4.7 Article

Monoclinic phase-free, low temperature spark plasma sintering of CeO2-doped ZrO2 ceramics and its associated benefits on mechanical properties

Related references

Note: Only part of the references are listed.
Article Materials Science, Ceramics

Transparent high-strength nanosized yttria stabilized zirconia obtained by pressure-less sintering

Omid Akhlaghi et al.

Summary: This work describes the development of transparent high-strength Yttria-Stabilized Zirconia (YSZ) ceramics with ultra-fine grain size. Utilizing conventional pressure-less densification, full densification and excellent light transmission were achieved. The resulting ceramics also exhibited high biaxial strength attributed to the refined microstructure and martensitic phase transformation.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2022)

Article Materials Science, Ceramics

Processing and mechanical properties of hot-pressed zirconium diboride - zirconium carbide ceramics

Eric W. Neuman et al.

Summary: ZrB2 was mixed with 0.5 wt% carbon and up to 10 vol% ZrC and densified by hot-pressing at 2000 degrees C. The resulting dense ceramics exhibited reduced ZrC content and residual carbon, smaller ZrB2 grain sizes, larger ZrC cluster sizes, increased elastic modulus, hardness, toughness, and flexure strength with increasing ZrC content. The strength-limiting flaw was identified as ZrB2 grain pullout.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2022)

Article Materials Science, Ceramics

Mechanical properties of ceria-calcia stabilized zirconia ceramics with alumina additions

D. Tovar-Vargas et al.

Summary: Ceria-stabilized zirconia-based composites have enhanced hardness, strength, and fracture toughness, along with excellent aging resistance, especially for the 10Ce-1CaO-5Al(2)O(3) composition.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2021)

Article Materials Science, Multidisciplinary

Phase transformation induces plasticity with negligible damage in ceria-stabilized zirconia-based ceramics

Alethea Liens et al.

ACTA MATERIALIA (2020)

Article Dentistry, Oral Surgery & Medicine

Importance of tetragonal phase in high-translucent partially stabilized zirconia for dental restorations

Fei Zhang et al.

DENTAL MATERIALS (2020)

Article Materials Science, Ceramics

Coarse-grain CeO2 doped ZrO2 ceramic prepared by spark plasma sintering

Marek Vojtko et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2020)

Article Materials Science, Multidisciplinary

First-principles study, fabrication and characterization of (Zr0.25Nb0.25Ti0.25V0.25)C high-entropy ceramics

Beilin Ye et al.

ACTA MATERIALIA (2019)

Article Chemistry, Physical

Reaping the remarkable benefits of a 'burst nucleation' approach for a ceria doped zirconia system

Aditya Arun et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Article Nanoscience & Nanotechnology

Spherical engineering Ca-TZP ceramics made from baddeleyite: fabrication, structure and mechanical properties

Vyacheslav V. Rodaev et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

Review Materials Science, Ceramics

Transparent Ceramics at 50: Progress Made and Further Prospects

Adrian Goldstein et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2016)

Article Engineering, Biomedical

Effect of polishing instruments and polishing regimens on surface topography and phase transformation of monolithic zirconia: An evaluation with XPS and XRD analysis

Nadin Al-Haj Husain et al.

JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2016)

Article Materials Science, Ceramics

Processing and characterization of Ca-TZP nanoceramics

Anna Labuz et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2015)

Review Materials Science, Multidisciplinary

Field-Assisted Sintering Technology/Spark Plasma Sintering: Mechanisms, Materials, and Technology Developments

Olivier Guillon et al.

ADVANCED ENGINEERING MATERIALS (2014)

Article Dentistry, Oral Surgery & Medicine

Influence of sintering conditions on low-temperature degradation of dental zirconia

Masanao Inokoshi et al.

DENTAL MATERIALS (2014)

Article Materials Science, Multidisciplinary

Phase assembly and electrical conductivity of spark plasma sintered CeO2-ZrO2 ceramics

Rosalia Poyato et al.

JOURNAL OF MATERIALS SCIENCE (2014)

Article Materials Science, Ceramics

3Y-TZP ceramics with improved hydrothermal degradation resistance and fracture toughness

F. Zhang et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2014)

Article Engineering, Biomedical

Low-temperature degradation of different zirconia ceramics for dental applications

Philipp Kohorst et al.

ACTA BIOMATERIALIA (2012)

Article Materials Science, Ceramics

Low Temperature Sintering of Nanocrystalline Zinc Oxide: Effect of Heating Rate Achieved by Field Assisted Sintering/Spark Plasma Sintering

Sebastian Schwarz et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2012)

Article Chemistry, Physical

Atmospheric-Pressure Chemical Vapor Deposition of Iron Pyrite Thin Films

Nicholas Berry et al.

ADVANCED ENERGY MATERIALS (2012)

Article Materials Science, Multidisciplinary

Spark plasma sintering of a commercially available granulated zirconia powder: Comparison with hot-pressing

Guillaume Bernard-Granger et al.

ACTA MATERIALIA (2010)

Review Dentistry, Oral Surgery & Medicine

Low temperature degradation -aging- of zirconia: A critical review of the relevant aspects in dentistry

Vanni Lughi et al.

DENTAL MATERIALS (2010)

Article Materials Science, Ceramics

Effect of dopants on the phase stability of zirconia-based plasma sprayed thermal barrier coatings

S. A. Tsipas

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2010)

Article Nanoscience & Nanotechnology

Effect of grain size on wear behavior in Y-TZP ceramics

B. Venkata Manoj Kumar et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

Article Nanoscience & Nanotechnology

Structure and mechanical properties of Al-Ni-Ti amorphous powder consolidated by pressure-less, pressure-assisted and spark plasma sintering

Suhrit Mula et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

Article Materials Science, Ceramics

The Tetragonal-Monoclinic Transformation in Zirconia: Lessons Learned and Future Trends

Jerome Chevalier et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2009)

Article Materials Science, Ceramics

Ceramics for medical applications: A picture for the next 20 years

J. Chevalier et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)

Article Dentistry, Oral Surgery & Medicine

Stabilized zirconia as a structural ceramic: An overview

J. Robert Kelly et al.

DENTAL MATERIALS (2008)

Article Chemistry, Multidisciplinary

Transparent nanometric cubic and tetragonal zirconia obtained by high-pressure pulsed electric current sintering

Umberto Anselmi-Tamburini et al.

ADVANCED FUNCTIONAL MATERIALS (2007)

Review Materials Science, Ceramics

Ceramics for prosthetic hip and knee joint replacement

Mohamed N. Rahaman et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2007)

Article Materials Science, Ceramics

Static and cyclic crack propagation in Ce-TZP ceramics with different amounts of transformation toughening

H. El Attaoui et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2007)

Article Materials Science, Ceramics

Coprecipitation synthesis of MgO-doped ZrO2 nano powder

Shaoyan Wang et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2006)

Article Materials Science, Ceramics

Phases in ceria-zirconia binary oxide (1-x)CeO2-xZrO2 nanoparticles:: The effect of particle size

F Zhang et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2006)

Article Nanoscience & Nanotechnology

Fast low-temperature consolidation of bulk nanometric ceramic materials

U Anselmi-Tamburini et al.

SCRIPTA MATERIALIA (2006)

Article Materials Science, Ceramics

Phase assembly and microstructure of CeO2-doped ZrO2 ceramics prepared by spark plasma sintering

T Xu et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2005)

Article Materials Science, Ceramics

Effect of powder coating on stabilizer distribution in CeO2-stabilized ZrO2 ceramics

PA Fang et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2005)

Article Materials Science, Multidisciplinary

The effect of reduction on the mechanical properties of CeO2 doped tetragonal zirconia ceramics

M Matsuzawa et al.

ACTA MATERIALIA (2004)

Article Nanoscience & Nanotechnology

Toughness tailoring of yttria-doped zirconia ceramics

B Basu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)

Article Materials Science, Ceramics

Crystallite and grain-size-dependent phase transformations in yttria-doped zirconia

A Suresh et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2003)

Article Chemistry, Physical

Solid oxide fuel cells for stationary, mobile, and military applications

SC Singhal

SOLID STATE IONICS (2002)

Article Materials Science, Multidisciplinary

Fracture toughness of nanocrystalline tetragonal zirconia with low yttria content

A Bravo-Leon et al.

ACTA MATERIALIA (2002)

Article Materials Science, Ceramics

Physical characteristics and sintering behavior of ultrafine zirconia-ceria powders

SK Tadokoro et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2002)

Article Materials Science, Multidisciplinary

Electrical conductivity and defect structure of CeO2-ZrO2 mixed oxide

JH Lee et al.

JOURNAL OF MATERIALS SCIENCE (2002)

Article Materials Science, Ceramics

Microstructure and mechanical properties of cubic zirconia (8YSZ)/SiC nanocomposites

L Donzel et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2000)

Article Chemistry, Physical

Progress in the development of zirconia gas sensors

WC Maskell

SOLID STATE IONICS (2000)