☆ 4.6 Article

Effects of Bi and Cu addition on mechanical properties of Sn9Zn alloy and interfacial intermetallic growth with Ni substrate

MATERIALS TODAY COMMUNICATIONS (2023)

Related references

Note: Only part of the references are listed.

Article Materials Science, Multidisciplinary

Nanoindentation creep behavior of nanocrystalline Ni and Ni-20 wt% Fe alloy and underlying mechanisms revealed by apparent activation volumes

Weiming Sun et al.

Summary: The nanoindentation creep behavior and underlying mechanisms of nanocrystalline Ni and Ni-Fe alloy were studied using a new testing method. The continuous creep strain rate and apparent activation volume data were obtained using the continuous stiffness measurement (CSM) technique. The effects of loading rate and stacking fault energy on the nanoindentation creep behavior were analyzed. The study found that the Ni-Fe alloy showed higher creep resistance in the transient regime but lower creep resistance in the steady-state regime compared to Ni. The contact stiffness data obtained by CSM technique can be used to determine the creep stress data.

MATERIALS & DESIGN (2023)

Add to Collection

Article Engineering, Manufacturing

Effects of doping trace Ni element on interfacial behavior of Sn/Ni (polycrystal/single-crystal) joints

Jianing Wang et al.

Summary: The study investigates the influence of doping minor Ni on the microstructure evolution of Sn-xNi/Ni (single-crystal) solder joints (x = 0, 0.05 and 0.1 wt.%). Results showed that the growth behavior of the interfacial layer differed due to the different mechanisms of element diffusion of the two substrates.

SOLDERING & SURFACE MOUNT TECHNOLOGY (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Structural, Thermal and Wetting Characteristics of Novel Low Bi-Low Ag Containing Sn-x.Ag-0.7Cu-1.0Bi (x=0.5 to 1.5) Alloys for Electronic Application

Raj Kumar Kaushik et al.

Summary: The study found that increasing Ag content in low Bi-low Ag alloys can lower the melting point and contact angle, while restricting the growth of interfacial IMC layers during thermal aging, making them suitable for use in portable electronics.

METALS AND MATERIALS INTERNATIONAL (2021)

Add to Collection

Article Engineering, Multidisciplinary

Elastic recovery induced strengthening effect in copper/ multilayer-graphene interface regions revealed by instrumental nanoindentation

Xueliang Wang et al.

Summary: The study found that the elastic recovery behavior induced by MLG significantly increased the hardness in the Cu/MLG interface region, and also revealed the gradient strengthening effect, which can be used to precisely enhance the mechanical performance of copper matrix composite materials by adjusting the interfacial microstructure and properties.

COMPOSITES PART B-ENGINEERING (2021)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Influence of bismuth on microstructure, thermal properties, mechanical performance, and interfacial behavior of SAC305-xBi/Cu solder joints

Suchart CHANTARAMANEE et al.

Summary: The addition of a small amount of bismuth in SAC305 solder joints can improve their properties by refining the microstructure, reducing the melting temperature, and enhancing the mechanical performance.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2021)

Add to Collection

Article Chemistry, Physical

Effects of minor alloying with Ge and In on the interfacial microstructure between Zn-Sn solder alloy and Cu substrate

Yuhang Wei et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Add to Collection

Article Chemistry, Physical

Improved microstructure and mechanical properties for SnBi solder alloy by addition of Cr powders

Wenbo Zhu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Effect of Bi on the microstructure and mechanical properties of Sn-Zn alloys processed by rolling

Guangyu Liu et al.

MATERIALS CHARACTERIZATION (2018)

Add to Collection

Article Engineering, Electrical & Electronic

Microstructure and interfacial reaction of Sn-Zn-x(Al,Ag) near-eutectic solders on Al and Cu substrates

M. L. Huang et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2014)

Add to Collection

Article Chemistry, Physical

Microstructure and mechanical properties of Sn-Bi, Sn-Ag and Sn-Zn lead-free solder alloys

Wislei R. Osorio et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2013)

Add to Collection

Article Materials Science, Multidisciplinary

Enhancing mechanical response of hypoeutectic Sn-6.5Zn solder alloy using Ni and Sb additions

A. A. El-Daly et al.

MATERIALS & DESIGN (2013)

Add to Collection

Article Materials Science, Multidisciplinary

Tensile properties and wettability of SAC0307 and SAC105 low Ag lead-free solder alloys

Fangjie Cheng et al.

JOURNAL OF MATERIALS SCIENCE (2011)

Add to Collection

Article Engineering, Electrical & Electronic

Properties and microstructure of Sn-9Zn lead-free solder alloy bearing Pr

Zhengxiang Xiao et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2011)

Add to Collection

Article Engineering, Electrical & Electronic

Effects of rare earth element Nd on the solderability and microstructure of Sn-Zn lead-free solder

Yu-hua Hu et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2011)

Add to Collection

Article Engineering, Electrical & Electronic

High-temperature lead-free solder alternatives

Vivek Chidambaram et al.

MICROELECTRONIC ENGINEERING (2011)

Add to Collection

Article Chemistry, Physical

Effect of Bi addition on the activation energy for the growth of Cu5Zn8 intermetallic in the Sn-Zn lead-free solder

Ramani Mayappan et al.

INTERMETALLICS (2010)

Add to Collection

Article Chemistry, Physical

Effect of phosphorus element on the comprehensive properties of Sn-Cu lead-free solder

Guangdong Li et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2010)

Add to Collection

Article Engineering, Electrical & Electronic

Investigation on properties of Ga to Sn-9Zn lead-free solder

Wenxue Chen et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2010)

Add to Collection

Review Engineering, Electrical & Electronic

Development of Sn-Zn lead-free solders bearing alloying elements

Liang Zhang et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2010)

Add to Collection

Article Materials Science, Multidisciplinary

Depressing effect of 0.1 wt.% Cr addition into Sn-9Zn solder alloy on the intermetallic growth with Cu substrate during isothermal aging

Jin Hu et al.

MATERIALS CHARACTERIZATION (2010)

Add to Collection

Article Nanoscience & Nanotechnology

Effects of small addition of Ag and/or Cu on the microstructure and properties of Sn-9Zn lead-free solders

A. A. El-Daly et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

Add to Collection

Article Materials Science, Multidisciplinary

High-Temperature Lead-Free Solders: Properties and Possibilities

Katsuaki Suganuma et al.

JOM (2009)

Add to Collection

Article Chemistry, Applied

Effects of cerium on Sn-Ag-Cu alloys based on finite element simulation and experiments

Zhang Liang et al.

JOURNAL OF RARE EARTHS (2009)

Add to Collection

Article Materials Science, Multidisciplinary

Thermodynamic properties and phase equilibria of Sn-Bi-Zn ternary alloys

Ching-feng Yang et al.

MATERIALS CHEMISTRY AND PHYSICS (2008)

Add to Collection

Article Thermodynamics

Thermodynamic assessment of the Bi-Sn-Zn system

Jiri Vizdal et al.

CALPHAD-COMPUTER COUPLING OF PHASE DIAGRAMS AND THERMOCHEMISTRY (2007)

Add to Collection

Article Materials Science, Multidisciplinary

Effect of Cu addition on interfacial reactions between Sn-9Zn lead-free solder and Ni substrate

Yee-wen Yen et al.

JOURNAL OF MATERIALS RESEARCH (2007)

Add to Collection

Article Chemistry, Physical

Properties of low melting point Sn-Zn-Bi solders

J Zhou et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2005)

Add to Collection

Article Materials Science, Multidisciplinary

Role of trace elements on tensile behavior of accumulative roll-bonded pure copper

Y Jang et al.

JOURNAL OF MATERIALS SCIENCE (2005)

Add to Collection

Article Chemistry, Physical

Investigation of interfacial microstructure and wetting property of newly developed Sn-Zn-Cu solders with Cu substrate

DQ Yu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2004)

Add to Collection

Article Materials Science, Multidisciplinary

Joint strength and interfacial microstructure between Sn-Ag-Cu and Sn-Zn-Bi solders and Cu substrate

A Hirose et al.

SCIENCE AND TECHNOLOGY OF ADVANCED MATERIALS (2004)

Add to Collection

Article Materials Science, Multidisciplinary

The effects of cooling rate on microstructure and mechanical behavior of Sn-3.5Ag solder

F Ochoa et al.

JOM-JOURNAL OF THE MINERALS METALS & MATERIALS SOCIETY (2003)

Add to Collection

Article Chemistry, Physical

Thermodynamic calculation of phase equilibria of the Bi-Sn-Zn system

DV Malakhov et al.

JOURNAL OF PHASE EQUILIBRIA (2000)

Add to Collection

© Peeref 2019-2024. All rights reserved.