Related references
Note: Only part of the references are listed.Clinical esthetic comparison between monolithic high-translucency multilayer zirconia and traditional veneered zirconia for single implant restoration in maxillary esthetic areas: Prosthetic and patient- centered outcomes
Chu-Nan Zhang et al.
JOURNAL OF DENTAL SCIENCES (2022)
Influence of surface and subsurface properties on the bonding between yttria stabilized tetragonal zirconia polycrystals and a veneering ceramic
Bernd Breidenstein et al.
JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY (2021)
Effect of sandblasting on the surface roughness and residual stress of 3Y-TZP (zirconia)
Christin Finger et al.
SN APPLIED SCIENCES (2020)
Surface wettability and nano roughness at different grit blasting operational pressures and their effects on resin cement to zirconia adhesion
Aftab Ahmed Khan et al.
DENTAL MATERIALS JOURNAL (2019)
Novel Zirconia Materials in Dentistry
Y. Zhang et al.
JOURNAL OF DENTAL RESEARCH (2018)
Promoting porcelain-zirconia bonding using different atmospheric pressure gas plasmas
Yi-Chuan Liu et al.
DENTAL MATERIALS (2018)
Surface-wetting characterization using contact-angle measurements
Tommi Huhtamaki et al.
NATURE PROTOCOLS (2018)
Comparison of fracture strength and failure mode of different ceramic implant abutments
Adham Elsayed et al.
JOURNAL OF PROSTHETIC DENTISTRY (2017)
Effect of Veneering Methods on Zirconia Framework-Veneer Ceramic Adhesion and Fracture Resistance of Single Crowns
Burcu Kanat-Erturk et al.
JOURNAL OF PROSTHODONTICS-IMPLANT ESTHETIC AND RECONSTRUCTIVE DENTISTRY (2015)
Clinical Advantages and Limitations of Monolithic Zirconia Restorations Full Arch Implant Supported Reconstruction: Case Series
Joao Carames et al.
INTERNATIONAL JOURNAL OF DENTISTRY (2015)
A review on the wettability of dental implant surfaces I: Theoretical and experimental aspects
Frank Rupp et al.
ACTA BIOMATERIALIA (2014)
Effect of sandblasting on surface roughness of zirconia-based ceramics and shear bond strength of veneering porcelain
Min He et al.
DENTAL MATERIALS JOURNAL (2014)
Effect of zirconia surface treatment on zirconia/veneer interfacial toughness evaluated by fracture mechanics method
Gaoqi Wang et al.
JOURNAL OF DENTISTRY (2014)
EVALUATION OF ROUGHNESS, WETTABILITY, AND MORPHOLOGY OF AN YTTRIA-STABILIZED TETRAGONAL ZIRCONIA POLYCRYSTAL CERAMIC AFTER DIFFERENT AIRBORNE-PARTICLE ABRASION PROTOCOL
Filipe Oliveira Abi-Rached et al.
JOURNAL OF PROSTHETIC DENTISTRY (2014)
3D-Characterization of the veneer-zirconia interface using FIB nano-tomography
Amelie K. Mainjot et al.
DENTAL MATERIALS (2013)
Surface characterisation and bonding of Y-TZP following non-thermal plasma treatment
Guilherme B. Valverde et al.
JOURNAL OF DENTISTRY (2013)
Allergy related to dental implant and its clinical significance
T. P. Chaturvedi
CLINICAL COSMETIC AND INVESTIGATIONAL DENTISTRY (2013)
Confocal Raman microscopic analysis of the zirconia/feldspathic ceramic interface
Jean-Cedric Durand et al.
DENTAL MATERIALS (2012)
Effect of thermal expansion mismatch on the Y-TZP/veneer interfacial adhesion determined by strain energy release rate
Gerd Goestemeyer et al.
JOURNAL OF PROSTHODONTIC RESEARCH (2012)
Performance of Dental Ceramics: Challenges for Improvements
E. D. Rekow et al.
JOURNAL OF DENTAL RESEARCH (2011)
Shear bond strengths of various luting cements to zirconia ceramic: Surface chemical aspects
Min-Jeong Kim et al.
JOURNAL OF DENTISTRY (2011)
The Tetragonal-Monoclinic Transformation in Zirconia: Lessons Learned and Future Trends
Jerome Chevalier et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2009)
State of the art of zirconia for dental applications
Isabelle Denry et al.
DENTAL MATERIALS (2008)
Stabilized zirconia as a structural ceramic: An overview
J. Robert Kelly et al.
DENTAL MATERIALS (2008)
Corrosion of alloys used in dentistry: A review
Deepti Upadhyay et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Microtensile bond strength of different components of core veneered all-ceramic restorations - Part II: Zirconia veneering ceramics
Moustafa N. Aboushelib et al.
DENTAL MATERIALS (2006)
What future for zirconia as a biomaterial?
J Chevalier
BIOMATERIALS (2006)
Influence of surface and heat treatments on the flexural strength of Y-TZP dental ceramic
M Guazzato et al.
JOURNAL OF DENTISTRY (2005)
Shear strength of core-veneer interface in bi-layered ceramics
HM Al-Dohan et al.
JOURNAL OF PROSTHETIC DENTISTRY (2004)
Strength, fracture toughness and microstructure of a selection of all-ceramic materials. Part II. Zirconia-based dental ceramics
M Guazzato et al.
DENTAL MATERIALS (2004)
Crack growth resistance of alumina, zirconia and zirconia toughened alumina ceramics for joint prostheses
AH De Aza et al.
BIOMATERIALS (2002)
The introduction of powder blasting for sensor and microsystem applications
E Belloy et al.
SENSORS AND ACTUATORS A-PHYSICAL (2000)
Share Paper
