☆ 4.7 Article

Monotonic and cyclic undrained behaviour and liquefaction resistance of pumiceous, non-plastic sandy silt

SOIL DYNAMICS AND EARTHQUAKE ENGINEERING (2023)

Related references

Note: Only part of the references are listed.

Article Engineering, Geological

Test method for minimum and maximum densities of small quantities of soil

Zorana Mijic et al.

Summary: Determining the relative density of sandy soil requires establishing the minimum and maximum void ratios. An alternative test method was proposed for cases where the standard-size mold cannot be used due to insufficient material from small undisturbed test specimens. The results showed good agreement between the minimum and maximum void ratios determined by both the standard and alternative methods for composite soil, with consistent trends compared to previous studies.

SOILS AND FOUNDATIONS (2021)

Add to Collection

Article Engineering, Environmental

Cone penetration tests in dry and saturated Ticino sand

Max O. Kluger et al.

Summary: Studies suggest that dry and saturated sands generally exhibit similar cone resistance-relative density relationships, but factors such as partial saturation and fines content may affect these relationships. Experimental evidence shows that clean uncemented quartz sand may have lower cone resistance in saturated conditions.

BULLETIN OF ENGINEERING GEOLOGY AND THE ENVIRONMENT (2021)

Add to Collection

Article Engineering, Geological

Reconnaissance report on geotechnical damage caused by 2018 Hokkaido Eastern Iburi earthquake with JMA seismic intensity 7

Tatsuya Ishikawa et al.

Summary: The 2018 Hokkaido Eastern Iburi earthquake led to various types of geo-disasters in Hokkaido, prompting the Japanese Geotechnical Society to organize an expert team to investigate and provide academic advice on disaster recovery and prevention.

SOILS AND FOUNDATIONS (2021)

Add to Collection

Article Engineering, Geological

Maximum dry density test to quantify pumice content in natural soils

M. S. Asadi et al.

SOILS AND FOUNDATIONS (2019)

Add to Collection

Article Engineering, Geological

Microstructural factors affecting the static and the cyclic resistance of a pyroclastic silty sand

V. Licata et al.

GEOTECHNIQUE (2018)

Add to Collection

Article Engineering, Geological

Undrained Cyclic Behavior of Reconstituted Natural Pumiceous Sands

Mohammad Sadeq Asadi et al.

JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2018)

Add to Collection

Article Engineering, Geological

Preparation of Uniform Sand Specimens Using Stationary Pluviation and Vibratory Methods

Chennarapu Hariprasad et al.

GEOTECHNICAL AND GEOLOGICAL ENGINEERING (2016)

Add to Collection

Article Engineering, Geological

Mechanical Behavior of Clean Sand at Low Confining Pressure: Verification with Element and Model Tests

Y. Huang et al.

JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2015)

Add to Collection

Article Engineering, Geological

Observations on microstructure of pumice particles using computed tomography

Naotaka Kikkawa et al.

CANADIAN GEOTECHNICAL JOURNAL (2013)

Add to Collection

Review Geography, Physical

Tephrochronology and its application: A review

David J. Lowe

QUATERNARY GEOCHRONOLOGY (2011)

Add to Collection

Article Engineering, Geological

GEOTECHNICAL ASPECTS OF THE 22 FEBRUARY 2011 CHRISTCHURCH EARTHQUAKE

Misko Cubrinovski et al.

BULLETIN OF THE NEW ZEALAND SOCIETY FOR EARTHQUAKE ENGINEERING (2011)

Add to Collection

Article Engineering, Geological

Modified state parameter for characterizing static liquefaction of sand with fines

D. C. Bobei et al.

CANADIAN GEOTECHNICAL JOURNAL (2009)

Add to Collection

Article Engineering, Geological

Pore Pressure Generation of Silty Sands due to Induced Cyclic Shear Strains

Kenan Hazirbaba et al.

JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2009)

Add to Collection

Article Engineering, Geological

Liquefaction Resistance of Sandy Soils under Partially Drained Condition

Yoichi Yamamoto et al.

JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2009)

Add to Collection

Article Engineering, Geological

Undrained Cyclic Pore Pressure Response of Sand-Silt Mixtures: Effect of Nonplastic Fines and Other Parameters

H. Dash et al.

GEOTECHNICAL AND GEOLOGICAL ENGINEERING (2009)

Add to Collection

Article Engineering, Mechanical

Failure and dilatancy properties of sand at relatively low stresses

Laurent Lancelot et al.

JOURNAL OF ENGINEERING MECHANICS-ASCE (2006)

Add to Collection

Article Engineering, Geological

Liquefaction susceptibility criteria for silts and clays

Ross W. Boulanger et al.

JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2006)

Add to Collection

Article Geology

Primary volcaniclastic rocks

J. D. L. White et al.

GEOLOGY (2006)

Add to Collection

Article Engineering, Geological

Flow deformation of liquefied sand under constant shear load and its application to analysis of flow slide of infinite slope

M Yoshimine et al.

SOIL DYNAMICS AND EARTHQUAKE ENGINEERING (2006)

Add to Collection

Article Engineering, Geological

Shear strength of cohesionless soils at low stress

RJ Fannin et al.

GEOTECHNIQUE (2005)

Add to Collection

Article Engineering, Geological

Maximum and minimum void ratio characteristics of sands

M Cubrinovski et al.

SOILS AND FOUNDATIONS (2002)

Add to Collection

Article Engineering, Geological

Undrained fragility of clean sands, silty sands, and sandy silts

S Thevanayagam et al.

JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING (2002)

Add to Collection

Article Engineering, Geological

Geotechnical aspects of the January 13, 2001 El Salvador earthquake

R Orense et al.

SOILS AND FOUNDATIONS (2002)

Add to Collection

Review Engineering, Geological

Earthquake-induced landslides in central America

JJ Bommer et al.

ENGINEERING GEOLOGY (2002)

Add to Collection

© Peeref 2019-2024. All rights reserved.