☆ 4.6 Article Proceedings Paper

Effect of non-uniform heat flux on solar thermoelectric generator

ENERGY REPORTS (2022)

Related references

Note: Only part of the references are listed.

Article Thermodynamics

Multi-sub-inlets at cathode flow-field plate for current density homogenization and enhancement of PEM fuel cells in low relative humidity

Yulin Wang et al.

Summary: This article investigates the use of multi-sub-inlet designs on the cathode flow-field plate of a polymer electrolyte membrane fuel cell to improve current density uniformity and overall cell performance. The results show that compared to conventional designs, the multi-sub-inlet design can improve oxygen distribution, enhance water removal capacity, and maintain a low pressure drop, leading to improved cell performance. Additionally, increasing the flow rate of the sub-inlets can further enhance the maximum power density while maintaining oxygen distribution uniformity.

ENERGY CONVERSION AND MANAGEMENT (2022)

Add to Collection

Article Thermodynamics

Optimal thermal management of server cooling system based cooling tower under different ambient temperatures

Wei He et al.

Summary: This study optimizes the thermal management of the internal server cooling cycle and external cold source water cycle in a data center to achieve significant power savings.

APPLIED THERMAL ENGINEERING (2022)

Add to Collection

Article Thermodynamics

Structural optimization of thermoelectric modules in a concentration photovoltaic-thermoelectric hybrid system

Minghui Ge et al.

Summary: This study investigated the influence of the structural parameters of a thermoelectric generator on the system efficiency of a photovoltaic-thermoelectric hybrid system. An optimal structural parameter for the TEG was identified, along with an analysis of its relationship with CPV temperature coefficient, concentration ratio, and cooling heat transfer coefficient.

ENERGY (2022)

Add to Collection

Article Thermodynamics

Three-dimensional numerical study of a cathode gas diffusion layer with a through/in plane synergetic gradient porosity distribution for PEM fuel cells

Yong Wang et al.

Summary: This study proposes a novel gradient porosity distribution technology in the cathode gas diffusion layer of a polymer electrolyte membrane fuel cell to enhance mass transfer and water removal. The results show that this technology has a greater advantage in improving cell performance and achieving more uniform internal physical quantity profiles.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

Add to Collection

Article Energy & Fuels

Lattice Boltzmann simulation of a gas diffusion layer with a gradient polytetrafluoroethylene distribution for a proton exchange membrane fuel cell

Yulin Wang et al.

Summary: In this study, the influence of polytetrafluoroethylene content and distribution on liquid transport behaviors in gas diffusion layers and the performance of proton exchange membrane fuel cells was investigated. The results indicate that an increased content of polytetrafluoroethylene favors liquid removal, but an extremely high content could weaken cell performance. Additionally, a reasonably higher polytetrafluoroethylene content in the inlet region of the gas diffusion layer benefits water drainage enhancement.

APPLIED ENERGY (2022)

Add to Collection

Article Energy & Fuels

Experimental study of thermoelectric generator with different numbers of modules for waste heat recovery

Minghui Ge et al.

Summary: This study investigates the effects of heat source temperature, flow, and module number on the thermoelectric performance of a thermoelectric generation system. The results show that the output power increases with the number of modules under high-flow conditions. The voltage uniformity coefficient can accurately indicate the voltage distribution uniformity. This study provides guidance for the design of high-efficiency thermoelectric generators.

APPLIED ENERGY (2022)

Add to Collection

Article Thermodynamics

Enhanced power extraction from thermoelectric generators considering non-uniform heat distribution

Miftah Y. Fauzan et al.

Summary: This paper presents a technique to enhance the performance of a thermoelectric generator under non-uniform heat distribution, validated through experimentation. A method for maximizing power to overcome the effects of non-uniform heat distribution is proposed.

ENERGY CONVERSION AND MANAGEMENT (2021)

Add to Collection

Article Thermodynamics

Experimental study on thermoelectric power generation based on cryogenic liquid cold energy

Minghui Ge et al.

Summary: This study designed and built a thermoelectric power generation system for cold energy. The experimental results showed that the temperature difference between the hot and cold ends increased in the liquid-phase and two-phase regions, but decreased and then increased in the gas-phase region. The poor heat transfer capacity at the hot end of the generator restricted the improvement of the temperature difference at the hot and cold ends.

ENERGY (2021)

Add to Collection

Article Green & Sustainable Science & Technology

Numerical investigation on the dynamic response characteristics of a thermoelectric generator module under transient temperature excitations

Ding Luo et al.

Summary: This work presents a three-dimensional transient numerical model of a thermoelectric generator module considering temperature-dependent properties and the topological connection of load resistance to study its dynamic response characteristics. The study compares and analyzes dynamic output power and conversion efficiency under steady and different transient temperature excitations, revealing that temperature rate influences the time delay in response and the stability of thermal responses. The dynamic response characteristic of output power is found to be synchronous with conversion efficiency, and periodic temperature excitation can amplify output power while maintaining steady-state conversion efficiency.

RENEWABLE ENERGY (2021)

Add to Collection

Article Thermodynamics

Electrical and mechanical analysis of a segmented solar thermoelectric generator under non-uniform heat flux

Samson Shittu et al.

ENERGY (2020)

Add to Collection

Review Thermodynamics

Automotive exhaust thermoelectric generators: Current status, challenges and future prospects

Zu-Guo Shen et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

Add to Collection

Proceedings Paper Energy & Fuels

Experimental performance study of a solar parabolic dish photovoltaic-thermoelectric generator

P. Bamroongkhan et al.

INNOVATIVE SOLUTIONS FOR ENERGY TRANSITIONS (2019)

Add to Collection

Article Thermodynamics

Theoretical and experimental analysis of a solar thermoelectric power generation device based on gravity-assisted heat pipes and solar irradiation

Zhang Zhe et al.

ENERGY CONVERSION AND MANAGEMENT (2016)

Add to Collection

Article Multidisciplinary Sciences

Non-equilibrium processing leads to record high thermoelectric figure of merit in PbTe-SrTe

Gangjian Tan et al.

NATURE COMMUNICATIONS (2016)

Add to Collection

Article Thermodynamics

Behavior of a thermoelectric power generation device based on solar irradiation and the earth's surface-air temperature difference

Zhang Zhe et al.

ENERGY CONVERSION AND MANAGEMENT (2015)

Add to Collection

Article Multidisciplinary Sciences

Cubic AgPbmSbTe2+m:: Bulk thermoelectric materials with high figure of merit

KF Hsu et al.

SCIENCE (2004)

Add to Collection

© Peeref 2019-2024. All rights reserved.