Journal
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T
Volume 23, Issue -, Pages 4334-4345Publisher
ELSEVIER
DOI: 10.1016/j.jmrt.2023.02.078
Keywords
Dynamic recrystallization; Severe plastic deformation; Microstructure; Strain rate; Stacking faults energy
Ask authors/readers for more resources
This study investigated the effects of stacking fault energy (SFE), temperature, strain, and strain rate on microstructural evolution and dynamic recrystallization (DRX) mechanism during linear friction welding (LFW) of face-centered cubic materials, specifically Al alloys (AA1050 and AA5052). The results showed that the temperature played a crucial role in the microstructural evolution, with high temperatures leading to continuous DRX and low temperatures resulting in discontinuous DRX. The grain structure and texture evolution depended on various parameters, with strains and strain rates dominating at temperatures above 0.5Tm and the SFE influencing at temperatures below 0.5Tm. Additionally, the Zener-Hollomon parameters of the Al alloy joints were investigated, and it was found that the AA5052 joints had a larger grain diameter than the AA1050 joints at lower Z values, but a smaller grain diameter at higher Z values. These differences were attributed to the lower SFE of AA5052, which promoted DRX and grain refinement during LFW.
Linear friction welding (LFW) was performed on face-centered cubic materials, that is, Al alloys (AA1050 and AA5052) with different stacking fault energies (SFEs). The pressure was controlled during the LFW to clarify the effects of temperature, strain, and strain rate on microstructural evolution and dynamic recrystallization (DRX) mechanism. The micro -structural evolution during DRX was mainly dependent on the temperature. The grain structures and textural evolution at high temperatures were governed by a continuous DRX, whereas those at low temperatures were primarily controlled by a discontinuous DRX. Various parameters determined the grain structure and textural evolution in different regimes. The evolution of grain structures and texture was dominated by strains and strain rates at temperatures above 0.5Tm (Tm: melting temperature) and by the SFE at tempera-tures below 0.5Tm. The Zener-Hollomon parameters of the Al alloy joints were investi-gated. It was found that the slope in AA5052 is larger than that in AA1050 during LFW. At a lower Z value, the grain diameter of the AA5052 joints was larger than that of the AA1050 joints, presumably because of the lower strain rate. Contrastingly, at a higher Z value, the grain diameter of the AA5052 joints was smaller than that of the AA1050 joints, even though the strain rates of the AA5052 joints were considerably lower than those of the AA1050 joints. These results were mainly attributed to the lower SFE of AA5052, which promoted DRX and grain refinement during the LFW. This report reveals the effects of SFE, temperature, strain, and strain rate on the DRX-induced microstructural evolutions during severe plastic deformation.(c) 2023 The Author(s). Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available