4.7 Article

Accumulative plastic strain of freezing-thawing subgrade clay under cyclic loading and its particle swarm optimisation-back-propagation-based prediction model

Journal

COLD REGIONS SCIENCE AND TECHNOLOGY
Volume 214, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.coldregions.2023.103946

Keywords

Accumulative plastic strain; Freezing-thawing clay; Cyclic loading; PSO-BP-based prediction model

Ask authors/readers for more resources

Accurate evaluation of cumulative plastic strains in subgrade soil in seasonally frozen regions is crucial for road designs and maintenance. Cyclic triaxial tests were conducted to study the influence of freeze-thaw cycles on cumulative strain characteristics of subgrade clay. The results showed that the cumulative strain increased with the dynamic stress amplitude and the number of freeze-thaw cycles. A PSO-BP model was developed to predict the accumulative plastic strain of clay, which had good agreement with experimental data.
Accurate evaluation of cumulative plastic strains in subgrade soil is crucial for road designs and maintenance. Roads in seasonally frozen regions undergo several freeze-thaw (F-T) cycles annually, resulting in considerable deterioration of soil properties. Under the repeated cyclic loading of moving vehicles, distinct residual defor-mation occurs in the thawed subgrade. To study the influence of F-T cycles on the cumulative strain charac-teristics, cyclic triaxial tests were conducted on subgrade clay under the most unfavourable conditions and in situ measured dynamic stress amplitudes. The test results revealed that the cumulative strain (eap) increased with the dynamic stress amplitude. When the dynamic stress amplitude increased from 46 kPa to 70 kPa, eap of unfrozen and F-T specimens increased by more than 14 and five times, respectively. The axial deformation of clay is sensitive to the number of F-T cycles. The freeze-thaw effect was greatest in the first cycle, with eap increasing from 1.42% to 5.63% at the end of the test (dynamic stress amplitude of 46 kPa). In subsequent cycles, relatively small deformations accumulated. A particle swarm optimisation-back-propagation-based (PSO-BP) model for predicting the accumulative plastic strain of clay was developed based on experimental results. In this model, the influences of the F-T process and loading cycles were considered. The prediction performance of the proposed model was validated and compared with that of traditional regression models. The predictions were in good agreement with the experimental data and satisfied the deterioration law for clays subjected to F-T cycles. The maximum error of the PSO-BP model was 2.75%.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available