☆ 3.8 Article

Fracture Resistance of Repaired 5Y-PSZ Zirconia Crowns after Endodontic Access

DENTISTRY JOURNAL (2023)

Related references

Note: Only part of the references are listed.

Article Dentistry, Oral Surgery & Medicine

Fracture load of 4-unit interim fixed partial dentures using 3D-printed and traditionally manufactured materials

Andreas Greuling et al.

Summary: The fracture strength of 3-dimensional printed interim materials and conventional materials were compared in this in vitro study. 4-unit interim fixed partial dentures made from 3 different materials were tested for fracture load before and after mastication simulation. Results showed that the 3D-printed interim restoration material and manufacturing process exhibited significantly lower fracture loads compared to the alternatives, but the influence of geometric differences on the results remained unclear.

JOURNAL OF PROSTHETIC DENTISTRY (2023)

Add to Collection

Article Engineering, Biomedical

The effect of surface treatments on the adhesive bond in all-ceramic dental crowns using four-point bending and dynamic loading tests

Christin Worpenberg et al.

Summary: The aim of this study was to investigate the effect of different surface treatments on the bond strength between framework ceramic and veneering ceramic. Sandblasting and grinding were carried out on samples, with and without plasma treatment. The results showed that the highest bond strength was achieved in the group with sandblasting at 90 degrees, 6 bar, and a working distance of 1.5 cm without plasma treatment, while the lowest bond strength was observed in the group with sandblasting at 90 degrees, 2 bar, and a working distance of 1 cm with plasma treatment. Overall, plasma treatment did not improve bond strength.

JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2023)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

The effect of endodontic access preparation on the failure load resistance of a 3Y-TZP monolithic zirconia crown

Jonathan Schubert et al.

Summary: Endodontic access preparation did not significantly affect the failure load resistance of 3Y-TZP zirconia crowns, with repaired crowns showing similar failure loads to unprepared controls. However, caution is advised regarding the interpretation of these findings until confirmed by clinical studies.

AUSTRALIAN ENDODONTIC JOURNAL (2022)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Fracture toughness of 3Y-TZP ceramic measured by the Chevron-Notch Beam method: A roundrobin study

Sabine Begand et al.

Summary: This interlaboratory round robin test investigated the robustness of the ChevronNotch Beam (CNB) test method and the effect of the processing and testing variations on the fracture toughness of a dental 3Y-TZP ceramic. The results revealed that the CNB method is suitable for determination of KIc on fine-grained ceramics such as 3Y-TZP ceramic, and by using tighter tolerances for processing and testing, a highly-precise evaluation of fracture toughness with low data variation is achievable.

DENTAL MATERIALS (2022)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Bonding of Resin Cements to Ultra-Translucent Zirconia After Aging for 24 Hours and 1 Year

Isadora Martini Garcia et al.

Summary: This study evaluated the effect of different luting techniques on the shear bond strength of ultra-translucent multi-layered zirconia and analyzed the influence of primers on the surface wettability. The results showed that using specific resin cements and primers can improve the bond strength and wettability, thus contributing to a stable long-term restoration.

INTERNATIONAL JOURNAL OF PROSTHODONTICS (2022)

Add to Collection

Article

Effects of yttria content and sintering temperature on the microstructure and tendency to brittle fracture of yttria-stabilized zirconia

V.V. Kulyk et al.

Archives of Materials Science and Engineering (2021)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Biaxial flexural strength of zirconia: A round robin test with 12 laboratories

Sebastian Spintzyk et al.

Summary: The interlaboratory round robin test aimed to verify the robustness of DIN EN ISO 6872:2019 and identify the influence of processing and testing variations. Results showed significant differences in flexural strength based on different preparation methods, with a certain degree of correlation between strength increase and surface roughness.

DENTAL MATERIALS (2021)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Effect of Repairing Endodontic Access Cavities on Survival of Single Crowns and Retainer Restorations

Annette Wiegand et al.

JOURNAL OF ENDODONTICS (2020)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Endodontic Access Effect on Full Contour Zirconia and Lithium Disilicate Failure Resistance

J. Mallya et al.

OPERATIVE DENTISTRY (2020)

Add to Collection

Review Dentistry, Oral Surgery & Medicine

Novel Zirconia Materials in Dentistry

Y. Zhang et al.

JOURNAL OF DENTAL RESEARCH (2018)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Performance of Monolithic and Veneered Zirconia Crowns After Endodontic Treatment and Different Repair Strategies

A. Scioscia et al.

OPERATIVE DENTISTRY (2018)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Reasons for placement and replacement of crowns in general dental practice

C. D. Lynch et al.

BRITISH DENTAL JOURNAL (2018)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Bonding effectiveness to different chemically pre-treated dental zirconia

Masanao Inokoshi et al.

CLINICAL ORAL INVESTIGATIONS (2014)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Simulation of cumulative damage associated with long term cyclic loading using a multi-level strain accommodating loading protocol

Moustafa Nabil Aboushelib

DENTAL MATERIALS (2013)

Add to Collection

Review Dentistry, Oral Surgery & Medicine

Current status of zirconia restoration

Takashi Miyazaki et al.

JOURNAL OF PROSTHODONTIC RESEARCH (2013)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Chipping behaviour of all-ceramic crowns with zirconia framework and CAD/CAM manufactured veneer

M. Schmitter et al.

JOURNAL OF DENTISTRY (2012)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Composite Resin to Yttria Stabilized Tetragonal Zirconia Polycrystal Bonding: Comparison of Repair Methods

P. Cristoforides et al.

OPERATIVE DENTISTRY (2012)

Add to Collection

Review Dentistry, Oral Surgery & Medicine

Assessment of mastication with implications for oral rehabilitation: a review

A. van der Bilt

JOURNAL OF ORAL REHABILITATION (2011)

Add to Collection

Article Engineering, Biomedical

Unstable cracking (chipping) of veneering porcelain on all-ceramic dental crowns and fixed partial dentures

M. V. Swain

ACTA BIOMATERIALIA (2009)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Effect of water aging on microtensile bond strength of dual-cured resin cements to pre-treated sintered zirconium-oxide ceramics

Raquel Castillo Oyague et al.

DENTAL MATERIALS (2009)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Surface Conditioning Influences Zirconia Ceramic Bonding

M. Kern et al.

JOURNAL OF DENTAL RESEARCH (2009)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

State of the art of zirconia for dental applications

Isabelle Denry et al.

DENTAL MATERIALS (2008)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Durability of the resin bond strength to zirconia ceramic after using different surface conditioning methods

Mona Wolfart et al.

DENTAL MATERIALS (2007)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Effect of silica coating and silanization on flexural and composite-resin bond strengths of zirconia posts: An in vitro study

AA Xible et al.

JOURNAL OF PROSTHETIC DENTISTRY (2006)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

In vitro evaluation of shear bond strengths of resin to densely-sintered high-purity zirconium-oxide ceramic after long-term storage and thermal cycling

MB Blatz et al.

JOURNAL OF PROSTHETIC DENTISTRY (2004)

Add to Collection

Article Dentistry, Oral Surgery & Medicine

Fracture strength after dynamic loading of endodontically treated teeth restored with different post-and-core systems

G Heydecke et al.

JOURNAL OF PROSTHETIC DENTISTRY (2002)

Add to Collection

© Peeref 2019-2024. All rights reserved.