☆ 4.5 Article

Insight into the FCC→HCP Transformation in Co-Rich Co-Cr-Fe-Mn-Ni High-Entropy Alloys

METALS (2023)

Related references

Note: Only part of the references are listed.

Article Chemistry, Physical

High deformation ability induced by phase transformation through adjusting Cr content in Co-Fe-Ni-Cr high entropy alloys

Xuefeng Gao et al.

Summary: The study revealed significant changes in phase transformation and mechanical properties of high entropy alloys as the chromium content increases. With the increase of chromium content, the volume fractions of HCP and sigma phases increase, leading to an increase in yield strength, but the increase in sigma phase reduces the ductility of the material.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Effects of Cr/Ni ratio on physical properties of Cr-Mn-Fe-Co-Ni high-entropy alloys

Christian Wagner et al.

Summary: The physical properties of ten single-phase FCC CrxMn20Fe20Co20Ni40-x high-entropy alloys were investigated. The lattice parameters of the alloys were nearly independent of composition, while the solidus temperatures increased linearly with increasing Cr content. The alloys did not exhibit ferromagnetism in a certain temperature range, and the temperature dependencies of their coefficients of thermal expansion and elastic moduli were independent of composition. Ab initio simulations qualitatively reproduced the magnetic transitions and magnetostriction observed in the alloys. The plastic deformation of the alloys was found to occur initially by the glide of perfect dislocations on {111} planes. The stacking fault energy (SFE) was determined and found to decrease with increasing Cr content. However, the calculated intrinsic SFEs were lower than the experimental values. The ab initio simulations showed that atomic relaxations, finite temperatures, and magnetism strongly influenced the intrinsic SFE.

ACTA MATERIALIA (2022)

Add to Collection

Article Chemistry, Physical

Thermodynamics-based design strategy for optimizing strength and ductility of Cr-Ni-Mn-Fe medium-entropy alloys

D. H. Chung et al.

Summary: In this study, a series of novel medium-entropy alloys (MEAs) were developed based on a thermodynamic approach, and one of the alloys was found to exhibit excellent strength and ductility at cryogenic temperatures. Experimental assessment and thermodynamic modeling quantitatively demonstrated the strength-ductility synergy derived from the interplay among plasticity mechanisms. Additionally, a model was proposed for evaluating the stacking fault energy of the alloys.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Effects of vacuum annealing on the phase constituents and mechanical properties of the AlxCrFeMn2-xNi multiprincipal component alloys

Changjun Wu et al.

Summary: The development of Co-free AlxCrFeMn2-xNi MPCAs is of great significance. The presence of L2(1)-Ni2MnAl phase and B2 phase contribute to the alloy hardness. A phase transformation of BCC phase to α phase occurs after 800 degrees C annealing, resulting in increased hardness and reduced ductility. The decomposition temperature of the sigma phase decreases with increasing Al content.

VACUUM (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Eutectic Reaction and Microstructure Stability in CoCrFeNiNbx High-Entropy Alloys

Xu Cao et al.

Summary: This study experimentally and thermodynamically investigates seven arc-melted and annealed CoCrFeNiNbx (x = 0.3-0.6) alloys. The microstructure of the alloys is found to be significantly affected by cooling rate and annealing treatment. A method of strengthening the alloy by precipitating a T phase is proposed.

METALS (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Phase Stability and Mechanical Properties Analysis of AlCoxCrFeNi HEAs Based on First Principles

Fu Liang et al.

Summary: Through computer simulation methods, this research found that AlCoxCrFeNi HEAs have the best hardness and toughness properties with a Co content of 0.5, providing theoretical guidance for the preparation of HEAs with optimal mechanical properties.

METALS (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Plastic deformation of single crystals of the equiatomic Cr-Mn-Fe-Co-Ni high-entropy alloy in tension and compression from 10 K to 1273 K

Marino Kawamura et al.

Summary: The plastic deformation behavior of single crystals of the Cr-Mn-Fe-Co-Ni high-entropy alloy has been studied at different temperatures, showing sensitivity to strain rate, temperature, and crystal orientation. Solid-solution hardening is identified as the main strengthening mechanism, with deformation twinning occurring at low temperatures, impacting the material's tensile properties.

ACTA MATERIALIA (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Phase transformation and microstructure evolution in ultrahard carbon-doped AlTiFeCoNi high-entropy alloy by high-pressure torsion

Parisa Edalati et al.

Summary: By introducing an FCC carbide into a BCC-based AlTiFeCoNi alloy with the assistance of CALPHAD thermodynamic calculations, an ultrahard HEA was produced and processed through severe plastic deformation via the high-pressure torsion method, resulting in nanograin formation, dislocation accumulation, carbide fragmentation, L21 -> BCC ordered-to-disordered phase transformation, and achieving an ultrahigh hardness of 950 Hv.

MATERIALS LETTERS (2021)

Add to Collection

Article Chemistry, Physical

Stability and Thermodynamics Properties of CrFeNiCoMn/Pd High Entropy Alloys from First Principles

Nguyen-Dung Tran et al.

Summary: This study calculates the structural, electronic structure, and thermodynamic properties of quinary CrFeCoNiMn and CrFeCoNiPd high-entropy alloys (HEA) using DFT-based approaches. The comparison between Mn- and Pd-HEAs in equiatomic and non-equiatomic compositions reveals that their stability at different temperatures is governed by different mechanisms. This explains the spatial fluctuations in atomic fraction observed in experiments, with a wider range in Pd-HEA compared to Mn-HEA.

JOURNAL OF PHASE EQUILIBRIA AND DIFFUSION (2021)

Add to Collection

Article Multidisciplinary Sciences

Hierarchical crack buffering triples ductility in eutectic herringbone high-entropy alloys

Peijian Shi et al.

Summary: The study demonstrates a directionally solidified eutectic high-entropy alloy with a hierarchically organized herringbone structure that reconciles crack tolerance and high elongation. The self-buffering herringbone material achieves an ultrahigh uniform tensile elongation while maintaining strength.

SCIENCE (2021)

Add to Collection

Article Materials Science, Multidisciplinary

First principle calculation of the effect of Cr, Ti content on the properties of VMoNbTaWMx (M = Cr, Ti) refractory high entropy alloy

Yu Gao et al.

VACUUM (2020)

Add to Collection

Article Nanoscience & Nanotechnology

Novel Co-rich high performance twinning-induced plasticity (TWIP) and transformation-induced plasticity (TRIP) high-entropy alloys

Daixiu Wei et al.

SCRIPTA MATERIALIA (2019)

Add to Collection

Article Chemistry, Physical

Effect of Long-Time Annealing at 1000 °C on Phase Constituent and Microhardness of the 20Co-Cr-Fe-Ni Alloys

Changjun Wu et al.

MATERIALS (2019)

Add to Collection

Article Chemistry, Physical

Phase stability and microhardness of CoCrFeMnxNi2-x high entropy alloys

Mengyun Tian et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Microstructure and mechanical properties of Cr-rich Co-Cr-Fe-Ni high entropy alloys designed by valence electron concentration

Wei Fang et al.

MATERIALS CHEMISTRY AND PHYSICS (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Novel Co-rich high entropy alloys with superior tensile properties

Daixiu Wei et al.

MATERIALS RESEARCH LETTERS (2019)

Add to Collection

Article Materials Science, Multidisciplinary

Twinning-induced plasticity (TWIP) steels

Bruno C. De Cooman et al.

ACTA MATERIALIA (2018)

Add to Collection

Article Materials Science, Multidisciplinary

Database development and Calphad calculations for high entropy alloys: Challenges, strategies, and tips

Hai-Lin Chen et al.

MATERIALS CHEMISTRY AND PHYSICS (2018)

Add to Collection

Article Materials Science, Multidisciplinary

Transformation Induced Plasticity Effects of a Non-Equal Molar Co-Cr-Fe-Ni High Entropy Alloy System

Wei Fang et al.

METALS (2018)

Add to Collection

Article Multidisciplinary Sciences

First-principles investigation of the micromechanical properties of fcc-hcp polymorphic high-entropy alloys

Xiaoqing Li et al.

SCIENTIFIC REPORTS (2018)

Add to Collection

Article Chemistry, Physical

An ab initio and experimental studies of the structure, mechanical parameters and state density on the refractory high-entropy alloy systems

Yongkun Mu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2017)

Add to Collection

Article Materials Science, Multidisciplinary

DFT study of the hexagonal high-entropy alloy fission product system

D. J. M. King et al.

JOURNAL OF NUCLEAR MATERIALS (2017)

Add to Collection

Review Materials Science, Multidisciplinary

A Review of Solid-Solution Models of High-Entropy Alloys Based on Ab lnitio Calculations

Fuyang Tian

FRONTIERS IN MATERIALS (2017)

Add to Collection

Article Materials Science, Multidisciplinary

The fcc solid solution stability in the Co-Cr-Fe-Mn-Ni multi-component system

Guillaume Bracq et al.

ACTA MATERIALIA (2017)

Add to Collection

Article Physics, Applied

Pressure-induced fcc to hcp phase transition in Ni-based high entropy solid solution alloys

F. X. Zhang et al.

APPLIED PHYSICS LETTERS (2017)

Add to Collection

Article Materials Science, Multidisciplinary

From high entropy alloys to diluted multi-component alloys: Range of existence of a solid-solution

Mathilde Laurent-Brocq et al.

MATERIALS & DESIGN (2016)

Add to Collection

Article Materials Science, Multidisciplinary

Mechanical properties, microstructure and thermal stability of a nanocrystalline CoCrFeMnNi high-entropy alloy after severe plastic deformation

B. Schuh et al.

ACTA MATERIALIA (2015)

Add to Collection

Article Nanoscience & Nanotechnology

Non-equiatomic high entropy alloys: Approach towards rapid alloy screening and property-oriented design

K. G. Pradeep et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)

Add to Collection

Article Multidisciplinary Sciences

Deviation from high-entropy configurations in the atomic distributions of a multi-principal-element alloy

Louis J. Santodonato et al.

NATURE COMMUNICATIONS (2015)

Add to Collection

Article Materials Science, Multidisciplinary

A Novel Low-Density, High-Hardness, High-entropy Alloy with Close-packed Single-phase Nanocrystalline Structures

Khaled M. Youssef et al.

MATERIALS RESEARCH LETTERS (2015)

Add to Collection

Article Materials Science, Multidisciplinary

Effect of aluminum on the microstructure and properties of two refractory high-entropy alloys

O. N. Senkov et al.

ACTA MATERIALIA (2014)

Add to Collection

Article Multidisciplinary Sciences

A fracture-resistant high-entropy alloy for cryogenic applications

Bernd Gludovatz et al.

SCIENCE (2014)

Add to Collection

Article Materials Science, Multidisciplinary

Sluggish diffusion in Co-Cr-Fe-Mn-Ni high-entropy alloys

K. -Y. Tsai et al.

ACTA MATERIALIA (2013)

Add to Collection

Article Materials Science, Multidisciplinary

Alloy Design Strategies and Future Trends in High-Entropy Alloys

Jien-Wei Yeh

JOM (2013)

Add to Collection

Article Physics, Applied

Effect of valence electron concentration on stability of fcc or bcc phase in high entropy alloys

Sheng Guo et al.

JOURNAL OF APPLIED PHYSICS (2011)

Add to Collection

Article Nanoscience & Nanotechnology

Microstructural development in equiatomic multicomponent alloys

B Cantor et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)

Add to Collection

Article Materials Science, Multidisciplinary

Virtual crystal approximation revisited: Application to dielectric and piezoelectric properties of perovskites

L Bellaiche et al.

PHYSICAL REVIEW B (2000)

Add to Collection

© Peeref 2019-2024. All rights reserved.