Investigation of high-density polyethylene pyrolyzed wax for asphalt binder modification: Mechanism, thermal properties, and ageing performance

The thermal pyrolysis of high-density polyethylene in a fixed bed reactor has been studied in the temperature range of 450-550 degrees C with two different nitrogen carrier gas flowrates, 2 and 4nullLnullmin(-1), to study the effect of these process parameters as well as the resultant vapour residence times on the formation of wax and its chemical and thermal properties. The technology had a high selectivity to waxes, with a yield of up to 91.87% wax from high-density polyethylene at 500 degrees C using a nitrogen carrier gas flowrate of 4nullLnullmin(-1) and subsequent 1.76 second vapour residence time, calculated using the ideal gas law. The waxes were characterised using techniques including gas-chromatography-mass spectroscopy (GC-MS), Fourier transform infrared spectroscopy (FTIR), thermal gravimetric analysis (TGA) and differential scanning calorimetry (DSC). The process operating temperature especially and its subsequent effect on vapour residence times within the reactor had a considerable impact on both the chemical and thermal properties of the waxes. Higher operating temperatures yielded more olefinic waxes due to the promotion of degradation radical mechanisms such as beta-scission. They were observed to have higher melting points and thermal stability. An investigation was conducted to assess the thermal properties and ageing performance of the waxes. Thermal conditioning in an ashing oven at 170 degrees C for 0-6 hours was conducted with a detailed analysis of GC-MS and FTIR at each stage of thermal exposure to further support thermal characterisation results. The changes in chemical composition were attributed mainly to oxidation and polymerization ageing reactions and were seen to be more prominent in the more unsaturated waxes produced at higher pyrolysis temperatures. The wax produced at 550 degrees C was determined the optimal wax for binder modification in hot-mix asphalt pavement design due to lower volatile/mass loss. A lower temperature range was suggested for optimal blending conditions to further reduce loss of volatiles with initial blending and storage.

Automated summary

The thermal pyrolysis of high-density polyethylene in a fixed bed reactor was studied to understand the formation and properties of waxes. Higher temperatures resulted in more olefinic waxes with higher melting points and thermal stability. The waxes produced at 550 degrees C were identified as optimal for binder modification in hot-mix asphalt pavement design due to lower volatile/mass loss.