Related references
Note: Only part of the references are listed.Heterostructured materials
Yuntian Zhu et al.
PROGRESS IN MATERIALS SCIENCE (2023)
Superior strength-ductility combination in Al alloys via dislocation gradient structure
Feng Wang et al.
MATERIALS RESEARCH LETTERS (2023)
Prominent role of reversed austenite on corrosion property of super 13Cr martensitic stainless steel
Peng Wang et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2023)
Simultaneous improvement of strength and ductility in ZK60 magnesium alloy by constructing the bimodal grain structure
Peng Peng et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2023)
Simultaneously enhanced strength and ductility in graphene nanosheet/Al-Cu-Mg nano-laminated composites by incorporating coarse domains
Haoyu Teng et al.
MATERIALS RESEARCH LETTERS (2023)
High strength and high ductility achieved in a heterogeneous lamella-structured magnesium alloy
Tong Wang et al.
MATERIALS RESEARCH LETTERS (2023)
Activating dispersed strain bands in tensioned nanostructure layer for high ductility: The effects of microstructure inhomogeneity
Yanfei Wang et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2022)
In-situ investigation of plasticity in a Ti-Al-V-Fe (α plus β) alloy: Slip mechanisms, strain localization, and partitioning
Shaolou Wei et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2022)
Dual-phase hetero-structured strategy to improve ductility of a low carbon martensitic steel
J. X. Huang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)
Enhanced tensile properties by heterogeneous grain structures and coherent precipitates in a CoCrNi-based medium entropy alloy
Zihan Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)
Direct Atomic-Scale Observation of Ultrasmall Ag Nanowires that Exhibit fcc, bcc, and hcp Structures under Bending
Shiduo Sun et al.
PHYSICAL REVIEW LETTERS (2022)
Mechanical response of the constrained nanostructured layer in heterogeneous laminate
Yanfei Wang et al.
SCRIPTA MATERIALIA (2022)
Tracking the sliding of grain boundaries at the atomic scale
Lihua Wang et al.
SCIENCE (2022)
Harmonic structure, a promising microstructure design
Kei Ameyama et al.
MATERIALS RESEARCH LETTERS (2022)
The effect of vanadium content on hierarchical martensite structure and yield strength of petroleum casing steels
Huaying Li et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)
Strain hardening behavior and microstructure evolution of gradient-structured Cu-Al alloys with low stack fault energy
Huan Liu et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)
Strengthening and ductilization of laminate dual-phase steels with high martensite content
Bo Gao et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)
Heterostructured materials: superior properties from hetero-zone interaction
Yuntian Zhu et al.
MATERIALS RESEARCH LETTERS (2021)
Carbon redistribution in quenched and tempered lath martensite
L. Morsdorf et al.
ACTA MATERIALIA (2021)
Mesoscopic origin of damage nucleation in dual-phase steels
Ao Tang et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2021)
Revolutionizing car body manufacturing using a unified steel metallurgy concept
Qi Lu et al.
SCIENCE ADVANCES (2021)
Simultaneously improving strength and ductility through laminate structure design in Mg-8.0Gd-3.0Y-0.5Zr alloys
Jing Li et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)
Additive manufacturing of multi-scale heterostructured high-strength steels
Chaolin Tan et al.
MATERIALS RESEARCH LETTERS (2021)
Strain-hardening behavior and mechanisms of a lamellar-structured low-alloy TRIP steel
Tongliang Wang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Introduction to Heterostructured Materials: A Fast Emerging Field
Yuntian Zhu
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2021)
Dense dispersed shear bands in gradient-structured Ni
Yanfei Wang et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2020)
Evolution of microstructures, dislocation density and arrangement during deformation of low carbon lath martensitic steels
Md Shamsujjoha
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Simultaneously increased strength and ductility via the hierarchically heterogeneous structure of Al-Mg-Si alloys/nanocomposite
Run Geng et al.
MATERIALS RESEARCH LETTERS (2020)
Shear band stability and uniform elongation of gradient structured material: Role of lateral constraint
Yanfei Wang et al.
EXTREME MECHANICS LETTERS (2020)
Lognormal Distribution of Local Strain: A Universal Law of Plastic Deformation in Material
Ao Tang et al.
PHYSICAL REVIEW LETTERS (2020)
Effect of matrix carbon content and lath martensite microstructures on the tempered precipitates and impact toughness of a medium-carbon low-alloy steel
Chen Sun et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Influence of refined hierarchical martensitic microstructures on yield strength and impact toughness of ultra-high strength stainless steel
Haiwen Luo et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)
Improved properties of dual-phase steel via pre-intercritical annealing treatment and thermal cycling
Sajad Ghaemifar et al.
MATERIALS SCIENCE AND TECHNOLOGY (2020)
Recrystallization, grain growth and austenite formation in cold rolled steels during intercritical annealing
Okan Poyraz et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Ultrastrong low-carbon nanosteel produced by heterostructure and interstitial mediated warm rolling
Bo Gao et al.
SCIENCE ADVANCES (2020)
Perspective on hetero-deformation induced (HDI) hardening and back stress
Yuntian Zhu et al.
MATERIALS RESEARCH LETTERS (2019)
Effect of bainite morphology on deformation compatibility of mesostructure in ferrite/bainite dual-phase steel: Mesostructure-based finite element analysis
Zhong-tao Zhao et al.
MATERIALS & DESIGN (2019)
A high-strength heterogeneous structural dual-phase steel
Bo Gao et al.
JOURNAL OF MATERIALS SCIENCE (2019)
Correlation of ferrite and martensite micromechanical behavior with mechanical properties of ultrafine grained dual phase steels
Amir Hossein Jahanara et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Effect of volume fraction of bainite on strain hardening behavior and deformation mechanism of F/B multi-phase steel
C. J. Tang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Interface affected zone for optimal strength and ductility in heterogeneous laminate
C. X. Huang et al.
MATERIALS TODAY (2018)
Thermomechanical processing of advanced high strength steels
Jingwei Zhao et al.
PROGRESS IN MATERIALS SCIENCE (2018)
Refinement of Banded Structure via Thermal Cycling and Its Effects on Mechanical Properties of Dual Phase Steel
Sajad Ghaemifar et al.
STEEL RESEARCH INTERNATIONAL (2018)
Fine-grained dual phase steel via intercritical annealing of cold-rolled martensite
Mohammad Alibeyki et al.
VACUUM (2018)
A low-alloy high-carbon martensite steel with 2.6 GPa tensile strength and good ductility
Yingjun Wang et al.
ACTA MATERIALIA (2018)
Ductility and plasticity of nanostructured metals: differences and issues
Y. T. Zhu et al.
MATERIALS TODAY NANO (2018)
Effect of heavy warm rolling on microstructures and mechanical properties of AISI 4140 steel
Lifeng Lv et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Bauschinger Effect and Back Stress in Gradient Cu-Ge Alloy
Xianzhi Hu et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2017)
Heterogeneous materials: a new class of materials with unprecedented mechanical properties
Xiaolei Wu et al.
MATERIALS RESEARCH LETTERS (2017)
Coopetitive micro-mechanisms between recrystallization and transformation during/after dynamic strain-induced transformation in aluminum-containing low-carbon steel
Shih-Che Chen et al.
MATERIALS & DESIGN (2017)
Influence of martensite volume fraction and hardness on the plastic behavior of dual-phase steels: Experiments and micromechanical modeling
Qingquan Lai et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2016)
Correlation of microstructure and strain hardening behavior in the ultrafine-grained Nb-bearing dual phase steels
A. Ghatei Kalashami et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Effect of Prior Austenite Grain Size Refinement by Thermal Cycling on the Microstructural Features of As-Quenched Lath Martensite
Javier Hidalgo et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2016)
Mechanism of Austenite Formation from Spheroidized Microstructure in an Intermediate Fe-0.1C-3.5Mn Steel
Qingquan Lai et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2016)
Back stress strengthening and strain hardening in gradient structure
Muxin Yang et al.
MATERIALS RESEARCH LETTERS (2016)
Heterogeneous lamella structure unites ultrafine-grain strength with coarse-grain ductility
Xiaolei Wu et al.
PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2015)
Development of Ultrafine-Grained Dual-Phase Steels: Mechanism of Grain Refinement During Intercritical Deformation
Anish Karmakar et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2013)
Experimental and numerical study on geometrically necessary dislocations and non-homogeneous mechanical properties of the ferrite phase in dual phase steels
J. Kadkhodapour et al.
ACTA MATERIALIA (2011)
Study on the ferrite grain refinement during intercritical deformation of a microalloyed steel
B. Eghbali
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Strain Hardening Behavior of Dual-Phase Steels
V. Colla et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2009)
Deformation-induced ferrite transformation in a low carbon Nb-Ti microalloyed steel
B. Eghbali et al.
MATERIALS & DESIGN (2007)
Deformation induced ferrite transformation in low carbon steels
Han Dong et al.
CURRENT OPINION IN SOLID STATE & MATERIALS SCIENCE (2005)
Ultragrain refinement of plain low carbon steel by cold-rolling and annealing of martensite
R Ueji et al.
ACTA MATERIALIA (2002)
Plasticity at the micron scale
JW Hutchinson
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2000)