☆ 4.5 Article

Penetration Behavior of CaO-SiO2-FeOx-MgO-(CaCl2) Slags in MgO Refractory

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2023)

Related references

Note: Only part of the references are listed.

Article Materials Science, Multidisciplinary

Initial Wetting Phenomena of MgO-SiO2 Liquid Slag on MgO-C Refractories

Seungwon Jeon et al.

Summary: The initial wetting phenomena of MgO-SiO2 slag on MgO-C refractories were studied using the dispensed drop technique at 1873 K. As the carbon content increased, the apparent contact angle and height increased, whereas the apparent radius decreased. Reduced Si was observed at the boundary between the slag and the refractories.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2023)

Add to Collection

Article Materials Science, Ceramics

Interfacial reactions between magnesia refractory and electric arc furnace (EAF) slag with use of direct reduced iron (DRI) as raw material

Jungho Heo et al.

Summary: The study found that as the DRI content increases, the thickness and dissolution depth of the MW intermediate layer increase, but the penetrability decreases. Proper control of DRI content is crucial for reducing degradation of refractory materials.

CERAMICS INTERNATIONAL (2022)

Add to Collection

Article Materials Science, Ceramics

Wetting and corrosion behavior of MgO substrates by CaO-Al2O3-SiO2-(MgO) molten slags

Yigui Lao et al.

Summary: The wetting and corrosion characteristics of refractory by molten slag are important for understanding the corrosion mechanism and slag resistance. The study found that microporous magnesia aggregate has better slag resistance compared to fused magnesia. Slags with higher CaO/SiO2 value and MgO content have a greater ability to slow down the dissolution of refractory substrate. Surface tension and viscosity have a more significant impact on slag penetration than contact angle.

CERAMICS INTERNATIONAL (2022)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Dephosphorisation behaviour of BOF crude steel using CaO-based flux

Zhiyin Deng et al.

Summary: Research has shown that using a CaO-based flux for dephosphorisation in the BOF converter during steel tapping has a unique mechanism, with relatively low efficiency when using pure CaO, necessitating the addition of suitable amounts of SiO2 and FeOx to improve dephosphorisation efficiency.

IRONMAKING & STEELMAKING (2022)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Wetting and corrosion behavior between magnesia-carbon refractory and converter slags with different MgO contents

Rui-qiang Bai et al.

Summary: The study revealed that the MgO content in slag affects the wetting and corrosion behavior between slag and MgO-C refractory, leading to reduced wetting capability, decreased penetration depth, and accelerated corrosion as MgO content increases. Additionally, the increase in MgO content in slag results in higher viscosity, poorer fluidity, weakened mass transfer and diffusion, and reduced activity of FeO, which collectively weaken the wetting effect caused by chemical reactions.

JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Degradation Behavior of MgO Refractory by BOF Slags Containing Calcium Chloride

Ziwen Yan et al.

Summary: By conducting laboratory experiments, it was found that the addition of CaCl2 into BOF slag could weaken the degradation of MgO refractory, while the addition of CaF2 played an opposite role. In the CaCl2-added slag, a solid solution magnesiowustite (MW) layer could be observed at the boundary between the refractory and the slag, and its thickness increased over time. In the MW layer, MgO diffused to the slag, while FeO diffused oppositely to the refractory. The dissolution of MgO refractory into CaCl2-added slag reduced the solubility of CaCl2 in the slag, leading to the precipitation of a CaCl2 layer near the MW layer.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2022)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Study on formation of dual-phase MnO-SiO2-based inclusions in tire cord steel

Guodong Song et al.

Summary: Laboratory and industrial experiments were conducted to investigate the formation and evolution of inclusions during Si-Mn deoxidation in tire cord steel. The results showed the presence of (Fe, Mn)O inclusions and CaO-SiO2-FeO based inclusions. During deoxidation, (Fe, Mn)O inclusions transformed into MnO-SiO2 system inclusions, while CaO-SiO2-FeO based inclusions generated CaO-SiO2-MnO inclusions. In Si-Mn deoxidized tire cord steel, the dual-phase SiO2 + MnO-SiO2 inclusions could stably remain in liquid steel.

METALLURGICAL RESEARCH & TECHNOLOGY (2022)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Comparison study of slag corrosion resistance of MgO-MgAl2O4, MgO-CaO and MgO-C refractories under electromagnetic field

Xin-ming Ren et al.

Summary: The study revealed that the corrosion and penetration of MgO-based refractories were accelerated under the influence of an electromagnetic field (EMF), making the molten slag easier to penetrate into the refractories. Despite MgO-C refractories showing no significant advantage in slag resistance, as EMF hindered the formation of a dense protective layer, they are still considered the most promising slag line material among MgO-MgAl2O4, MgO-CaO, and MgO-C refractories.

JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL (2021)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Corrosion Behavior of MgO-C Ladle Refractory by Molten Slag

Qing Zhao et al.

Summary: This study investigates the corrosion behavior of MgO-C refractory in contact with molten slag, finding that the corrosion depth is influenced by the FeO content in slag, carbon content in refractory, and rotation speed. The corrosion mechanism is primarily attributed to the penetration corrosion caused by carbon oxidation.

STEEL RESEARCH INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Effect of CaCl2 Addition on the Melting Behaviors of CaO-SiO2-FeOx Steelmaking Slag System

Ziwen Yan et al.

Summary: The addition of CaCl2 affects the melting point of BOF slag, with the impact depending on the slag basicity and FeOx content.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2021)

Add to Collection

Article Materials Science, Ceramics

Effect of fluorspar on the interfacial reaction between electric arc furnace slag and magnesia refractory: Competitive corrosion-protection mechanism of magnesiowustite layer

Min Kyo Oh et al.

Summary: The study investigated the interfacial reaction between CaO-SiO2-FeO-Al2O3-MnO-MgO-xCaF2 type electric arc furnace steelmaking slag and magnesia refractory. It was found that the CaF2 content in the slag affects the thickness of the solid solution layer, and by varying the MgO content in the slag, the depth of refractory dissolution and slag penetration were determined. The study also proposed a critical CaF2 content of approximately 3 wt% that had no significant effect on refractory corrosion.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Effect of CaCl2 Addition on Phosphorus Distribution Between CaO-SiO2-FeOx-P2O5 Slag and Carbon-Saturated Iron at Steelmaking Temperature

Ziwen Yan et al.

Summary: The study investigated the effect of CaCl2 addition on the dephosphorization ability of steelmaking slags. CaCl2 was found to improve the phosphorus distribution ratio in the slags, resulting in higher P content in the liquid slag and enhanced generation of P-rich solid phases in high-basicity slags. The addition of CaCl2 did not significantly change the effects of slag basicity and FeOx content in BOF slags, indicating its beneficial influence on phosphorus distribution in steelmaking processes.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Effect of CaCl2 Addition on the Viscosity of CaO-SiO2-FeOx Steelmaking Slag System

Ziwen Yan et al.

Summary: Research shows that CaCl2 can effectively decrease slag viscosity and lower the critical crystallization temperature (T-CR). Increasing slag basicity can reduce slag viscosity at high temperatures (T > T-CR), but is not beneficial for viscosity reduction at T T-CR. Additionally, higher basicity and FeOx content can simplify the structure of silicates in the slag system, regardless of the addition of CaCl2.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2021)

Add to Collection

Article Materials Science, Ceramics

Wetting, spreading and corrosion behavior of molten slag on dense MgO and MgO-C refractory

Zhaoyang Liu et al.

CERAMICS INTERNATIONAL (2019)

Add to Collection

Article Materials Science, Ceramics

Slag corrosion characteristics of MgO-based refractories under vacuum electromagnetic field

Xinming Ren et al.

JOURNAL OF THE AUSTRALIAN CERAMIC SOCIETY (2019)

Add to Collection

Article Materials Science, Ceramics

Influence of CaF2 in calcium aluminate-based slag on the degradation of magnesia refractory

Jin Sung Han et al.

CERAMICS INTERNATIONAL (2018)

Add to Collection

Article Chemistry, Physical

High chloride content calcium silicate glasses

Xiaojing Chen et al.

PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2017)

Add to Collection

Article Materials Science, Ceramics

Thermodynamic Stability of Spinel Phase at the Interface Between Alumina Refractory and CaO-CaF2-SiO2-Al2O3-MgO-MnO Slags

Jun Seok Park et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2015)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Slag corrosion of MgO-C refractories during secondary steel refining

I. Kasimagwa et al.

IRONMAKING & STEELMAKING (2014)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Initial Wetting and Spreading Phenomena of a CaO-SiO2 Liquid Slag on MgO Substrates

Jiwon Park et al.

ISIJ INTERNATIONAL (2014)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Wettability between Molten Slag and MgO-C Refractories for the Slag Splashing Process

Zhangfu Yuan et al.

ISIJ INTERNATIONAL (2013)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Corrosion Behavior of MgO-C Refractory in Ferromanganese Slags

Hyungsic Um et al.

ISIJ INTERNATIONAL (2012)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Reactive wetting phenomena of MgO-C refractories in contact with CaO-SiO2 slag

Seon-Hwa Heo et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2012)

Add to Collection

Article Materials Science, Ceramics

Thermodynamic simulation models for predicting Al2O3-MgO castable chemical corrosion

A. P. Luz et al.

CERAMICS INTERNATIONAL (2011)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Density and Surface Tension of CaO-SiO2-Al2O3-R2O (R=Li, Na, K) Melts

Sohei Sukenaga et al.

ISIJ INTERNATIONAL (2011)

Add to Collection

Article Metallurgy & Metallurgical Engineering

The effect of FetO Content on MgO Solubilities in Lime-based Slags

Sung-Mo Jung et al.

ISIJ INTERNATIONAL (2010)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Interfacial Reaction between Refractory Materials and Metallurgical Slags containing Fluoride

J. H. Park et al.

STEEL RESEARCH INTERNATIONAL (2010)

Add to Collection

Article Materials Science, Multidisciplinary

Wettability of some refractory materials by molten SiO2-MnO-TiO2-FeOx slag

Ping Shen et al.

MATERIALS CHEMISTRY AND PHYSICS (2009)

Add to Collection

Article Materials Science, Multidisciplinary

Degradation of MgO refractory in CaO-SiO2-MgO-FeOx and CaO-SiO2-Al2O3-MgO-FeOx slags under forced convection

SA Nightingale et al.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2005)

Add to Collection

Article Physiology

Constrained sessile drop as a new configuration to measure low surface tension in lung surfactant systems

LMY Yu et al.

JOURNAL OF APPLIED PHYSIOLOGY (2004)

Add to Collection

Article Materials Science, Ceramics

Density, surface tension, and viscosity of PbO-B2O3-SiO2 glass melts

S Fujino et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2004)

Add to Collection

Article Materials Science, Multidisciplinary

Dynamic and equilibrium interfacial phenomena in liquid steel-slag systems

Y Chung et al.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2000)

Add to Collection

Article Materials Science, Ceramics

Penetration and corrosion of magnesia grain by silicate slags

S Zhang et al.

BRITISH CERAMIC TRANSACTIONS (2000)

Add to Collection

Article Metallurgy & Metallurgical Engineering

Foaming characteristics of BOF slags

SM Jung et al.

ISIJ INTERNATIONAL (2000)

Add to Collection

© Peeref 2019-2024. All rights reserved.