4.4 Article

Tribological Response of δ-Bi2O3 Coatings Deposited by RF Magnetron Sputtering

Journal

LUBRICANTS
Volume 11, Issue 5, Pages -

Publisher

MDPI
DOI: 10.3390/lubricants11050207

Keywords

lubricious oxide; bismuth oxide; cubic delta-phase; coatings; sputtering; coefficient of friction

Ask authors/readers for more resources

Bismuth oxide (Bi2O3) coatings and composite coatings containing this oxide have been investigated for their potential applications in various fields. Two parametric models based on chemical features have been proposed to predict the lubricity response of oxides, but they provide contradictory values for the coefficient of friction (COF) of Bi2O3. In this study, magnetron sputtering was used to deposit Bi2O3 coatings on steel substrates, and tribological responses were evaluated. The delta-Bi2O3 phase showed low wear and COFs, indicating lubricious behavior and supporting the validity of one of the models. Challenges regarding adhesion strength and thermal stability were observed for future applications.
Bismuth oxide (Bi2O3) coatings and composite coatings containing this oxide have been studied due to their potential applications in gas sensing, optoelectronics, photocatalysis, and even tribology. Two parametric models based on chemical features have been proposed with the aim of predicting the lubricity response of oxides. However, such models predict contradictory values of the coefficient of friction (COF) for Bi2O3. In this study, we deposited Bi2O3 coatings, via magnetron sputtering, on AISI D2 steel substrates to evaluate the tribological responses of the coatings and determine which parametric model describes them better. Experimentally, only coatings presenting the cubic defective fluorite-like delta-Bi2O3 phase could be evaluated. We performed pin-on-disk tests at room temperature and progressively increasing temperatures up to 300 degrees C using alumina and steel counter-bodies. Low wear and COFs (0.05 to 0.15) indicated that the delta-phase behaves as a lubricious solid, favoring the validity of one of the models. An alternative explanation is proposed for the low COF of the defective fluorite-like structure since it is well known that it contains 25% of anionic vacancies that can be ordered to form low shear-strength planes, similar to the Magneli phases. Two challenges for future potential applications were observed: one was the low adhesion strength to the substrate, and the other was the thermal stability of this phase.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.4
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available