4.7 Article

Embedded-type optical sensors for in situ monitoring of carbonation of cementitious materials

Related references

Note: Only part of the references are listed.
Article Construction & Building Technology

Upcycling sintering red mud waste for novel superfine composite mineral admixture and CO2 sequestration

Songhui Liu et al.

Summary: A room temperature in-situ wet carbonation method was proposed to activate sintering red mud waste (SRM) and sequester CO2, which resulted in the formation of fine calcite crystals and silica-alumina gel. The carbonated SRM exhibited a high CO2 sequestration rate and pozzolanic reactivity, making it a potential cement mineral admixture.

CEMENT & CONCRETE COMPOSITES (2022)

Article Green & Sustainable Science & Technology

Quantification of CO2 uptake of concretes with mineral additions after 10-year natural carbonation

Akli Younsi et al.

Summary: The CO2 uptake of Portland cement, fly ash, and blast furnace slag concrete was studied to assess the CO2 exchanges during the life cycle of structures. It was found that concrete with high slag content has lower CO2 binding capacity but compensates with a higher carbonation depth.

JOURNAL OF CLEANER PRODUCTION (2022)

Article Chemistry, Multidisciplinary

Accelerated carbonation of recycled concrete aggregates: Investigation on the microstructure and transport properties at cement paste and mortar scales

Farah Kaddah et al.

Summary: The accelerated carbonation of recycled concrete aggregates has been suggested as a way to improve their properties. This study investigates the effects of carbonation on cement paste and mortar specimens at different scales. The results show that carbonation leads to the precipitation of different minerals and the development of material stiffness, which in turn affects the microcracking and permeability of the specimens. The formation of calcium carbonate also reduces the porosity and pore sizes.

JOURNAL OF CO2 UTILIZATION (2022)

Article Construction & Building Technology

Quantitative characterization of carbonation of cement-based materials using X-ray imaging

Shuxian Hong et al.

Summary: This study investigated the carbonation process of cement using non-destructive X-ray imaging technology, providing a new quantitative method for cement carbonation. The results showed that this method could accurately image the distribution of carbonation and obtain density changes. The method was consistent with the results obtained by thermogravimetric analysis.

CEMENT & CONCRETE COMPOSITES (2022)

Article Chemistry, Multidisciplinary

Semi-dry carbonation of recycled concrete paste

Maciej Zajac et al.

Summary: Demolished concrete can be utilized as a carbon sink, and its carbonation process can reduce CO2 emissions and promote the circularity and recycling of cement. This study found that decreasing gas humidity and water availability can limit the transport of reactants and result in the co-precipitation of carbonation products into a dense matrix structure.

JOURNAL OF CO2 UTILIZATION (2022)

Article Construction & Building Technology

Continuous optical in-situ pH monitoring during early hydration of cementitious materials

Isabel Galan et al.

Summary: A luminescent sensor technique for pH analyses has been successfully tested in cementitious media, allowing for in-situ monitoring of pH levels during early hydration reactions. The pH development in different types of cements was analyzed, showing correlation with heat of hydration and providing insights into solid phase dissolution and formation processes. This measurement technique enables continuous and reproducible recording of pH data, offering new perspectives on transformation pathways and reactions in high alkaline cementitious systems.

CEMENT AND CONCRETE RESEARCH (2021)

Article Chemistry, Analytical

Fluorescent molecular probe based optical fiber sensor dedicated to pH measurement of concrete

Ayedah Tariq et al.

Summary: An optical fiber sensor using a fluorescent molecular probe has been developed to measure the pH of cementitious materials, showing reversible and reliable responses to pH changes. It has the necessary characteristics for concrete study, with a response time of 100 seconds and a precision of +/- 0.1 pH units.

SENSORS AND ACTUATORS B-CHEMICAL (2021)

Article Green & Sustainable Science & Technology

A novel upcycling technique of recycled cement paste powder by a two-step carbonation process

Xiaoliang Fang et al.

Summary: This study presents an innovative two-step carbonation process to convert recycled cement waste into calcium-rich residue and silicon-rich gel, demonstrating the potential of upcycling demolished concrete waste into new value-added products.

JOURNAL OF CLEANER PRODUCTION (2021)

Article Green & Sustainable Science & Technology

Utilization of CO2 in direct aqueous carbonation of concrete fines generated from aggregate recycling: Influences of the solid-liquid ratio and CO2 concentration

Hsing-Jung Ho et al.

Summary: The research focuses on developing an effective aggregate recycling process for concrete waste and utilizing CO2 through direct aqueous carbonation using concrete fines. The results demonstrate that concrete fines are a promising candidate for CO2 utilization, with a high CO2 uptake efficiency under atmospheric pressure and low CO2 concentration conditions.

JOURNAL OF CLEANER PRODUCTION (2021)

Article Geosciences, Multidisciplinary

Global CO2 uptake by cement from 1930 to 2019

Rui Guo et al.

Summary: Because of the alkaline nature and high calcium content of cements, they can serve as a CO2-absorbing agent and reduce emissions during production. A life-cycle assessment is necessary to determine the actual net carbon impacts of the cement industry. Mortar is estimated to be the greatest contributor to the total carbon uptake among four types of cement materials.

EARTH SYSTEM SCIENCE DATA (2021)

Article Construction & Building Technology

Alternative pH-indicators for determination of carbonation depth on cement-based concretes

Nico Vogler et al.

CEMENT & CONCRETE COMPOSITES (2020)

Article Multidisciplinary Sciences

Carbon Capture and Utilization by mineralization of cement pastes derived from recycled concrete

Jan Skocek et al.

SCIENTIFIC REPORTS (2020)

Article Environmental Sciences

Highly efficient colorimetric CO2 sensors for monitoring CO2 leakage from carbon capture and storage sites

Kwanyoung Ko et al.

SCIENCE OF THE TOTAL ENVIRONMENT (2020)

Article Chemistry, Analytical

Fibre optic ratiometric fluorescence pH sensor for monitoring corrosion in concrete

Juergen Bartelmess et al.

ANALYST (2020)

Article Green & Sustainable Science & Technology

Application of natural and artificial tracers to constrain CO2 leakage and degassing in the K-COSEM site, South Korea

YeoJin Ju et al.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2019)

Article Construction & Building Technology

Reactive transport numerical modeling of mortar carbonation: Atmospheric and accelerated carbonation

Jena Jeong et al.

JOURNAL OF BUILDING ENGINEERING (2019)

Article Chemistry, Analytical

A Raman spectroscopy based optical fibre system for detecting carbonation profile of cementitious materials

Yanfei Yue et al.

SENSORS AND ACTUATORS B-CHEMICAL (2018)

Article Construction & Building Technology

Indicator of carbonation front in concrete as substitute to phenolphthalein

Servando Chinchon-Paya et al.

CEMENT AND CONCRETE RESEARCH (2016)

Article Chemistry, Analytical

Fluorescence based fibre optic pH sensor for the pH 10-13 range suitable for corrosion monitoring in concrete structures

T. Hien Nguyen et al.

SENSORS AND ACTUATORS B-CHEMICAL (2014)

Article Construction & Building Technology

Role of cement paste composition on the self induced stress in early-age mortars: Application of the Cosserat size number

Hamidreza Ramezani et al.

CEMENT & CONCRETE COMPOSITES (2013)

Article Thermodynamics

Chemo-physical modeling of cement mortar hydration: Role of aggregates

Jena Jeong et al.

THERMOCHIMICA ACTA (2013)

Article Engineering, Multidisciplinary

Size effect method application for modeling of human cancellous bone using geometrically exact Cosserat elasticity

Hamidreza Ramezani et al.

COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING (2012)

Article Engineering, Chemical

Injection of CO2 into saline formations: Benchmarking worldwide projects

Aleksandra Hosa et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2011)

Article Materials Science, Multidisciplinary

A new multi-scale modeling approach based on hygro-Cosserat theory for self-induced stress in hydrating cementitious mortars

Jena Jeong et al.

COMPUTATIONAL MATERIALS SCIENCE (2011)

Article Instruments & Instrumentation

Fiber-Optic Sensor Applications in Civil and Geotechnical Engineering

Wolfgang R. Habel et al.

PHOTONIC SENSORS (2011)

Article Engineering, Environmental

Sequestration of CO2 by Concrete Carbonation

Isabel Galan et al.

ENVIRONMENTAL SCIENCE & TECHNOLOGY (2010)

Article Economics

Carbon capture and storage

Jon Gibbins et al.

ENERGY POLICY (2008)

Article Chemistry, Analytical

A novel fabrication method of fiber-optical planar transmission sensors for monitoring pH in concrete structures

Marc Blumentritt et al.

SENSORS AND ACTUATORS B-CHEMICAL (2008)

Review Engineering, Environmental

A review of accelerated carbonation technology in the treatment of cement-based materials and sequestration of CO2

M Fernández Bertos et al.

JOURNAL OF HAZARDOUS MATERIALS (2004)

Article Engineering, Chemical

Development of a new CO2 sequestration process utilizing the carbonation of waste cement

A Iizuka et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2004)