Related references
Note: Only part of the references are listed.Prediction and optimization of the yield stress of material extrusion specimens made of ABS, using numerical simulation and experimental tests
Carmita Camposeco-Negrete et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2022)
Fracture behavior of additively printed ABS: Effects of print architecture and loading rate
John P. Isaac et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2021)
Fracture behavior of 3D printed carbon fiber-reinforced polymer composites
Denizhan Yavas et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2021)
A novel generalized stress invariant-based strength model for inter-layer failure of FFF 3D printing PLA material
Tianyun Yao et al.
MATERIALS & DESIGN (2020)
Influence of raster orientation on the determination of fracture properties of polypropylene thin components produced by additive manufacturing
M. Lorenzo-Banuelos et al.
THEORETICAL AND APPLIED FRACTURE MECHANICS (2020)
Characterization of the Mechanical Properties of FFF Structures and Materials: A Review on the Experimental, Computational and Theoretical Approaches
Enrique Cuan-Urquizo et al.
MATERIALS (2019)
Novel mechanical models of tensile strength and elastic property of FDM AM PLA materials: Experimental and theoretical analyses
Yu Zhao et al.
MATERIALS & DESIGN (2019)
FDM process parameters influence over the mechanical properties of polymer specimens: A review
Diana Popescu et al.
POLYMER TESTING (2018)
Numerical and experimental studies of additively manufactured polymers for enhanced fracture properties
J. Li et al.
ENGINEERING FRACTURE MECHANICS (2018)
Fracture Toughness Improvement of Poly(lactic acid) Reinforced with Poly(ε-caprolactone) and Surface-Modified Silicon Carbide
Jie Chen et al.
ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2018)
Fracture behavior of additively manufactured acrylonitrile butadiene styrene (ABS) materials
Kevin R. Hart et al.
ENGINEERING FRACTURE MECHANICS (2017)
Fracture resistance measurement of fused deposition modeling 3D printed polymers
Nahal Aliheidari et al.
POLYMER TESTING (2017)
Weld formation during material extrusion additive manufacturing
Jonathan E. Seppala et al.
SOFT MATTER (2017)
Measurements of the mechanical response of unidirectional 3D-printed PLA
Y. Song et al.
MATERIALS & DESIGN (2017)
The rise of 3-D printing: The advantages of additive manufacturing over traditional manufacturing
Mohsen Attaran
BUSINESS HORIZONS (2017)
Experimental characterization and micrography of 3D printed PLA and PLA reinforced with short carbon fibers
Rafael Thiago Luiz Ferreira et al.
COMPOSITES PART B-ENGINEERING (2017)
Effects of annealing time and temperature on the crystallinity and heat resistance behavior of injection-molded poly(lactic acid)
Yottha Srithep et al.
POLYMER ENGINEERING AND SCIENCE (2013)
NIH Image to ImageJ: 25 years of image analysis
Caroline A. Schneider et al.
NATURE METHODS (2012)
Thermal and Strain-Induced Chain Ordering in Lactic Acid Stereocopolymers: Influence of the Composition in Stereomers
G. Stoclet et al.
MACROMOLECULES (2011)
Effect of annealing on the fracture toughness of poly(lactic acid)
SD Park et al.
JOURNAL OF MATERIALS SCIENCE (2004)
A literature review of poly(lactic acid)
D Garlotta
JOURNAL OF POLYMERS AND THE ENVIRONMENT (2001)
Share Paper
