4.7 Article

Modulation of Molybdenum oxidation state via Catalytic-oxidation

Related references

Note: Only part of the references are listed.
Article Chemistry, Multidisciplinary

Suppression of Dissolution Rate via Coordination Complex in Tungsten Chemical Mechanical Planarization

Kangchun Lee et al.

Summary: A novel strategy involving the formation of coordination complex between picolinic acid and tungsten oxide suppresses tungsten dissolution and improves tungsten topography. Addition of 1.5 wt% picolinic acid as an inhibitor dramatically attenuates the dissolution rate of tungsten, leading to improved topography with an R-a value of 7.8 nm while validating CMP removal rate.

APPLIED SCIENCES-BASEL (2022)

Article Chemistry, Physical

Tungsten passivation layer (WO3) formation mechanisms during chemical mechanical planarization in the presence of oxidizers

Maneesh Kumar Poddar et al.

Summary: This study investigates the effects of single and mixed oxidants Fe(NO3)(3) and H2O2 on tungsten (W) CMP, revealing that mixed oxidants lead to a higher W polishing rate due to the in-situ generation of hydroxyl radicals ((OH)-O-center dot). This excessive generation of (OH)-O-center dot results in the formation of a passive WO3 film, converting the hard W film into a soft layer, ultimately enhancing the W removal rate during CMP.

APPLIED SURFACE SCIENCE (2021)

Article Materials Science, Multidisciplinary

Effects of H2O2 and pH on the Chemical Mechanical Planarization of Molybdenum

Heon-Yul Ryu et al.

Summary: The study revealed that H2O2 promotes the dissolution of Mo oxides and formation of peroxo Mo complexes. CMP showed higher removal rates at different pH levels, with pH 2 exhibiting lower SER and lower surface roughness.

ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY (2021)

Article Engineering, Electrical & Electronic

High-Temperature Specific Contact Resistance of Iron Disilicide Soldered to Molybdenum by Field's Metal

Antoine Micallef et al.

Summary: This study aimed to evaluate the suitability of a contact scheme for thermoelectric characterization of FeSi2-based materials with the combined thermoelectric measurement technique. The specific contact resistance was found to be suitably low up to 415 degrees C, but oxidation irreversibly degrades the electrical contact above this temperature.

ACS APPLIED ELECTRONIC MATERIALS (2021)

Article Chemistry, Physical

The joint automated repository for various integrated simulations (JARVIS) for data-driven materials design

Kamal Choudhary et al.

NPJ COMPUTATIONAL MATERIALS (2020)

Article Nanoscience & Nanotechnology

Triggering Sequential Catalytic Fenton Reaction on 2D MXenes for Hyperthermia-Augmented Synergistic Nanocatalytic Cancer Therapy

Ruijie Liang et al.

ACS APPLIED MATERIALS & INTERFACES (2019)

Article Materials Science, Multidisciplinary

Fenton-Like Reaction between Copper Ions and Hydrogen Peroxide for High Removal Rate of Tungsten in Chemical Mechanical Planarization

Kijung Kim et al.

ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY (2018)

Article Materials Science, Multidisciplinary

Chemical Mechanical Polishing of Mo Using H2O2 as Oxidizer in Colloidal Silica Based Slurries

Xin-Ping Qu et al.

ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY (2017)

Article Chemistry, Physical

Electrochemical Stability of Metastable Materials

Arunima K. Singh et al.

CHEMISTRY OF MATERIALS (2017)

Article Chemistry, Physical

Investigation of cu-BTA complex formation during Cu chemical mechanical planarization process

Byoung-Jun Cho et al.

APPLIED SURFACE SCIENCE (2016)

Article Electrochemistry

Effect of CoxMoy as Single Barrier Layer on Properties of Directly Electroplated Copper Films

Xu Wang et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)

Article Engineering, Electrical & Electronic

Study of direct Cu electrodeposition on ultra-thin Mo for copper interconnect

Xu Wang et al.

MICROELECTRONIC ENGINEERING (2016)

Article Chemistry, Physical

Generalized molybdenum oxide surface chemical state XPS determination via informed amorphous sample model

Jonas Baltrusaitis et al.

APPLIED SURFACE SCIENCE (2015)

Article Electrochemistry

Study of electrochemical bleaching of p-nitrosodimethylaniline and its role as hydroxyl radical probe compound

Jens Muff et al.

JOURNAL OF APPLIED ELECTROCHEMISTRY (2011)

Article Chemistry, Physical

Theoretical and Experimental Study of the Electronic Structures of MoO3 and MoO2

David O. Scanlon et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2010)

Article Chemistry, Physical

The effect of hydrogen peroxide on polishing removal rate in CMP with various abrasives

R. Manivannan et al.

APPLIED SURFACE SCIENCE (2009)

Article Chemistry, Multidisciplinary

Demonstration of the Fenton reaction

Dean C. Luehrs et al.

JOURNAL OF CHEMICAL EDUCATION (2007)

Article Materials Science, Multidisciplinary

Real-space grid implementation of the projector augmented wave method

JJ Mortensen et al.

PHYSICAL REVIEW B (2005)

Article Chemistry, Physical

Role of interaction forces in controlling the stability and polishing performance of CMP slurries

GB Basim et al.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2003)

Article Electrochemistry

Potential-pH diagrams of interest to chemical mechanical planarization of copper

S Tamilmani et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2002)