4.7 Article

The investigation of the innovative hybrid heat pump system designed and prototyped for heating process of electric vehicles

Related references

Note: Only part of the references are listed.
Article Thermodynamics

Heating performance of a coolant-source heat pump using waste heat from stack and electric devices in fuel cell electric vehicles under cold conditions

Hoseong Lee et al.

Summary: This study investigates the heating performance of a coolant-source heat pump utilizing waste heat in FCEVs, finding that the performance is mainly dependent on the compressor speed. The utilization of waste heat from the fuel cell stack and electric devices shows different characteristics in different cooling modes.

ENERGY CONVERSION AND MANAGEMENT (2022)

Article Energy & Fuels

Prediction and optimization of the design decisions of liquid cooling systems of battery modules using artificial neural networks

Emre Bulut et al.

Summary: This study focuses on predicting the effects of cooling channel parameters on temperature, heat transfer coefficient, and pressure drop in a liquid cooling battery system using artificial neural network models. Optimization algorithms are then used to minimize pump power consumption. The chaos game optimization method shows superior performance in terms of speed, accuracy, and power reduction.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2022)

Article Thermodynamics

Performance analysis of an automotive heat pump system with desiccant coated heat exchangers

Sun-Ik Na et al.

Summary: Electric vehicles consume a lot of battery energy for heating and defogging due to the absence of waste heat from the combustion engine. This study introduces a desiccant coated heat exchanger to reduce energy consumption and improve efficiency.

APPLIED THERMAL ENGINEERING (2022)

Article Thermodynamics

Dual-separated cooling channel performance evaluation for high-power led Pcb in automotive headlight

Gokhan Sevilgen et al.

Summary: This paper conducted thermal and hydraulic analysis of a dual-separated cooling channel for automotive lighting systems, comparing theoretical and simulation results to find that using the dual-separated cooling channel can increase light output by about 10% and reduce junction temperature, resulting in improved operating efficiency.

CASE STUDIES IN THERMAL ENGINEERING (2021)

Article Thermodynamics

MULTI-OBJECTIVE OPTIMIZATION OF LIQUID COOLING SYSTEM FOR A TWELVE-CELL BATTERY MODULE

Emre Bulut et al.

HEAT TRANSFER RESEARCH (2021)

Article Engineering, Multidisciplinary

Computational fluid dynamics simulation and performance optimization of an electrical vehicle Air-conditioning system

Libin Tan et al.

Alexandria Engineering Journal (2021)

Article Thermodynamics

Investigation on the performance and characteristics of a heat pump system for electric vehicles under extreme temperature conditions

Kang Li et al.

Summary: This study investigates the performance of an ACHP system in EVs under extremely cold conditions, determining the system requirements at different temperatures and designing a prototype system based on these findings. Experimental results show that the ACHP system can meet the cooling and heating needs of EVs, increasing the driving range by 23% compared to using a PTC heater at -10 degrees Celsius.

CASE STUDIES IN THERMAL ENGINEERING (2021)

Article Thermodynamics

A new approach for battery thermal management system design based on Grey Relational Analysis and Latin Hypercube Sampling

Emre Bulut et al.

Summary: This research investigates the effects of mass flow rate and number of channels on multi-channel serpentine cooling plates, using LHS and GRA to optimize design parameters for minimizing pressure drop, maximum temperature, and maximizing convective heat transfer coefficient. The optimized design showed a significant decrease in pressure drop, a slight decrease in convective heat transfer coefficient, and a slight decrease in maximum temperature compared to the base design, demonstrating the effectiveness of the proposed approach for designing better cooling plates.

CASE STUDIES IN THERMAL ENGINEERING (2021)

Article Thermodynamics

THERMAL ANALYSIS OF DIFFERENT HEAT PUMP SYSTEMS FOR HEATING PROCESS OF ELECTRIC VEHICLES

Halil Bayram et al.

Summary: Three different 1D models of electric vehicle heating system were developed in this study, with the hybrid heat pump model showing the best thermal performance. At the end of a driving cycle at -5 degrees C ambient temperature, this model was able to increase the cabin temperature up to 25 degrees C, showcasing superior heating capability.

HEAT TRANSFER RESEARCH (2021)

Article Thermodynamics

Performance evaluation of R1234yf heat pump system for an electric vehicle in cold climate

Wanyong Li et al.

INTERNATIONAL JOURNAL OF REFRIGERATION (2020)

Review Green & Sustainable Science & Technology

The solutions to electric vehicle air conditioning systems: A review

Zhenying Zhang et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2018)

Article Engineering, Civil

Computational simulations of unsteady flow field and spray impingement on a simplified automotive geometry

Anton Kabanovs et al.

JOURNAL OF WIND ENGINEERING AND INDUSTRIAL AERODYNAMICS (2017)

Article Thermodynamics

Comparison of different cooling methods for lithium ion battery cells

Dafen Chen et al.

APPLIED THERMAL ENGINEERING (2016)

Review Green & Sustainable Science & Technology

A critical review of thermal management models and solutions of lithium-ion batteries for the development of pure electric vehicles

Qian Wang et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2016)

Article Thermodynamics

Experimental study of oil cooling systems for electric motors

Tanguy Davin et al.

APPLIED THERMAL ENGINEERING (2015)

Article Environmental Studies

Electric vehicles' energy consumption measurement and estimation

Xinkai Wu et al.

TRANSPORTATION RESEARCH PART D-TRANSPORT AND ENVIRONMENT (2015)

Article Automation & Control Systems

The effects of using different type of inlet vents on the thermal characteristics of the automobile cabin and the human body during cooling period

Muhsin Kilic et al.

INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)

Article Engineering, Mechanical

EXPERIMENTAL STUDIES ON THE HEATING PERFORMANCE OF THE PTC HEATER AND HEAT PUMP COMBINED SYSTEM IN FUEL CELLS AND ELECTRIC VEHICLES

K. Y. Kim et al.

INTERNATIONAL JOURNAL OF AUTOMOTIVE TECHNOLOGY (2012)

Article Thermodynamics

EVALUATION OF HEAT TRANSFER CHARACTERISTICS IN AN AUTOMOBILE CABIN WITH A VIRTUAL MANIKIN DURING HEATING PERIOD

Muhsin Kilic et al.

NUMERICAL HEAT TRANSFER PART A-APPLICATIONS (2009)

Article Thermodynamics

Modelling airflow, heat transfer and moisture transport around a standing human body by computational fluid dynamics

Muhsin Kilic et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2008)