Journal
DESALINATION
Volume 550, Issue -, Pages -Publisher
ELSEVIER
DOI: 10.1016/j.desal.2022.116366
Keywords
Evaporation desalination; Polypropylene membrane; Graphene oxide; Seawater desalination; Heat exchange; Humidity
Categories
Ask authors/readers for more resources
The performance of nanoporous polypropylene membrane contactors in water evaporative transfer processes is reported in this paper, considering membrane packing density, flow, and temperature conditions. The efficiency of heat and mass transfer in the membrane evaporator is evaluated under various partial pressure gradients and gas phase Reynolds numbers. By inducing convective flows in the gas phase, the evaporation efficiency increases and reaches 4.6 kg x m-2xh-1 (3.0 kW x m-2xh-1) at the inlet water temperature of 60 degrees C. The efficiency is achieved through heat extraction from the gaseous phase and evaporation of water from the external surface of fibers. A thin graphene oxide coating is applied to prevent liquid penetration through the pores and salts crystallization, although slightly reducing the membrane performance.
The paper reports the performance of nanoporous polypropylene membrane contactors in water evaporative transfer processes, depending on membrane packing density, flow, and temperature conditions. The membrane evaporator's heat and mass transfer efficiency were evaluated in a wide range of partial pressure gradients and gas phase Reynolds numbers. A protocol for simple evaluation of evaporative heat flux to the heat exchange flux is introduced to reveal the efficiency of mass-to-heat transfer. It has been shown the evaporation efficiency significantly depends on gas flow conditions, increasing at Re - 30 and exceeding 4.6 kg x m-2xh- 1 (3.0 kW x m-2xh- 1) at the temperature of inlet water of 60 degrees C. It is achieved by inducing convective flows in the gas phase, which enable the rise of effective heat transfer coefficient for membrane evaporator -250 W x m-2xK- 1. The attained efficiency is confirmed to originate from heat extraction from the gaseous phase and the evaporation of water from the external surface of fibers. While exhibiting maximal heat flux the regime requires liquid phase penetration through the pores, leading to degradation of the membrane performance in desalination applications. To avoid penetration of ions thin (-300 nm) graphene oxide coating was deposited onto the internal surface of the nanoporous evaporator, enabling to avoid liquid penetration through the pores and salts crystallization at the external surface, while exhibiting slightly lower performance of the membrane.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available