4.6 Article

Co-Gasification Synergistic Characteristics of Sewage Sludge and High-Sodium Coal

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Transition metal load HZSM-5 catalyst assisted hydrothermal conversion of sewage sludge: Nitrogen transformation mechanism and denitrification effectiveness ofbio-oil

Yao Tong et al.

Summary: Sewage sludge is both a hazardous waste and a biomass resource rich in organic matter. In this study, hydrothermal liquefaction of sewage sludge was conducted using a transition metal supported HZSM-5 catalyst at 340°C. The nitrogen forms in the liquefaction products were analyzed and the migration and transformation paths of nitrogen were proposed. The addition of catalyst affected the physicochemical properties and yield of the products.

JOURNAL OF THE ENERGY INSTITUTE (2023)

Article Thermodynamics

Characteristics of steel slag as an oxygen carrier for chemical looping gasification of sewage sludge

Zhiyuan Zhang et al.

Summary: A comprehensive study was conducted to evaluate the characteristics of BOFS and EAFS as oxygen carriers for the CLG of SS. BOFS demonstrated higher surface roughness, wear resistance, and oxygen transport capacity compared to EAFS. The parameters showed complex trends with increasing mass ratio. The highest carbon conversion rate and cold gas efficiency were observed when the steam flow rate was 0.15 g/min for both BOFS and EAFS as oxygen carriers. BOFS exhibited faster cyclic reactivity decline but higher combustible component content.

ENERGY (2022)

Article Environmental Sciences

Energy conversion performance in co-hydrothermal carbonization of sewage sludge and pinewood sawdust coupling with anaerobic digestion of the produced wastewater

Ruikun Wang et al.

Summary: The study focused on the energy conversion and utilization of sewage sludge and lignocellulosic biomass using hydrothermal carbonization and anaerobic digestion processes. More than 60% of energy in the feedstock materials can be recovered through a coupled HTC-AD process. The temperature and reaction time during the hydrothermal carbonization process significantly affect the mass yield and higher heating value of hydrochar, while the wastewater obtained at lower temperatures showed the highest cumulative methane yield.

SCIENCE OF THE TOTAL ENVIRONMENT (2022)

Article Thermodynamics

An experimental investigation of high-ash coal gasification in a pilot-scale bubbling fluidized bed reactor

Saurabh Gupta et al.

Summary: This study investigates the gasification of low-grade, sub-bituminous coal in a pilot-scale bubbling fluidized bed reactor. The effects of equivalence ratio and steam/coal ratio on the composition of the syngas, carbon conversion, cold gas efficiency, and agglomeration behavior are studied.

ENERGY (2022)

Article Thermodynamics

Simulation on co-gasification of bituminous coal and industrial sludge in a downdraft fixed bed gasifier coupling with sensible heat recovery, and potential application in sludge-to-energy

Wenqi Zhang et al.

Summary: In this study, the co-gasification process of bituminous coal and industrial sludge in the downdraft fixed bed gasifier was modeled using Aspen Plus software. The effects of gasification temperature, air equivalent ratio, and steam to BC-IS blends ratio on the gasification characteristics were investigated. The results showed that increasing the gasification temperature improved the syngas content and gasification performance.

ENERGY (2022)

Article Energy & Fuels

Fixation of Phosphorus in Ash during Cocombustion of SewageSludge and Coals: Influence of Coal and Steam

Yi Xiao et al.

Summary: This study investigated the migration of phosphorus during the co-combustion of wet sewage sludge and various coals. The results showed that phosphorus was more easily fixed in ash as apatite at higher temperatures. Different coal compositions had varying abilities to capture phosphorus, and steam generally had a negative impact on phosphorus capture.

ENERGY & FUELS (2022)

Article Energy & Fuels

Enhanced hydrogen production from anaerobically digested sludge using microwave assisted pyrolysis

Daegi Kim et al.

Summary: Sewage sludge production has been increasing globally due to the rise in the number of wastewater treatment plants. In this study, a pyrolysis method was used to generate energy from anaerobically digested sludge, with the microwave-assisted pyrolysis method proving to be faster and more efficient than conventional pyrolysis. The MWP method resulted in a significantly higher yield of H-2 gas compared to CP, and 800 degrees C was determined to be the optimal temperature for both methods.
Article Engineering, Environmental

Syngas analysis by hybrid modeling of sewage sludge gasification in downdraft reactor: Validation and optimization

Karthickeyan Viswanathan et al.

Summary: This article addresses the thermochemical conversion of sewage sludge through a downdraft gasifier. It proposes a hybrid modeling approach using a two-zone equilibrium and one-zone kinetic model for sewage sludge gasification. The study finds that the syngas compositions and cold gas efficiency are sensitive to variations in gasifying agent flow rates, feedstock flow rate, and gasifier temperature and pressure. The article concludes by using an optimization algorithm to determine the optimal operating conditions under prescribed constraints.

WASTE MANAGEMENT (2022)

Article Chemistry, Multidisciplinary

Influence Mechanism of Water-Soluble Sodium on Zhundong Coal Pyrolysis

Zhiyuan Zhang et al.

Summary: In this study, a water-soluble sodium-loaded coal sample was prepared using crown ether, and its pyrolysis process and kinetics were investigated. The results showed that the presence of sodium intensified the pyrolysis reaction and affected the graphitization of char.

ACS OMEGA (2022)

Article Thermodynamics

Technical feasibility of biomass and paper-mill sludge co-gasification for renewable fuel production using Aspen Plus

Pali Rosha et al.

Summary: This study introduces an innovative simulation method for effectively utilizing paper-mill sludge in the production of energy-enriched renewable fuel through co-gasification. A co-gasification model based on Aspen Plus was developed to examine the synergetic effects of biomass and paper-mill sludge co-gasification. The model was validated against experimental data and showed good agreement. Sensitivity analysis revealed optimal conditions for maximum H2, CO, LHV, and CCE content in biomass gasification. The model also showed that co-gasification enhanced the H2 proportion and reduced CO content.

ENERGY (2022)

Article Energy & Fuels

Length Energy yield optimization of co-hydrothermal carbonization of sewage sludge and pinewood sawdust coupled with anaerobic digestion of the wastewater byproduct

Ruikun Wang et al.

Summary: This study focuses on optimizing the total energy yield from sewage sludge and pinewood sawdust in a hydrothermal carbonization and anaerobic digestion coupling process. The results show that the proportion of pinewood sawdust, hydrothermal carbonization temperature, and residence time have significant effects on the total energy yield, while the influence of the liquid-solid mass ratio of the raw feedstock is limited.
Article Thermodynamics

The feasibility of solar assisted pyrolysis of sewer sludge and its potential for CO2 emissions reductions

T. V. Eldredge

Summary: This study proposes the use of solar energy and a solar PTC to assist in the pyrolysis of sewage sludge, predicting significant reductions in electricity consumption and CO2 emissions. These reductions are achieved through the use of carbon-neutral pyrolysis gas and energy savings associated with sewage sludge processing.

ENERGY (2021)

Article Engineering, Environmental

Migration characteristics of heavy metals during sludge pyrolysis

Zhiyuan Zhang et al.

Summary: The study found that sludge pyrolysis is a multi-step process, with the activation energy increasing with the pyrolysis conversion rate. The thermal volatilities of heavy metals at 850 degrees Celsius followed the sequence Cu < Cr < Ni < Mn < Pb < As < Zn < Cd = Hg.

WASTE MANAGEMENT (2021)

Article Agricultural Engineering

Steam-oxygen gasification of sewage sludge: Rseduction of tar, H2S and COS with limestone as bed additive

Max Schmid et al.

Summary: This study focuses on using limestone as a bed additive in sewage sludge gasification to reduce the production of tar, H2S, and COS. Results show that adding limestone can significantly reduce heavy tar species and decrease H2S and COS concentrations without affecting NH3 levels. This approach can effectively mitigate facility problems related to tar and reduce downstream cleaning efforts.

BIOMASS & BIOENERGY (2021)

Article Engineering, Chemical

Sewage Sludge Gasification in a Fluidized Bed: Experimental Investigation and Modeling

Renata Migliaccio et al.

Summary: This study investigates the gasification of sewage sludge in a fluidized bed reactor, analyzing the characteristics of the feedstock and predicting the composition of syngas under different operating conditions. The research contributes to proper sewage sludge management within the context of the circular economy.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2021)

Article Engineering, Environmental

Hydrothermal carbonisation of mechanically dewatered digested sewage sludge-Energy and nutrient recovery in centralised biogas plant

Anna Hamalainen et al.

Summary: This study demonstrates that different types of hydrochars produced in hydrothermal carbonisation have varied impacts on the original digestates in terms of quality, total solids content, energy content, carbon content, phosphorus content, and nitrogen content. The energy content of hydrochars produced in HTC treatments is similar to that of digestates, but ash content increases. HTC treatments also yield filtrates with high soluble chemical oxygen demand and methane potential, while concentrations of pharmaceuticals and heavy metals are low.

WATER RESEARCH (2021)

Article Energy & Fuels

Effects of modified kaolin adsorbents on sodium adsorption efficiency and ash fusion characteristics during Zhundong coal combustion

Hao Zhou et al.

Summary: The study improved sodium adsorption efficiency of kaolin by using a novel modification method of intercalation-exfoliation combined with acid leaching. Experimental results showed that the modified kaolin had the best sodium adsorption performance, mainly controlled by intra-particle diffusion. The results suggest a broad application prospect for kaolin modified by the method of intercalation-exfoliation combined with acid leaching in terms of sodium adsorption capacity and alleviation of slagging tendency.

JOURNAL OF THE ENERGY INSTITUTE (2021)

Article Environmental Sciences

Influence of Potassic Additives on Sludge Gasification Under Model Flue Gas Atmosphere

Mi Yan et al.

WASTE AND BIOMASS VALORIZATION (2020)

Article Nanoscience & Nanotechnology

Catalytic Effect of Inherently-Water-Soluble Sodium on Zhundong Coal Gasification

Zhi-Yuan Zhang et al.

SCIENCE OF ADVANCED MATERIALS (2020)

Article Energy & Fuels

Co-gasification of oil palm biomass in a pilot scale downdraft gasifier

Kelechi E. Anyaoha et al.

ENERGY REPORTS (2020)

Article Thermodynamics

Co-pyrolysis characteristics of sludge mixed with Zhundong coal and sulphur contaminant release regularity

Bing Zhao et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2019)

Article Environmental Sciences

Insights into the speciation of heavy metals during pyrolysis of industrial sludge

W. D. Chanaka Udayanga et al.

SCIENCE OF THE TOTAL ENVIRONMENT (2019)

Proceedings Paper Energy & Fuels

The effect of biomass contents with heavy metal on gasification efficiency during fluidized bed gasification process

Hsien Chen et al.

RENEWABLE AND SUSTAINABLE ENERGY II, PTS 1-4 (2012)