4.8 Article

Numerical analysis and optimization of a novel photovoltaic thermal solar unit improved by Nano-PCM as an energy storage media and finned collector

Related references

Note: Only part of the references are listed.
Article Green & Sustainable Science & Technology

An experimental and numerical study on the impact of various parameters in improving the heat transfer performance characteristics of a water based photovoltaic thermal system

Atazaz Hassan et al.

Summary: This study investigates the improvement of heat transfer performance in a photovoltaic thermal system through numerical and experimental research. The water-based PV/T system exhibits the highest average thermal, electrical, and overall efficiencies of 44.5%, 14.8%, and 59.3% respectively. The thermal and electrical efficiencies of the PV/T system increase with higher Reynolds numbers. Increasing tube diameters and decreasing backplate thickness result in a significant decrease in cell temperature. The experimental and numerical findings are in good agreement, with a maximum relative error of 3.96%.

RENEWABLE ENERGY (2023)

Article Energy & Fuels

Multi-aspect analysis and RSM-based optimization of a novel dual-source electricity and cooling cogeneration system

Saeid Azizi et al.

Summary: This work proposes a novel cogeneration system using geothermal and natural gas dual-sources for sustainable development and environmental protection. Performance investigation and optimization were conducted using various analyses and algorithms. The findings showed the highest exergy destruction in the combustion chamber and the profitability of the system after a certain period of operation.

APPLIED ENERGY (2023)

Article Thermodynamics

Heat transfer efficiency and electrical performance evaluation of photovoltaic unit under influence of NEPCM

Mohammadjavad Khodadadi et al.

Summary: In this study, the design of a PVT unit with phase change material (PCM) is analyzed to assess its efficiency under different concentrations of nanofluids and non-encapsulated phase change materials (NEPCMs). The effects of flow rates, solar radiation intensities, and multilayers of PCMs are also evaluated. Furthermore, a comparison study is conducted to assess the impact of integrating a thermoelectric (TE) module with the PVT system. The simulation is performed using the enthalpy-porosity approach and a transient solver with a pressure-based finite volume method. The results show that increasing the flow rate of coolant and the concentration of NEPCM can enhance the charging rate but may slightly decrease the temperature.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

Article Green & Sustainable Science & Technology

PV temperature and performance prediction in free-standing, BIPV and BAPV incorporating the effect of temperature and inclination on the heat transfer coefficients and the impact of wind, efficiency and ageing

S. Kaplanis et al.

Summary: A novel compact model is developed to predict PV temperature, in-plane solar irradiance, and power output with high accuracy. The model shows small relative errors for tracking and BIPV systems, taking into account various influencing factors.

RENEWABLE ENERGY (2022)

Article Energy & Fuels

Analysis of the effects of porous media parameters and inclination angle on the thermal storage and efficiency improvement of a photovoltaic-phase change material system

Nazanin Variji et al.

Summary: The application of phase change materials (PCM) can improve the electrical efficiency of PV panels, but their low thermal conductivity is a disadvantage. This study investigates the use of metal foam insertion to enhance heat transfer, and the results show that inserting metal foam with a porosity of 0.9 can increase the average temperature and electrical efficiency of the system by 6.8% and 9.8% respectively.

JOURNAL OF ENERGY STORAGE (2022)

Article Energy & Fuels

Utilization of a phase change material with metal foam for the performance improvement of the photovoltaic cells

Hamid Shakibi et al.

Summary: This study presents a novel configuration for improving the thermal management system of photovoltaic panels using phase change materials and metal foam layers. Numerical simulations and analysis were conducted to investigate the effects of different factors on the system's performance. The results demonstrate that the proposed system has superior thermal management capabilities.

JOURNAL OF ENERGY STORAGE (2022)

Review Green & Sustainable Science & Technology

An updated review of the performance of nanofluid-based photovoltaic thermal systems from energy, exergy, economic, and environmental (4E) approaches

Ali Salari et al.

Summary: The PVTS system can provide both electricity and thermal energy. The utilization of nanofluids can enhance the efficiency of the PVTS system, leading to reduced CO2 emissions and energy savings.

JOURNAL OF CLEANER PRODUCTION (2021)

Article Automation & Control Systems

A multi-objective bat algorithm with a novel competitive mechanism and its application in controller tuning

Hu Li et al.

Summary: A competitive mechanism-based multi-objective bat algorithm is proposed to balance convergence and diversity by adaptively complementing multiple evolution strategies. Through experiments, the algorithm outperforms 12 state-of-the-art algorithms on benchmark functions and demonstrates effectiveness and practicality in real-life multi-objective optimization problems.

ENGINEERING APPLICATIONS OF ARTIFICIAL INTELLIGENCE (2021)

Article Green & Sustainable Science & Technology

Performance improvement of a PVT system using a multilayer structural heat exchanger with PCMs

Zaiguo Fu et al.

Summary: This study investigates the performance of a multilayer-structured PVT system with PCMs through experimental and numerical methods. The results show that using a heat exchanger with PCMs can improve the electrical efficiency of the PVT system, while prolonged operation time can increase thermal efficiency. A composite PCM with 15% expanded graphite can enhance the comprehensive efficiency by 25.2%.

RENEWABLE ENERGY (2021)

Article Energy & Fuels

Passive/active photovoltaic-thermal (PVT) system implementing infiltrated phase change material (PCM) in PS-CNT foam

Rouhollah Ahmadi et al.

Summary: The study conducted various cooling experiments on PV cells, revealing the impacts of both Passive PCM-composite and Active water-cooling systems on the performance of PVT systems. Results showed that PCM-composite system can significantly reduce PV-cell temperature and increase electrical efficiency, while the water-cooling system performs better in terms of both power generation and thermal energy harvesting.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2021)

Article Thermodynamics

Experimental investigation on the enhanced performance of a solar PVT system using micro-encapsulated PCMs

Zaiguo Fu et al.

Summary: This study investigated the performance of a photovoltaic-thermal (PVT) solar system using MPCM slurry as the cooling medium. Results showed that using MPCM slurry can improve the thermal and electrical efficiency of the system compared to using tap water or a system with a PCM layer. The study demonstrated the feasibility of enhancing performance in solar PVT systems by utilizing MPCM slurry.

ENERGY (2021)

Article Green & Sustainable Science & Technology

Experimental evaluation of a hybrid photovoltaic and thermal solar energy collector with integrated phase change material (PVT-PCM) in comparison with a traditional photovoltaic (PV) module

Mauricio Carmona et al.

Summary: A novel thermal energy storage and recovery system was proposed to improve the overall efficiency of solar energy collectors by integrating a phase change material in a hybrid module. Experimental comparisons showed that the daily electrical efficiency of the hybrid PVT-PCM module increased by 7.43% compared to the traditional PV module, resulting in a total increase of 20.45% in the capability to extract useful energy from the sun.

RENEWABLE ENERGY (2021)

Article Green & Sustainable Science & Technology

Dynamic simulation and exergetic optimization of a Concentrating Photovoltaic/ Thermal (CPVT) system

I. K. Karathanassis et al.

RENEWABLE ENERGY (2019)

Article Green & Sustainable Science & Technology

Exergy performance assessment of a linear parabolic trough photovoltaic thermal collector

Mohammad Valizadeh et al.

RENEWABLE ENERGY (2019)

Article Thermodynamics

The photovoltaic-thermal system parameter optimization design and practical verification

Chung-Feng Jeffrey Kuo et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

Article Thermodynamics

Performance assessment of novel photovoltaic thermal system using nanoparticle in phase change material

Alper Ergun et al.

INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW (2019)

Review Green & Sustainable Science & Technology

Photovoltaic panel integrated with phase change materials (PV-PCM): technology overview and materials selection

Tao Ma et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2019)

Article Green & Sustainable Science & Technology

Numerical and experimental investigation of the effect of operating conditions on performance of PVT and PVT-PCM

H. Fayaz et al.

RENEWABLE ENERGY (2019)

Review Green & Sustainable Science & Technology

Novel approaches and recent developments on potential applications of phase change materials in solar energy

A. K. Pandey et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2018)

Article Construction & Building Technology

Maximizing the energy output of a photovoltaic-thermal solar collector incorporating phase change materials

Di Su et al.

ENERGY AND BUILDINGS (2017)

Article Thermodynamics

Evaluation of the nanofluid and nano-PCM based photovoltaic thermal (PVT) system: An experimental study

Ali H. A. Al-Waeli et al.

ENERGY CONVERSION AND MANAGEMENT (2017)

Article Green & Sustainable Science & Technology

Design, simulation and experimental characterization of a novel parabolic trough hybrid solar photovoltaic/thermal (PV/T) collector

Bennett K. Widyolar et al.

RENEWABLE ENERGY (2017)

Article Energy & Fuels

Heat retention of a photovoltaic/thermal collector with PCM

Maria C. Browne et al.

SOLAR ENERGY (2016)

Review Thermodynamics

A review of entropy generation in nanofluid flow

Omid Mahian et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2013)

Article Thermodynamics

Numerical investigations of unconstrained melting of nano-enhanced phase change material (NEPCM) inside a spherical container

S. F. Hosseinizadeh et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2012)

Article Green & Sustainable Science & Technology

Validation of CFD simulation for flat plate solar energy collector

Mohamed Selmi et al.

RENEWABLE ENERGY (2008)