Related references
Note: Only part of the references are listed.Modeling and multiresponse optimization on WEDM for HSLA by RSM
Neeraj Sharma et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining
Aqueel Shah et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2011)
Soft computing models based prediction of cutting speed and surface roughness in wire electro-discharge machining of tungsten carbide cobalt composite
Probir Saha et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2008)
Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method
S. S. Mahapatra et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2007)
An investigation on machinability of nodular cast iron by WEDM
N Özdemir et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2006)
Parametric optimisation of wire electrical discharge machining of gamma titanium aluminide alloy through an artificial neural network model
S Sarkar et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2006)
The effect of cutting parameters on wire crater sizes in wire EDM
N Tosun et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2003)
An investigation on wire wear in WEDM
N Tosun et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)
Experimental investigation into shaping particle-reinforced material by WEDM-HS
ZN Guo et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Share Paper
