4.5 Article

Degradation of biomass tar catalyzed by Fe/Ce supported on diatomite-based foam ceramics

Related references

Note: Only part of the references are listed.
Article Energy & Fuels

Catalysis/CO2 sorption enhanced pyrolysis-gasification of biomass for H2-rich gas production: Effects of activated carbon, NiO active component and calcined dolomite

Bin Li et al.

Summary: This study investigates the effects of activated carbon, NiO active component, and calcined dolomite addition on H2-rich gas production from biomass pyrolysis-gasification. The results show that activated carbon greatly enhances H2 production due to its catalytic effect and self-gasification. Lower impregnation ratio of ZnCl2 or H3PO4 to biomass is preferable for H2 production. NiO mainly enters the micropores of activated carbon and may cover some active sites, reducing self-gasification but also showing catalytic effects on H2 production. The addition of calcined dolomite further increases H2 concentration and yield, and a synergistic effect is observed with NiO/activated carbon catalyst and calcined dolomite.
Article Thermodynamics

Oxidative fast pyrolysis of biomass in a quartz tube fluidized bed reactor: Effect of oxygen equivalence ratio

Bin Li et al.

Summary: The effect of oxygen equivalence ratio (ER) on oxidative fast pyrolysis of pine sawdust was studied. Oxygen mainly oxidized the biochar, providing the largest contribution to heat demand during biomass pyrolysis for autothermal operation. The biochar yield decreased from 21.03 to 9.5 wt% with an increase in ER from 0 to 11.15%. The addition of oxygen altered the formation and distribution of bio-oil, leading to the consumption of light compounds and promotion of anhydrosugar formation.

ENERGY (2023)

Review Thermodynamics

A comprehensive review of primary strategies for tar removal in biomass gasification

M. Cortazar et al.

Summary: In the current energy scenario, biomass gasification is considered a key technology for producing heat, power, and biofuels. However, the presence of high levels of tar in syngas poses challenges to the commercialization of biomass gasification technologies. This article provides a comprehensive overview of tar formation and elimination mechanisms, the adverse effects of tar, and tar analyzing techniques. It also summarizes the primary strategies for tar removal, including the impact of operation parameters, catalyst utilization, and reactor design on tar formation and elimination.

ENERGY CONVERSION AND MANAGEMENT (2023)

Article Energy & Fuels

Enhanced H2 production from steam gasification of biomass by red mud-doped Ca-Al-Ce bi-functional material

Xianyao Yan et al.

Summary: In this study, a red mud-doped Ca-Al-Ce bi-functional material was prepared to enhance H-2 production in the sorption-enhanced steam gasification of biomass. The addition of red mud significantly improved the performance of H-2 production, CO2 capture, and tar reduction.

APPLIED ENERGY (2022)

Article Thermodynamics

Porous coal char-based catalyst from coal gangue and lignite with high metal contents in the catalytic cracking of biomass tar

Shilin Du et al.

Summary: In this study, porous coal char-based catalysts were prepared using coal gangue and lignite with high metals content for biomass tar decomposition. The CO2 etching and metal exposure improved the catalysts' porosity, enhancing adsorption and contact with reactants. The coal gangue char prepared at 800 degrees C exhibited the highest catalytic activity. At a reforming temperature of 700 degrees C, CG-800 achieved a high tar conversion efficiency and total syngas yield.

ENERGY (2022)

Article Thermodynamics

A review of CaO based catalysts for tar removal during biomass gasification

Bin Li et al.

Summary: Tar is a major technical barrier for biomass gasification, but the use of CaO catalysts has been proven effective. This review examines the application of different types of CaO catalysts for tar removal and summarizes the tar cracking mechanism.

ENERGY (2022)

Article Environmental Sciences

Catalyst development for tar reduction in biomass gasification: Recent progress and the way forward

Ahmad Galadima et al.

Summary: The paper discusses the potential technology of biomass valorization through catalytic gasification, focusing on the removal of generated tar. It reports updates on catalyst development for tar reduction, covering various materials and their impact on reaction activity and stability. Further areas for investigation are also identified in the review.

JOURNAL OF ENVIRONMENTAL MANAGEMENT (2022)

Article Energy & Fuels

Construction of Fe embedded graphene nanoshell/carbon nanofibers catalyst for catalytic cracking of biomass tar: Effect of CO2 etching

Jiaxing Wang et al.

Summary: In this study, a carbon-based metal catalyst was prepared using sawdust as raw material, and Fe embedded graphene nanoshell/carbon nanofibers catalyst was prepared by impregnation and carbothermal reduction in CO2 atmosphere. During CO2 etching and FeCl3 catalysis, a structure was formed where carbon nanofibers/graphene shells wrapped metallic iron deposited on the porous carbon support.
Article Energy & Fuels

Iron-based catalyst (Fe2-xNixTiO5) for tar decomposition in biomass gasification

L. C. M. Ruivo et al.

Summary: The study found that the Fe2-xNixTiO5 catalyst showed high activity in converting model compounds at high temperatures, but the activity decreased with increased time on stream, possibly due to structural changes in iron active phases and sulfur chemisorption on the nickel surface.
Article Materials Science, Ceramics

Preparation of biphasic hydroxyapatite/β-tricalcium phosphate foam using the replication technique

Hamza Khallok et al.

CERAMICS INTERNATIONAL (2020)

Article Thermodynamics

Hybrid input-output analysis to evaluate economic impacts of biomass energy

Cholapat Jongdeepaisal et al.

INTERNATIONAL JOURNAL OF GREEN ENERGY (2020)

Article Chemistry, Applied

Catalytic gasification of biomass and coal blend with Fe2O3/olivine in a decoupled triple bed

Yue Pan et al.

FUEL PROCESSING TECHNOLOGY (2019)

Article Thermodynamics

Hydrogen production from cellulose catalytic gasification catalyst on CeO2/Fe2O3

Jun Zou et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

Article Chemistry, Physical

Promotional effects of Ce on Ni-Ce/gamma Al2O3 for enhancement of H-2 in hydrothermal gasification of biomass

Mohammad M. Hossain

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

Article Chemistry, Physical

Effects of calcination on silica phase transition in diatomite

Renji Zheng et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2018)

Article Materials Science, Ceramics

Preparation of porous ceramic membrane for gas-solid separation

Xinying Song et al.

CERAMICS INTERNATIONAL (2018)

Article Energy & Fuels

Utilization of NiO/porous ceramic monolithic catalyst for upgrading biomass fuel gas

Cui Quan et al.

JOURNAL OF THE ENERGY INSTITUTE (2018)

Article Thermodynamics

Hydrogen and syngas production by catalytic biomass gasification

W. X. Peng et al.

ENERGY CONVERSION AND MANAGEMENT (2017)

Article Chemistry, Applied

Catalytic decomposition of tar using iron supported biochar

James R. Kastner et al.

FUEL PROCESSING TECHNOLOGY (2015)

Article Chemistry, Physical

Surface silylation of natural mesoporous/macroporous diatomite for adsorption of benzene

Wenbin Yu et al.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2015)

Proceedings Paper Energy & Fuels

Biomass gasification plant and syngas clean-up system

P. De Filippis et al.

CLEAN, EFFICIENT AND AFFORDABLE ENERGY FOR A SUSTAINABLE FUTURE (2015)

Article Chemistry, Physical

Catalyst property of Co-Fe alloy particles in the steam reforming of biomass tar and toluene

Lei Wang et al.

APPLIED CATALYSIS B-ENVIRONMENTAL (2012)

Article Chemistry, Physical

Catalytic steam reforming of biomass tar over iron- or nickel-based catalyst supported on calcined scallop shell

Guoqing Guan et al.

APPLIED CATALYSIS B-ENVIRONMENTAL (2012)

Article Engineering, Chemical

Separation of particles from syngas at high-temperatures with an electrostatic precipitator

Audrey Villot et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2012)

Article Chemistry, Analytical

Th(IV) adsorption on mesoporous molecular sieves: effects of contact time, solid content, pH, ionic strength, foreign ions and temperature

Liming Zuo et al.

JOURNAL OF RADIOANALYTICAL AND NUCLEAR CHEMISTRY (2011)

Article Chemistry, Multidisciplinary

Toluene steam reforming as tar model molecule produced during biomass gasification with an iron/olivine catalyst

Mirella Virginie et al.

COMPTES RENDUS CHIMIE (2010)

Article Thermodynamics

Overview of recent advances in thermo-chemical conversion of biomass

Linghong Zhang et al.

ENERGY CONVERSION AND MANAGEMENT (2010)

Article Engineering, Chemical

Improvement in filtration characteristics of diatomite by calcination

Nezahat Ediz et al.

INTERNATIONAL JOURNAL OF MINERAL PROCESSING (2010)

Article Multidisciplinary Sciences

Diversity dynamics of marine planktonic diatoms across the Cenozoic

Daniel L. Rabosky et al.

NATURE (2009)

Article Chemistry, Physical

Adsorption of thorium(IV) on MX-80 bentonite: Effect of pH, ionic strength and temperature

D. L. Zhao et al.

APPLIED CLAY SCIENCE (2008)

Article Agricultural Engineering

Catalytic pyrolysis of Miscanthus x giganteus over activated alumina

Sait Yorgun et al.

BIORESOURCE TECHNOLOGY (2008)

Article Materials Science, Multidisciplinary

Synthesis of sodium zeolites from natural and modified diatomite

A Chaisena et al.

MATERIALS LETTERS (2005)

Article Chemistry, Applied

Tar removal from biomass-derived fuel gas by pulsed corona discharges

SA Nair et al.

FUEL PROCESSING TECHNOLOGY (2003)

Review Agricultural Engineering

A review of the primary measures for tar elimination in biomass gasification processes

L Devi et al.

BIOMASS & BIOENERGY (2003)