Related references
Note: Only part of the references are listed.Experimental and computational analysis of the coolant distribution considering the viscosity of the cutting fluid during machining with helical deep hole drills
Ekrem Oezkaya et al.
ADVANCES IN MANUFACTURING (2022)
Multi-Objective Optimization in Single-Shot Drilling of CFRP/Al Stacks Using Customized Twist Drill
Muhammad Hafiz Hassan et al.
MATERIALS (2022)
Research on ultrasonic-assisted drilling in micro-hole machining of the DD6 superalloy
Xiao-Xiang Zhu et al.
ADVANCES IN MANUFACTURING (2020)
Variation characteristic of drilling force and influence of cutting parameter of SiCp/Al composite thin-walled workpiece
Shu-Tao Huang et al.
ADVANCES IN MANUFACTURING (2019)
Effect of Cold Rolling on Microstructure and Mechanical Properties of AISI 304N Stainless Steel
Xiao Li et al.
2018 4TH INTERNATIONAL CONFERENCE ON ENVIRONMENTAL SCIENCE AND MATERIAL APPLICATION (2019)
Investigation the Effect of Point Angle While Drilling Titanium
G. Yuvaraj et al.
MATERIALS TODAY-PROCEEDINGS (2019)
3D numerical analysis of drilling process: heat, wear, and built-up edge
Mohammad Lotfi et al.
ADVANCES IN MANUFACTURING (2018)
An experimental investigation of the effects of point angle on the high-speed steel drills performance in drilling
Zulkuf Demir
MEASUREMENT & CONTROL (2018)
Tool geometry based prediction of critical thrust force while drilling carbon fiber reinforced polymers
Y. Karpat et al.
ADVANCES IN MANUFACTURING (2015)
Effect of Machining Parameters on Tool Wear and Hole Quality of AISI 316L Stainless Steel in Conventional Drilling
A. Z. Sultan et al.
2ND INTERNATIONAL MATERIALS, INDUSTRIAL, AND MANUFACTURING ENGINEERING CONFERENCE, MIMEC2015 (2015)
Effect of Drill Point Angle on Surface Integrity when Drilling Titanium Alloy
Muhamad Nasir Murad et al.
MATERIALS, INDUSTRIAL, AND MANUFACTURING ENGINEERING RESEARCH ADVANCES 1.1 (2014)
Effects of geometric structure of twist drill bits and cutting condition on tool life in drilling 42CrMo ultrahigh-strength steel
Xiangyu Wang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
Wear mechanisms analysis for turning Ti-6Al-4V-towards the development of suitable tool coatings
Syed H. Imran Jaffery et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Work-hardening in the drilling of austenitic stainless steels
S Dolinsek
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)
Share Paper
