4.7 Article

Microstructure formation and mechanical performance of micro-nanoscale ceramic reinforced aluminum matrix composites manufactured by laser powder bed fusion

Journal

JOURNAL OF ALLOYS AND COMPOUNDS
Volume 939, Issue -, Pages -

Publisher

ELSEVIER SCIENCE SA
DOI: 10.1016/j.jallcom.2023.168803

Keywords

Laser powder bed fusion; Al matrix composites; Micro-nanoscale reinforcements; Reaction mechanism; Performance

Ask authors/readers for more resources

In this study, aluminum-based composites with different percentages of (ZrC+TiC) ceramic reinforcements were manufactured using laser powder bed fusion (LPBF) additive manufacturing. The influence of hybrid ceramic content on laser absorption behavior, micro-nanoscale reinforcing phase formation, and mechanical performance of the composites was investigated. Increasing the hybrid ceramic content from 10% to 20% enhanced the laser absorption behavior and increased the fraction of nanoparticles. The composites with 20% ceramic content exhibited a micro/nano hardness of 120 HV0.2 and 1.33 GPa, respectively. The composites with 15% (ZrC+TiC)/Al showed a higher elastic modulus of -94.4 GPa and tensile strength of -280 MPa compared to the unreinforced Al matrix, attributed to the formation of nano-precipitates and coherent bonding at the reinforcement/matrix interfaces.
The constituent ratio merged into as-fabricated composites can directly influence the content of in-situ formed reinforcing phases, which is closely related to the mechanical performance of these composites. In this work, aluminum matrix composites reinforced with 10, 15, and 20 wt% (ZrC+TiC) ceramic fractions have been manufactured by laser powder bed fusion (LPBF) additive manufacturing. The effect of hybrid ceramic reinforcement content on laser absorption behavior, fabrication and fraction of micro-nanoscale reinforcing phases, mechanical performance of the as-fabricated aluminum matrix composites is studied. In the laser processing, TiC reacts with ZrC to synthesize interfacial layer on the unmolten ceramic particals and precipitate nano-particles. With the hybrid ceramic content raising from 10 to 20 wt%, the laser absorption behavior is enhanced, and the nano-particle fraction increases. The micro/nano hardness of the composites with 20 wt% ceramic content, reaches 120 HV0.2 and 1.33 GPa, respectively. An elastic modulus of -94.4 GPa and tensile strength of -280 MPa are obtained for the 15 wt% (ZrC+TiC)/Al composites, much higher than those of the unreinforced Al matrix. This is attributed to the combination of formation of nano-precipitates and coherent bonding at the reinforcement/matrix interfaces in these composites. (c) 2023 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available