic Recovery of Lead

Kai Che et al.

Summary: In this study, an anodic oxygen evolution reaction catalyst with a low Ir mass fraction of 7.2% was obtained by electroplating iridium on carbon cloth (CC). The use of CC-Ir as an anodic catalyst effectively suppressed the side reaction of PbO2, reducing energy consumption and increasing recovery efficiency in lead electrolytic recovery process.

CATALYSTS (2023)

Add to Collection

Article Chemistry, Physical

Investigation of novel leveler Rhodamine B on copper superconformal electrodeposition of microvias by theoretical and experimental studies

Yaqiang Li et al.

Summary: Achieving void-defect copper filling by electrodeposition on microvias is crucial, and Rhodamine B (RhB) has been found to effectively suppress defects. The optimal concentration of RhB for achieving bottom-up growth was determined as 100 mg/L using convection-dependent adsorption analysis. The interaction between sodium 3,3'-dithiodipropane sulfonate, polyethylene glycol, and RhB was investigated, and competition adsorption between RhB and SPS was observed. The introduction of RhB improved surface morphology, reduced surface roughness, and promoted the formation of Cu (111) surface, while also improving wettability for better bottom-up growth.

APPLIED SURFACE SCIENCE (2023)

Add to Collection

Review Engineering, Environmental

Recent developments of electrodeposition-redox replacement in metal recovery and functional materials: A review

Linfan Cui et al.

Summary: One way to address the increasing demand for metals and the depletion of high-grade raw materials is through innovative methods of metal recovery. Electrochemical recovery, specifically the combination of electrodeposition and redox replacement processes, has shown promise in efficiently recovering precious metals from underutilized secondary raw materials and hydrometallurgical solutions. This technology allows for the controllable preparation of metal coatings, nanoparticles, and functional surfaces, indicating its potential to alleviate material scarcity. In this review, we analyze the progress and future prospects of electrochemical recovery for metal recovery and the creation of high-value-added materials, including energy efficiency and sustainable materials.

CHEMICAL ENGINEERING JOURNAL (2023)

Add to Collection

Article Chemistry, Multidisciplinary

The influence of leveler Brilliant Green on copper superconformal electroplating based on electrochemical and theoretical study

Yaqiang Li et al.

Summary: Finding the right additive for copper superconformal electrodeposition is crucial. Brilliant Green has been found to effectively suppress copper electrodeposition according to electro-chemical analysis. The optimum concentration of 100 mg/L was determined based on the analysis of convection-dependent adsorption behavior. The interaction between different additives was also investigated, and the introduction of Brilliant Green improved the transport of cupric ions.

JOURNAL OF INDUSTRIAL AND ENGINEERING CHEMISTRY (2023)

Add to Collection

Article Green & Sustainable Science & Technology

Life cycle assessment of soluble lead redox flow battery

Emmanuel Shittu et al.

Summary: The soluble lead redox flow battery is a promising flow battery solution with lower cost and lower environmental impact compared to other stationary storage applications, such as lithium-ion batteries and lead acid batteries.

JOURNAL OF CLEANER PRODUCTION (2022)

Add to Collection

Article Chemistry, Physical

Revealing the acceleration effect of SPS and Cl- on copper Surface: Instantaneous nucleation and Multi-Step energy change

Penghui Ren et al.

Summary: The acceleration effect of Cl- and bis-(sodium sulfopropyl)-disulfide (SPS) in electroplating solution was analyzed using various electrochemical methods and dynamic simulation with DFT. The reduction rate of Cu2+/1+ in the solution containing Cl- was found to be faster than that in the solution without Cl-.

APPLIED SURFACE SCIENCE (2022)

Add to Collection

Article Chemistry, Physical

Optimization of electrodeposition nanocrytalline Ni-Fe alloy coatings for the replacement of Ni coatings

Yaqiang Li et al.

Summary: This study successfully fabricated nanocrystalline Ni-Fe alloy coatings with excellent brightness and corrosion resistance. The electrodeposition behavior of the coatings was investigated, revealing the co-deposition mechanism of Ni2+ and Fe2+. XRD and TEM analysis confirmed the formation of intermetallic compound Ni3Fe phase with small grain size. SEM and AFM images showed that the coating surface was nanocrystalline and compact, with lower roughness than pure Ni coating. The nanocrystalline Ni-Fe alloy coating exhibited good corrosion resistance.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Add to Collection

Article Chemistry, Physical

Micro Pb filled polymer composites: Theoretical, experimental and simulation results for γ-ray shielding performance

O. Kilicoglu et al.

Summary: Research on advanced composites for protecting the environment from radioactive pollution has shown that polymer micro composites loaded with micro lead (Pb) have high attenuation coefficients for photon radiation, making them promising for applications in protective enclosures and other protective measures.

RADIATION PHYSICS AND CHEMISTRY (2022)

Add to Collection

Article Chemistry, Analytical

Influence of suppressing additive malachite green on superconformal cobalt electrodeposition

Xiaochuan Ma et al.

Summary: In this study, a novel suppressor, malachite green, was used to achieve the bottom-up growth of cobalt. The interaction between malachite green and metal substrate, as well as the interaction between malachite green and cobalt ions, was analyzed to illustrate the inhibition mechanism of malachite green. Electrochemical analysis confirmed the inhibitory effect of malachite green. The results of current transient analysis showed that an effective malachite green concentration gradient could be formed within blind vias, leading to the bottom-up growth of cobalt.

JOURNAL OF ELECTROANALYTICAL CHEMISTRY (2022)

Add to Collection

Article Chemistry, Multidisciplinary

Green Electrorefining of Crude Lead with High-Quality Deposits in an Additive-Assisted Methanesulfonic Acid System

Changliu Xiang et al.

Summary: In this study, an additive-assisted methanesulfonic acid (MSA) system was proposed for green and efficient electrorefining of crude lead. Experimental results showed that the system achieved lower energy demand and higher cathodic current efficiency compared to conventional systems. Additionally, the obtained product had high purity and the distribution behavior of elements was clearly demonstrated.

ACS SUSTAINABLE CHEMISTRY & ENGINEERING (2022)

Add to Collection

Article Green & Sustainable Science & Technology

Lead Electrorefining Process from Exhausted Lead Acid Batteries by Using Acidic and Alkaline Electrolytes

A. Mondal et al.

Summary: This study compares two electrorefining processes using acidic and alkaline electrolytes and finds that the acidic electrolyte has higher productivity and lower specific energy consumption.

JOURNAL OF SUSTAINABLE METALLURGY (2022)

Add to Collection

Article Chemistry, Physical

Electrochemical behavior of through-hole electrodeposition inhibitor EO-PO under periodic pulse reverse

Yuanhang Zhang et al.

Summary: This study systematically investigated the behavior of an ethylene oxide propylene oxide random copolymer as an inhibitor during the periodic pulse reverse electrodeposition process. It was found that this inhibitor can effectively improve the uniformity of electrodeposition and enhance the concentration window of ethylene oxide propylene oxide.

COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS (2022)

Add to Collection

Article Electrochemistry

Effects of Thiourea and Allyl Thioura on the Electrodeposition and Microstructures of Copper from Methanesulfonic Acid Baths

Chi-Haw Chiang et al.

Summary: This study found that the additives thiourea and allyl thioura have significant effects on the crystallographic texture and surface morphology of copper deposits, despite having similar molecular structures.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)

Add to Collection

Article Green & Sustainable Science & Technology

Electro-Deposition Behavior in Methanesulfonic-Acid-Based Lead Electro-Refining

You-gang Li et al.

Summary: This study investigated the electro-deposition behavior of Pb in the MSA system, revealing the thermodynamic priority of Pb2+/Pb reduction reaction over H+/H-2. Various factors affecting Pb electrodeposition were studied, and numerical calculations helped acquire in-depth kinetics and mechanism knowledge, offering guidance in practice optimization.

JOURNAL OF SUSTAINABLE METALLURGY (2021)

Add to Collection

Article Chemistry, Physical

Chemical-Electrochemical Process Concept for Lead Recovery from Waste Cathode Ray Tube Glass

Arpad Imre-Lucaci et al.

Summary: This paper introduces a novel method for recovering lead from waste CRT glass using a chemical-electrochemical process. Experimental results demonstrate that the process is efficient in recovering lead and eco-friendly under specific operating conditions.

MATERIALS (2021)

Add to Collection

Article Chemistry, Applied

Quinacridone skeleton as a promising efficient leveler for smooth and conformal copper electrodeposition

Xiaomin Wang et al.

DYES AND PIGMENTS (2020)

Add to Collection

Article Chemistry, Multidisciplinary

Lead(II) chloride effects on nuclear shielding capabilities of polymer composites

F. Ozkalayci et al.

JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS (2020)

Add to Collection

Article Chemistry, Physical

A new green, energy-saving, and pressing refining process for the recovery of ultrahigh-purity lead in alkaline solution from spent lead plate grids

Xuan Zhang et al.

IONICS (2019)

Add to Collection

Review Chemistry, Physical

Developments in electrochemical processes for recycling lead-acid batteries

Sze-yin Tan et al.

CURRENT OPINION IN ELECTROCHEMISTRY (2019)

Add to Collection

Article Electrochemistry

Computational analysis and experimental evidence of two typical levelers for acid copper electroplating

Zhiqiang Lai et al.

ELECTROCHIMICA ACTA (2018)

Add to Collection

Article Chemistry, Analytical

Electrochemical study and extraction of Pb metal from Pb oxides and Pb sulfate using hydrophobic Bronsted acidic amide-type ionic liquid: A feasibility demonstration

Hsing-Wen Yeh et al.

JOURNAL OF ELECTROANALYTICAL CHEMISTRY (2018)

Add to Collection

Review Energy & Fuels

Lead batteries for utility energy storage: A review

Geoffrey J. May et al.

JOURNAL OF ENERGY STORAGE (2018)

Add to Collection

Article Electrochemistry

A Clean and Highly Efficient Leaching-Electrodeposition Lead Recovery Route in HClO4 Solution

Xuan Zhang et al.

INTERNATIONAL JOURNAL OF ELECTROCHEMICAL SCIENCE (2017)

Add to Collection

Article Engineering, Chemical

A green electrorefining process for production of pure lead from methanesulfonic acid medium

Bingjie Jin et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2016)

Add to Collection

Article Optics

Thin-film Sb2Se3 photovoltaics with oriented one-dimensional ribbons and benign grain boundaries

Ying Zhou et al.

NATURE PHOTONICS (2015)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Fundamental study of lead recovery from cerussite concentrate with methanesulfonic acid (MSA)

Zhenghui Wu et al.

HYDROMETALLURGY (2014)

Add to Collection

Article Chemistry, Multidisciplinary

Wavefunction and reactivity study of benzo[a]pyrene diol epoxide and its enantiomeric forms

Tian Lu et al.

STRUCTURAL CHEMISTRY (2014)

Add to Collection

Article Materials Science, Coatings & Films

Versatile electrochemical coatings and surface layers from aqueous methanesulfonic acid

Frank C. Walsh et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Morphological and crystallographic characteristics of lead powder obtained by electrodeposition from an environmentally friendly electrolyte

Nebojsa D. Nikolic et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2014)

Add to Collection

Article Chemistry, Analytical

A new insight into the mechanism of lead electrodeposition: Ohmic-diffusion control of the electrodeposition process

Nebojsa D. Nikolic et al.

JOURNAL OF ELECTROANALYTICAL CHEMISTRY (2013)

Add to Collection

Article Chemistry, Multidisciplinary

Multiwfn: A multifunctional wavefunction analyzer

Tian Lu et al.

JOURNAL OF COMPUTATIONAL CHEMISTRY (2012)

Add to Collection

Article Chemistry, Multidisciplinary

Nanogravimetric study of lead underpotential deposition on selenium thin films as a semiconductor alloy formation procedure

M. F. Cabral et al.

RSC ADVANCES (2012)

Add to Collection

Article Chemistry, Physical

Hybrid lead-acid battery with reticulated vitreous carbon as a carrier- and current-collector of negative plate

A. Czerwinski et al.

JOURNAL OF POWER SOURCES (2010)

Add to Collection

Article Chemistry, Physical

A novel shielding material prepared from solid waste containing lead for gamma ray

Mehmet Erdem et al.

RADIATION PHYSICS AND CHEMISTRY (2010)

Add to Collection

Article Chemistry, Physical

Lead-acid cells with lightweight, corrosion-protected, flexible-graphite grids

B. Hariprakash et al.

JOURNAL OF POWER SOURCES (2007)

Add to Collection

Article Chemistry, Multidisciplinary

Lead recovery from waste frit glass residue of electronic plant by chemical-electrochemical methods

K Pruksathorn et al.

KOREAN JOURNAL OF CHEMICAL ENGINEERING (2005)

Add to Collection

Article Chemistry, Physical

A novel flow battery: A lead acid battery based on an electrolyte with soluble lead(II) - Part I. Preliminary studies

A Hazza et al.

PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2004)

Add to Collection

© Peeref 2019-2024. All rights reserved.