4.7 Article

Improving performance of proton-exchange membrane (PEM) electro-ozonizers using 3D printing

Related references

Note: Only part of the references are listed.
Review Environmental Sciences

Microbubbles and their application to ozonation in water treatment: A critical review exploring their benefit and future application

Alexander John et al.

Summary: This review compares the use of microbubbles with conventional bubbles in the ozonation process. Microbubbles have a larger interfacial area and lower rise velocity, allowing for more efficient transfer of ozone into the liquid phase. Microbubbles have shown to oxidize organic compounds more quickly and enhance mass transfer. However, fair and consistent experimental comparisons between microbubbles and conventional bubbles are needed.

CRITICAL REVIEWS IN ENVIRONMENTAL SCIENCE AND TECHNOLOGY (2022)

Article Environmental Sciences

Toward real applicability of electro-ozonizers: Paying attention to the gas phase using actual commercial PEM electrolyzers technology

M. Rodriguez-Pena et al.

Summary: This study focuses on increasing the TRL of electro-ozonizer technology by evaluating the effect of electrolyte composition and operation conditions on the production of ozone. Results show that operating at low temperatures and high pressures is the most efficient way to produce ozone, and the importance of scavengers in the ozone production process was also discovered.

CHEMOSPHERE (2022)

Article Engineering, Chemical

Operating an ozone-evolving PEM electrolyser in tap water: A case study of water and ion transport

Roman Grimmig et al.

Summary: While PEM water electrolysis has potential for in situ sanitization with ozone, its application is limited by the need for ultrapure water for long-term stability. A study was conducted on the impact of different feed water qualities on the performance of a PEM tap water electrolyser for ozone evolution. Water transport was found to increase with applied current, while ion permeation was limited by ion transfer to the anode/PEM interface.

SEPARATION AND PURIFICATION TECHNOLOGY (2022)

Article Engineering, Chemical

Influence of pressure and cell design on the production of ozone and organic degradation

M. Rodriguez-Pena et al.

Summary: This study evaluates the effect of pressure on the electrochemical production of ozone and the degradation of organics in wastewater. The results show that the mechanical design and electrolyte composition have a significant impact on the performance of the electrolyzers. Increasing pressure can decrease the degradation rate of pesticides but increase ozone production. This may be attributed to the activation of ozone and its stability at different pressures.

SEPARATION AND PURIFICATION TECHNOLOGY (2022)

Article Engineering, Environmental

Does electro-peroxonation improve performance of electro-ozonation?

M. Rodriguez-Pena et al.

Summary: This study compares the degradation and mineralization of clopyralid using electrochemically produced hydrogen peroxide, ozone, and their mixture, and reveals important differences in the performance of the oxidation technologies. The co-existence of electrochemically produced hydrogen peroxide and ozone affects their concentrations in the bulk solution, leading to less efficient oxidation and mineralization of clopyralid with hydrogen peroxide and more efficient results with ozone. The combination of powerful oxidants in the mixture does not result in the expected synergism, but rather antagonistic responses.

JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING (2022)

Review Chemistry, Physical

New insights about the electrochemical production of ozone

Mayra Rodriguez-Pena et al.

Summary: Ozone is an efficient oxidant that can be used to oxidize pollutants and kill pathogens without generating hazardous waste. Electrochemical ozone production has advantages over traditional methods, but further development is needed to improve its value chain.

CURRENT OPINION IN ELECTROCHEMISTRY (2021)

Article Electrochemistry

Understanding ozone generation in electrochemical cells at mild pHs

M. Rodriguez-Pena et al.

Summary: This study evaluates the production of ozone at mild pH conditions using a commercial electrochemical PEM cell CONDIAPURE (R) and proposes a phenomenological model to understand the processes inside the cell. It is found that ozone production can be explained by the oxidation of water, while ozone decomposition plays a crucial role. The model successfully explains the impact of operation mode, current intensity, and presence of organics on ozone production.

ELECTROCHIMICA ACTA (2021)

Article Electrochemistry

On the production of ozone, hydrogen peroxide and peroxone in pressurize d undivide d electrochemical cells

Gustavo Acosta-Santoyo et al.

Summary: By comparing different electrode materials and applying different pressure values, it was found that the production of oxidants in undivided cells is complex. The results show that pressure has varying effects on the production of different oxidants, highlighting the importance of selecting the proper design for maximizing efficiency.

ELECTROCHIMICA ACTA (2021)

Article Electrochemistry

Disinfection of urines using an electro-ozonizer

Miguel Herraiz-Carbone et al.

Summary: This study demonstrates that complete disinfection of urines polluted with Klebsiella pneumoniae can be achieved in less than 180 minutes by using a commercial electro-ozonizer at current intensities higher than 0.5 A. The combination of ozone and chlorine-based disinfectants leads to higher removal efficiencies in comparison with ozone alone, especially at lower current intensities. Damage to cell walls by electrogenerated oxidants, as well as degradation of total proteins and DNA, are observed during the electrochemical process.

ELECTROCHIMICA ACTA (2021)

Article Engineering, Chemical

Electrochemical generation of ozone using a PEM electrolyzer at acidic pHs

M. Rodriguez-Pena et al.

Summary: This study focuses on electrochemically producing ozone in acidic conditions, finding that electrolytes containing perchlorate salts result in higher concentrations of ozone, and that increasing pressure and decreasing temperature have a positive impact on ozone production. A model considering all processes explains the fundamentals of ozone production in acidic conditions, validated by experimental results.

SEPARATION AND PURIFICATION TECHNOLOGY (2021)

Article Engineering, Environmental

A highly stable microporous boron-doped diamond electrode etched by oxygen plasma for enhanced electrochemical ozone generation

Fangmu Liu et al.

Summary: The study introduces a microporous BDD electrode etched by oxygen plasma (p-BDD) to enhance electrochemical ozone generation performance, with optimized etching parameters and significantly improved electrochemically active surface area and charge transfer resistance compared to bare BDD, resulting in 3.76 times higher ozone generation capacity under the same unit energy consumption.

JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING (2021)

Article Engineering, Chemical

Electro-ozonizers: A new approach for an old problem

J. A. Lara-Ramos et al.

SEPARATION AND PURIFICATION TECHNOLOGY (2020)

Article Engineering, Chemical

A novel simulation method for predicting ozone generation in corona discharge region

Yong Zhu et al.

CHEMICAL ENGINEERING SCIENCE (2020)

Review Chemistry, Multidisciplinary

3D-printing technologies for electrochemical applications

Adriano Ambrosi et al.

CHEMICAL SOCIETY REVIEWS (2016)

Article Materials Science, Multidisciplinary

An electrolyte-free system for ozone generation using heavily boron-doped diamond electrodes

Yuki Honda et al.

DIAMOND AND RELATED MATERIALS (2013)

Article Engineering, Environmental

Sulfamethoxazole abatement by means of ozonation

Renato F. Dantas et al.

JOURNAL OF HAZARDOUS MATERIALS (2008)

Article Electrochemistry

Characterization of a stirred tank electrochemical cell for water disinfection processes

A. M. Polcaro et al.

ELECTROCHIMICA ACTA (2007)

Article Chemistry, Multidisciplinary

Measurement of mass-transfer coefficients by an electrochemical technique

P. Canizares et al.

JOURNAL OF CHEMICAL EDUCATION (2006)