Related references
Note: Only part of the references are listed.Evading the strength-ductility trade-off at room temperature and achieving ultrahigh plasticity at 800°C in a TiAl alloy
Guoming Zheng et al.
ACTA MATERIALIA (2022)
Tuning the microstructure and mechanical properties of TiAl-based alloy through grain boundary engineering
Yaodong Xuanyuan et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)
Twin and twin intersection phenomena in a creep deformed microalloyed directionally solidified high Nb containing TiAl alloy
Xuesong Xu et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2022)
Insights into the abnormal flow softening of lamellar γ-TiAl alloys during hot-working: Experimental analysis and numerical simulation
Liang Cheng et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)
A β-solidifying TiAl alloy reinforced with ultra-fine Y-rich precipitates
Xu Gu et al.
SCRIPTA MATERIALIA (2021)
Kinetics of cyclically-induced mechanical twinning in γ-TiAl unveiled by a combination of acoustic emission, neutron diffraction and electron microscopy
A. Vinogradov et al.
ACTA MATERIALIA (2021)
Dynamic recrystallization and hot processing map of Ti-48Al-2Cr-2Nb alloy during the hot deformation
Xiaofei Chen et al.
MATERIALS CHARACTERIZATION (2021)
Microstructure, mechanical and tribological performances of a directionally solidified γ-TiAl alloy
Hailing Wang et al.
MATERIALS CHARACTERIZATION (2021)
Transition of dynamic recrystallization mechanism during hot deformation of Incoloy 028 alloy
XiTing Zhong et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)
An investigation of geometrically necessary dislocations and back stress in large grained tantalum via EBSD and CPFEM
Landon T. Hansen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Effect of alloying additions on work hardening, dynamic recrystallization, and mechanical properties of Ti-44Al-5Nb-1Mo alloys during direct hot-pack rolling
G. H. Liu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
A unified static and dynamic recrystallization Internal State Variable (ISV) constitutive model coupled with grain size evolution for metals and mineral aggregates
H. E. Cho et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2019)
High temperature deformation and control of homogeneous microstructure during hot pack rolling of Ti-44Al-5Nb-(Mo, V, B) alloys: The impact on mechanical properties
T. R. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Modeling of dynamic recrystallization volume fraction evolution for AlCu4SiMg alloy and its application in FEM
Guo-zheng Quan et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2019)
Effect of the Zener-Hollomon parameter on the dynamic recrystallization kinetics of Mg-Zn-Zr-Yb magnesium alloy
Lu Li et al.
COMPUTATIONAL MATERIALS SCIENCE (2019)
Hot deformation characteristics and dynamic recrystallization mechanism of GH4730 Ni-based superalloy
Jinglong Qu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2019)
Dynamic recrystallization kinetics and microstructure evolution of 7055 aluminum alloy during hot compression
Tao Zhang et al.
METALLURGICAL RESEARCH & TECHNOLOGY (2019)
Microstructure evolution and mechanical properties of gamma-TiAl honeycomb structure fabricated by isothermal forging and pulse current assisted diffusion bonding
Chengcheng Shi et al.
INTERMETALLICS (2018)
Pulse current auxiliary forging of sintered TiAl alloys based on the investigation of dynamic recrystallization and phase transformation
Chengcheng Shi et al.
MATERIALS CHARACTERIZATION (2018)
Investigation of hydrogen influencing γ-phase true and pseudo twinning in a TiAl based alloy during high-temperature plane strain compression
Daosheng Wen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Slip transfer across gamma-TiAl lamellae in tension
Alberto Jesus Palomares-Garcia et al.
MATERIALS & DESIGN (2018)
Enhanced high-temperature tensile property by gradient twin structure of duplex high-Nb-containing TiAI alloy
Jie Ding et al.
ACTA MATERIALIA (2018)
Dynamic softening behavior and microstructural characterization of TiAl-based alloy during hot deformation
Zhipeng Wan et al.
MATERIALS CHARACTERIZATION (2017)
Impact of Alloying on Stacking Fault Energies in γ-TiAl
Phillip Dumitraschkewitz et al.
APPLIED SCIENCES-BASEL (2017)
Experimental study and numerical simulation of dynamic recrystallization behavior of TiAl-based alloy
Zhipeng Wan et al.
MATERIALS & DESIGN (2017)
Hot pack rolling nearly lamellar Ti-44Al-8Nb-(W, B, Y) alloy with different rolling reductions: Lamellar colonies evolution and tensile properties
Haitao Zhou et al.
MATERIALS & DESIGN (2017)
Effect of lamellar orientation on the strength and operating deformation mechanisms of fully lamellar TiAl alloys determined by micropillar compression
Alberto Jesus Palomares-Garcia et al.
ACTA MATERIALIA (2017)
Modeling concepts for intermetallic titanium aluminides
F. Appel et al.
PROGRESS IN MATERIALS SCIENCE (2016)
A review of dynamic recrystallization phenomena in metallic materials
K. Huang et al.
MATERIALS & DESIGN (2016)
Deformation behavior of high Nb containing TiAl based alloy in α plus γ two phase field region
S. Z. Zhang et al.
MATERIALS & DESIGN (2016)
Dynamic recrystallization behavior of Ti-5Al-5Mo-5V-1Cr-1Fe alloy
Houquan Liang et al.
MATERIALS & DESIGN (2014)
Dynamic recrystallization behavior of an as-cast TiAl alloy during hot compression
Jianbo Li et al.
MATERIALS CHARACTERIZATION (2014)
An in-situ high-energy X-ray diffraction study on the hot-deformation behavior of a β-phase containing TiAl alloy
T. Schmoelzer et al.
INTERMETALLICS (2013)
Deformation and dynamic recrystallization behavior of a high Nb containing TiAl alloy
Liang Cheng et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2013)
Microstructure evolution and mechanical properties of a novel beta γ-TiAl alloy
H. Z. Niu et al.
INTERMETALLICS (2012)
Advances in gamma titanium aluminides and their manufacturing techniques
Kunal Kothari et al.
PROGRESS IN AEROSPACE SCIENCES (2012)
Flow behavior and microstructure evolution of a P/M TiAl alloy during high temperature deformation
Gang Wang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Microstructure and mechanical properties of high niobium containing TiAl alloys elaborated by spark plasma sintering
Houria Jabbar et al.
INTERMETALLICS (2010)
Constitutive modeling and processing map for elevated temperature flow behaviors of a powder metallurgy titanium aluminide alloy
W. Zhang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Microstructure evolution during dynamic recrystallization of hot deformed superalloy 718
Y. Wang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
A dislocation density based constitutive model for crystal plasticity FEM including geometrically necessary dislocations
A. Ma et al.
ACTA MATERIALIA (2006)
Review of alloy and process development of TiAl alloys
Xinhua Wu
INTERMETALLICS (2006)
Study by EBSD of the development of the substructure in a hot deformed 304 stainless steel
D Jorge-Badiola et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
The adiabatic correction factor for deformation heating during the uniaxial compression test
RL Goetz et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2001)
Share Paper
