☆ 4.4 Article

Research on Parasitic Power of Cooling Balance of Plant System for Proton Exchange Membrane Fuel Cell

JOURNAL OF THERMAL SCIENCE AND ENGINEERING APPLICATIONS (2023)

Related references

Note: Only part of the references are listed.

Article Thermodynamics

A hybrid optimization strategy of electrical efficiency about cooling PEMFC combined with ultra-thin vapor chambers

Wentao Huang et al.

Summary: This paper proposes a hybrid optimization strategy to maximize the electrical efficiency of an open-cathode PEMFC combined with ultra-thin vapor chambers (UTVC). By establishing a dynamic model and integrating a neural network method with a meta-heuristic algorithm, the optimization results show that adjusting the power of the fan can improve the electrical efficiency of the PEMFC-UTVC.

ENERGY CONVERSION AND MANAGEMENT (2022)

Add to Collection

Article Thermodynamics

Enhancing heat dissipation to improve efficiency of two-stage electric air compressor for fuel cell vehicle

Donghai Hu et al.

Summary: The electric air compressor is a major energy-consuming component in a proton exchange membrane fuel cell, and improving its efficiency is crucial for energy saving. By enhancing the cooling effect of the electric air compressor, energy consumption can be reduced and efficiency can be increased.

ENERGY CONVERSION AND MANAGEMENT (2022)

Add to Collection

Review Green & Sustainable Science & Technology

Progress and perspectives of integrated thermal management systems in PEM fuel cell vehicles: A review

Jiamin Xu et al.

Summary: This paper reviews the design of integrated thermal management systems in proton exchange membrane fuel cell vehicles (PEMFCV), providing insights into control strategies. The factors affecting thermal performance are analyzed and future research directions and challenges are discussed. It is found that liquid cooling and heat pumps are suitable choices for the system.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2022)

Add to Collection

Article Energy & Fuels

Adaptive optimization strategy of air supply for automotive polymer electrolyte membrane fuel cell in life cycle

Zhichao Gong et al.

Summary: An adaptive optimization matching method is developed to maintain the high-efficiency operation of automotive polymer electrolyte membrane fuel cell (PEMFC) system. The system efficiency is optimized using genetic algorithm, and matching strategies for the compressor under different stack conditions are developed. It is found that the optimized method improves system efficiency.

APPLIED ENERGY (2022)

Add to Collection

Article Thermodynamics

Performance evaluation on thermodynamics-economy-environment of PEMFC vehicle power system under dynamic condition

Xi Chen et al.

Summary: In this paper, a vehicle PEMFC power system model is established to study the influence of auxiliary equipment energy consumption on fuel cell power system efficiency and total system cost. The mapping relationship between operating parameters and thermodynamic system performance is analyzed, and the results of system output and cost estimation are obtained.

ENERGY CONVERSION AND MANAGEMENT (2022)

Add to Collection

Article Thermodynamics

Investigation of optimal operating temperature for the PEMFC and its tracking control for energy saving in vehicle applications

Donghai Hu et al.

Summary: This paper investigates the impact of operating temperature on PEMFC efficiency, optimizing the temperature control of the PEMFC system to improve efficiency by decoupling the operating temperature from driving conditions. The study demonstrates significant increases in efficiency under optimal temperature tracking control compared to constant temperature control and traditional rule-based control.

ENERGY CONVERSION AND MANAGEMENT (2021)

Add to Collection

Article Thermodynamics

Investigating temperature-driven water transport in cathode gas diffusion media of PEMFC with a non-isothermal, two-phase model

Yiming Xu et al.

Summary: The study focuses on the impact of temperature distribution on water transport in proton exchange membrane fuel cells through phase-change-induced flow. A non-isothermal, two-phase model is used to investigate water transport in different layers of the fuel cell. The results show that adjusting operating temperature and humidity can optimize water management and enhance the proportion of phase-change-induced flow in the porous layers.

ENERGY CONVERSION AND MANAGEMENT (2021)

Add to Collection

Article Thermodynamics

4E analysis and multiobjective optimization of a PEMFC-based CCHP system with dehumidification

Junjie Zhao et al.

Summary: This paper proposes a novel PEMFC-based CCHP system with independent control of refrigeration and dehumidification for data centers. The effects of operating parameters on the 4E are investigated and multiobjective optimization is carried out. Results show that increasing inlet pressure and cooling water mass flow can improve system efficiency and reduce annual GHG emissions.

ENERGY CONVERSION AND MANAGEMENT (2021)

Add to Collection

Article Chemistry, Physical

Water distribution and performance variation in a transparent PEMFC with large active area

Biao Xiao et al.

Summary: The study investigated the effects of temperature, humidity, flow rate, and pressure on the performance of a proton exchange membrane fuel cell. It found that better cell performance and higher water distribution levels were observed with lower temperature, higher operation pressure, and higher humidity. The compensated voltages were determined to be very close under specific conditions.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Add to Collection

Article Thermodynamics

An innovative thermal management method for cooling loop of electric driving system for durable and high efficiency electric vehicle

Dongjun Li et al.

Summary: This paper introduces an innovative thermal management framework and control strategies for the cooling loop of electric drive. Experimental results demonstrate that this method shows significant advantages in improving temperature control of key components and pump efficiency in electric vehicles.

APPLIED THERMAL ENGINEERING (2021)

Add to Collection

Article Chemistry, Physical

Thermal analysis and management of proton exchange membrane fuel cell stacks for automotive vehicle

Lu Xing et al.

Summary: Thermal management is crucial for proton exchange membrane fuel cells in automotive vehicles. By theoretical analysis and case studies, controlling the cooling water flow rate and temperature is key to effectively meeting thermal management constraints.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Add to Collection

Article Chemistry, Physical

Automotive fuel cell stack and system efficiency and fuel consumption based on vehicle testing on a chassis dynamometer at minus 18 °C to positive 35 °C temperatures

Henning Lohse-Busch et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Add to Collection

Article Chemistry, Physical

Experimental and modelling studies of low temperature PEMFC performance

Sachin Chugh et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Add to Collection

Article Energy & Fuels

Thermal Management System Modeling and Simulation of a Full-Powered Fuel Cell Vehicle

Yiping Wang et al.

JOURNAL OF ENERGY RESOURCES TECHNOLOGY-TRANSACTIONS OF THE ASME (2020)

Add to Collection

Article Thermodynamics

Modelling and control of vehicle integrated thermal management system of PEM fuel cell vehicle

Jiamin Xu et al.

ENERGY (2020)

Add to Collection

Article Thermodynamics

Evaluation criterion of different flow field patterns in a proton exchange membrane fuel cell

Jun Shen et al.

ENERGY CONVERSION AND MANAGEMENT (2020)

Add to Collection

Article Thermodynamics

A novel radiator structure for enhanced heat transfer used in PEM fuel cell vehicle

Chengyuan Gonga et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)

Add to Collection

Article Energy & Fuels

Three-dimensional simulation of a new cooling strategy for proton exchange membrane fuel cell stack using a non-isothermal multiphase model

Guobin Zhang et al.

APPLIED ENERGY (2019)

Add to Collection

Review Chemistry, Applied

Progress on design and development of polymer electrolyte membrane fuel cell systems for vehicle applications: A review

Guangjin Wang et al.

FUEL PROCESSING TECHNOLOGY (2018)

Add to Collection

Article Engineering, Multidisciplinary

Dynamic Time-Delay Characteristics and Structural Optimization Design of Marine Gas Turbine Intercooler

Ning-bo Zhao et al.

MATHEMATICAL PROBLEMS IN ENGINEERING (2014)

Add to Collection

Article Chemistry, Physical

Modeling and simulation of proton exchange membrane fuel cell systems

Abdellah Beicha

JOURNAL OF POWER SOURCES (2012)

Add to Collection

Article Energy & Fuels

A high-flexibility DC load for fuel cell and solar arrays power sources based on DC-DC converters

E. Duran et al.

APPLIED ENERGY (2011)

Add to Collection

Review Energy & Fuels

A review of polymer electrolyte membrane fuel cells: Technology, applications, and needs on fundamental research

Yun Wang et al.

APPLIED ENERGY (2011)

Add to Collection

Article Chemistry, Physical

A chaotic heat-exchanger for PEMFC cooling applications

Y Lasbet et al.

JOURNAL OF POWER SOURCES (2006)

Add to Collection

Article Electrochemistry

Modelling and analysis of electrochemical, thermal, and reactant flow dynamics for a PEM fuel cell system

MJ Khan et al.

FUEL CELLS (2005)

Add to Collection

Article Green & Sustainable Science & Technology

A new dynamic model for predicting transient phenomena in a PEM fuel cell system

PR Pathapati et al.

RENEWABLE ENERGY (2005)

Add to Collection

© Peeref 2019-2024. All rights reserved.