Related references
Note: Only part of the references are listed.
Article
Engineering, Electrical & Electronic
Yunkyung Hwang et al.
Summary: A new RDC method using a trapezoidal excitation signal is proposed in this article to minimize nonlinear problems while maintaining the advantages of the square-wave excitation method. The trapezoidal excitation signal is expressed through a Fourier series expansion to find the optimal point where the total harmonic distortion (THD) along the length of the flat region is minimized. Additionally, a simple circuit for implementing trapezoidal excitation signals is introduced. The effectiveness of the proposed method is verified through experiments.
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT
(2023)
Article
Automation & Control Systems
Peyman Naderi
Summary: In this paper, a Variable-Reluctance resolver (VR-Resolver) with a novel structure is proposed as an absolute position sensor, which analyzes two possible structures. The elimination of slip rings in the rotor is achieved by locating the signals and excitation windings on the stator. The rotor is shaped in a simple variable reluctance structure with low sensitivity to manufacturing tolerance.
Article
Automation & Control Systems
Wenyuan Mi et al.
Summary: This article proposes a novel all-digital RDC system that detects synchronous envelopes based on a numerical synchronous integration method. This system significantly reduces angle delay and quantization errors compared to conventional RDC systems.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2023)
Article
Automation & Control Systems
Saeed Hajmohammadi et al.
Summary: This article discusses the issue of higher accuracy in applications using multispeed resolvers and proposes the use of multiturn resolvers to overcome this challenge. A new dual side configuration structure is presented and analyzed, and finite element method is used to verify its success. Experimental measurements confirm the effectiveness of the proposed sensor.
IEEE-ASME TRANSACTIONS ON MECHATRONICS
(2022)
Article
Computer Science, Information Systems
Pooreum Jang et al.
Summary: This paper investigates the use of resolvers as position sensors for obtaining angle information. To achieve precise signal detection, the resolver signals are sampled in synchronization with the pulsewidth modulation (PWM) carrier. Additional signal processing is required when the resolver excitation signal frequency and the PWM carrier frequency are different in order to obtain angle information.
Article
Engineering, Electrical & Electronic
Tayfun Gundogdu et al.
Summary: This study presents a comprehensive design and analysis of a limited-angle wound rotor resolver (LAWRR) with high precision. The impact of two major design parameters, stator and rotor number of turns combinations, as well as the transformation ratio, on the angular position accuracy is investigated. A simple analytical method is used to determine the optimal number of turn combinations based on total harmonic distortion (THD) percentage. Finite element analysis (FEA) is employed to verify the analytical calculations and determine the optimal number of turns combinations. The cross-correlation effect between the stator and rotor winding configurations is also considered, and accuracy analyses are conducted.
IEEE SENSORS JOURNAL
(2022)
Article
Engineering, Electrical & Electronic
F. Zare et al.
Summary: In this paper, an integrated core, high reliability, linear-rotational resolver with a simple slotless configuration is proposed. Different winding configurations are used to determine the linear and angular position, and the influence of these configurations on sensor accuracy is discussed. A decoupling technique for helical motion is also proposed.
IEEE SENSORS JOURNAL
(2022)
Article
Automation & Control Systems
Hamid Saneie et al.
Summary: This article proposes a general method for determining the winding configuration of VR resolvers and verifies the effectiveness of the proposed winding.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2022)
Article
Automation & Control Systems
Le Sun et al.
Summary: This article introduces a novel concept of stator-PM variable reluctance (VR) resolver, which avoids high-frequency excitation by utilizing a unique PM back electromotive force decoding solution. The resolver, with axial magnetic field technology and a slotless structure, is more compact and smaller than radial field prototypes. The use of a printed circuit board instead of winding coils simplifies the manufacturing process.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2022)
Article
Chemistry, Analytical
Bruno Brajon et al.
Summary: Magnetic and inductive sensors are the dominant technologies for automotive angular position sensing. This paper introduces a hybrid concept that combines magnetic Hall and inductive principles to achieve superior performance in terms of range, compactness, and robustness. A prototype of the hybrid sensor was realized and characterized, demonstrating its high accuracy and resilience against mechanical misalignments, stray fields, and stray metals.
Article
Engineering, Electrical & Electronic
A. Moheyseni et al.
Summary: This article proposes a slotless disk configuration for multi-pole wound-rotor (WR) resolvers and performs an optimization of the winding configuration. The success of the proposed analytical model is verified through 3-D finite element simulations and experimental measurements.
IEEE TRANSACTIONS ON TRANSPORTATION ELECTRIFICATION
(2022)
Article
Automation & Control Systems
Ronggang Ni et al.
Summary: This article investigates a novel VRR structure that is radially integrated inside a PMSM to construct a compact machine topology. Detailed electromagnetic design and experiments validate the effectiveness of the proposed machine topology.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2022)
Article
Automation & Control Systems
Peyman Naderi et al.
Summary: This work presents a novel analysis for a new type of VR-Resolvers based on the MEC method. The performance of the resolver under different windings configurations and rotor structures is investigated accurately using a flexible MEC model. The effects of eccentricity fault on the resolver are also evaluated. The proposed MEC model provides an opportunity to adjust accuracy and simulate various structures in healthy and faulty conditions with just a single model. The MEC results are confirmed by finite element method and experimental results, showing the effectiveness of the proposed model.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2022)
Article
Chemistry, Analytical
Aldi Hoxha et al.
Summary: This paper introduces a new methodology to optimize the design of a printed circuit board (PCB) based ratiometric rotary inductive position sensor. The optimization focuses on reducing the linearity error and voltage mismatch of the sensor. By modifying the shape of the receiving coils, the optimized sensors demonstrate improved linearity error without the need for signal calibration or post-processing manipulation. The effectiveness of the optimization tool is verified through simulations and measurements on different prototypes of an absolute rotary sensor.
Article
Engineering, Electrical & Electronic
M. Bahari et al.
Summary: This article presents an outer rotor structure for the Variable Reluctance Resolver (VR-Resolver) with a non-overlapping tooth-coil windings configuration to simplify the manufacturing process. The study investigates the structure and working principle of the proposed position sensor and analyzes its performance using transient finite-element analysis (TFEA). Sensitivity analysis on rotor shape factors, slot opening, and manufacturing tolerances is conducted, and the effectiveness of the optimal design is verified through 3D TFEA.
IEEE SENSORS JOURNAL
(2022)
Article
Energy & Fuels
Xiaohe Ran et al.
Summary: This paper proposes an analytical model of a novel axial reluctance resolver based on the finite element method and winding function method. The resolver consists of a rotor with half-wave magnetic-bands and a stator with parallel teeth, which simplifies the manufacturing process and allows for mass production. The interference resistance of the sinusoidal distributed winding configuration is verified using the winding function method, and the accuracy and computation costs of the proposed method are compared with the finite element method under constant and sinusoidal distributed winding configurations. The robustness of the half-wave resolver under axial offset is demonstrated and validated through theoretical explanation and numerical simulation. The accuracy of the proposed resolver under healthy and offset conditions is compared and summarized. Compared to traditional resolvers, the half-wave axial reluctance resolver has simpler processing, higher precision, and stronger interference resistance. The simulation results and theoretical analysis confirm the success of the design and analysis process.
Article
Automation & Control Systems
Hamid Saneie et al.
Summary: The article proposes a method to determine the optimal winding configuration for resolvers, simplifying the winding configuration for resolvers with different pole pairs and teeth numbers while considering sensor reliability. Confirmation of analysis using a three-dimensional finite element method was conducted, and a prototype of the sensor was built and tested to verify the proposed winding approach.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2021)
Article
Engineering, Electrical & Electronic
Mohammad Bahari et al.
Summary: Resolver, as an electromagnetic sensor, is commonly used in industrial applications due to its reliable performance in harsh environments. Among different types, variable reluctance resolvers stand out for their robust structure and cost-effectiveness. This article proposes a toroidal winding arrangement for a VR resolver with a 5-X rotor, analyzed using a magnetic equivalent circuit and time-stepping finite element analysis. The results are validated through experimental tests on a prototype resolver.
IEEE SENSORS JOURNAL
(2021)
Article
Energy & Fuels
Le Sun et al.
Summary: The stator-PM variable reluctance (VR) resolver is proposed as a new position sensor that can measure rotor position over a wide speed range, with high-speed signal decoding capabilities. A solution based on field modulation theory is provided to address design challenges with different numbers of rotor poles.
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2021)
Article
Engineering, Electrical & Electronic
Fateme Zare et al.
Summary: In this paper, a new configuration for rotational-linear position estimation is proposed and an optimization is performed to reduce the sensor's volume and improve accuracy. The performance of the initial and optimal designs is analyzed using 3-D transient FEM, and the success of the proposed design is confirmed through experimental testing.
IEEE SENSORS JOURNAL
(2021)
Article
Engineering, Electrical & Electronic
Reza Ghandehari et al.
Summary: This study introduces a new parametric magnetic equivalent circuit (MEC) for modeling a permanent magnet resolver with adjustable accuracy. The model allows evaluation of PM-Resolver performance in healthy and faulty conditions with different rotor structures, showing acceptable position estimation accuracy and increased error due to eccentricity fault. The MEC results are validated using 2D-EM and experimental data, demonstrating the effectiveness of the modeling technique and the advantages over finite element method in terms of model flexibility and processing time.
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT
(2021)
Article
Computer Science, Information Systems
Wenzheng Gao et al.
Summary: This paper presents a new planar inductive sensor with printed circuit boards (PCB) based stator and rotor, which is capable of more precise measurement in harsh environments. The sensor utilizes PCB technique to accurately configure planar coils, making it suitable for high precision and reliable measurement.
Article
Engineering, Electrical & Electronic
M. Bahari et al.
IEEE SENSORS JOURNAL
(2020)
Article
Energy & Fuels
Hamid Saneie et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2020)
Article
Engineering, Electrical & Electronic
Longfei Xiao et al.
IEEE TRANSACTIONS ON MAGNETICS
(2020)
Article
Engineering, Electrical & Electronic
S. Hajmohammadi et al.
IEEE SENSORS JOURNAL
(2020)
Article
Engineering, Electrical & Electronic
Saeed Hajmohammadi et al.
IEEE SENSORS JOURNAL
(2020)
Article
Automation & Control Systems
Le Sun et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2020)
Article
Automation & Control Systems
Ramin Alipour-Sarabi et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2019)
Article
Engineering, Electrical & Electronic
M. Alemi-Rostami et al.
IEEE TRANSACTIONS ON VEHICULAR TECHNOLOGY
(2019)
Article
Engineering, Electrical & Electronic
F. Tootoonchian
IEEE SENSORS JOURNAL
(2019)
Article
Energy & Fuels
Hamid Saneie et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2019)
Article
Computer Science, Information Systems
Qiang Li et al.
Article
Automation & Control Systems
Hamid Saneie et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2018)
Article
Engineering, Electrical & Electronic
Farid Totoonchian
IET ELECTRIC POWER APPLICATIONS
(2018)
Article
Engineering, Electrical & Electronic
Farid Tootoonchian
IET SCIENCE MEASUREMENT & TECHNOLOGY
(2018)
Article
Engineering, Electrical & Electronic
F. Abolqasemi-Kharanaq et al.
IEEE SENSORS JOURNAL
(2018)
Article
Engineering, Electrical & Electronic
Ramin Alipour-Sarabi et al.
IEEE SENSORS JOURNAL
(2017)
Article
Engineering, Electrical & Electronic
Zahra Nasiri-Gheidari et al.
IEEE SENSORS JOURNAL
(2017)
Article
Energy & Fuels
Zahra Nasiri-Gheidari
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2017)
Article
Engineering, Electrical & Electronic
Farid Tootoonchian et al.
IET ELECTRIC POWER APPLICATIONS
(2017)
Article
Engineering, Electrical & Electronic
Hamid Saneie et al.
IET ELECTRIC POWER APPLICATIONS
(2017)
Article
Nanoscience & Nanotechnology
Jisho Oshino et al.
Article
Engineering, Electrical & Electronic
Farid Tootoonchian
IEEE SENSORS JOURNAL
(2016)
Article
Energy & Fuels
X. Ge et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2016)
Article
Engineering, Multidisciplinary
X. Ge et al.
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS
(2016)
Article
Engineering, Electrical & Electronic
Qifu Tang et al.
IEEE SENSORS JOURNAL
(2015)
Article
Energy & Fuels
X. Ge et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2015)
Article
Engineering, Electrical & Electronic
X. Ge et al.
IEEE TRANSACTIONS ON MAGNETICS
(2015)
Article
Engineering, Electrical & Electronic
Ki-Chan Kim
IEEE TRANSACTIONS ON MAGNETICS
(2013)
Article
Engineering, Multidisciplinary
Haiming Liu et al.
MATHEMATICAL PROBLEMS IN ENGINEERING
(2013)
Article
Automation & Control Systems
Joao Figueiredo
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2011)
