4.6 Article

High-Tap-Density Sulfur Cathodes Made Beyond 400 °C for Lithium-Sulfur Cells with Balanced Gravimetric/Volumetric Energy Densities

Related references

Note: Only part of the references are listed.
Article Materials Science, Multidisciplinary

Minimizing Carbon Content with Three-in-One Functionalized Nano Conductive Ceramics: Toward More Practical and Safer S Cathodes of Li-S Cells

Ning Li et al.

Summary: Replacing carbon materials with indium-doped tin oxide (ITO) nanoceramics as hosts in Li-S cathodes can increase electrode density, reduce electrolyte usage, improve flame retardance, and exhibit good lithium storage performance.

ENERGY & ENVIRONMENTAL MATERIALS (2023)

Article Chemistry, Multidisciplinary

Stabilization of gamma sulfur at room temperature to enable the use of carbonate electrolyte in Li-S batteries

Rahul Pai et al.

Summary: This study investigates the stability of lithium sulfur batteries in carbonate electrolyte. The authors found that monoclinic gamma-sulfur on activated carbon nanofibers converts to Li2S without the formation of intermediate polysulfides, leading to improved cycling stability.

COMMUNICATIONS CHEMISTRY (2022)

Article Energy & Fuels

Formulating energy density for designing practical lithium-sulfur batteries

Guangmin Zhou et al.

Summary: The authors analyze key Li-S cell parameters, propose an energy density calculation, and discuss the design targets for practical high-performance Li-S batteries.

NATURE ENERGY (2022)

Article Chemistry, Multidisciplinary

Realizing High Utilization of High-Mass-Loading Sulfur Cathode via Electrode Nanopore Regulation

Shuibin Tu et al.

Summary: The study presents the design of chunky sulfur/graphene particle electrodes, which achieve stable electrodes and high utilization of active materials through the vertical alignment of active sulfur and the inclusion of heteroatoms in chunky graphene particles.

NANO LETTERS (2022)

Article Engineering, Environmental

Polyacrylonitrile-induced formation of core-shell carbon nanocages: Enhanced redox kinetics towards polysulfides by confined catalysis in Li-S batteries

Hongcheng Gao et al.

Summary: By preparing nitrogen-doped carbon frame with cobalt nanoparticles supported in a carbon shell, the redox kinetics of polysulfides were efficiently promoted. As a result, the sulfur cathode based on such confined hollow core/shell nanocages delivered high capacity and outstanding cycling stability.

CHEMICAL ENGINEERING JOURNAL (2021)

Review Chemistry, Multidisciplinary

Strategy of Enhancing the Volumetric Energy Density for Lithium-Sulfur Batteries

Ya-Tao Liu et al.

Summary: This review focuses on the challenges and key factors in improving the volumetric energy density of lithium-sulfur batteries, proposes strategies for overcoming these challenges, and discusses key technologies for improving performance by enhancing the cathode materials.

ADVANCED MATERIALS (2021)

Review Chemistry, Physical

Encapsulation methods of sulfur particles for lithium-sulfur batteries: A review

Shiqi Li et al.

Summary: This review discusses the application of core-shell structured sulfur composite nanoparticles and their derivatives in Li-S batteries, focusing on the encapsulation strategy for producing optimally structured sulfur NPs. It analyzes the strengths and weaknesses of various methods, as well as the electrochemical properties and performance of resulting NPs in LSB technology.

ENERGY STORAGE MATERIALS (2021)

Article Chemistry, Multidisciplinary

MOF-Derived Bifunctional Co0.85Se Nanoparticles Embedded in N-Doped Carbon Nanosheet Arrays as Efficient Sulfur Hosts for Lithium-Sulfur Batteries

Yonghui Xie et al.

Summary: A novel design strategy utilizing Co0.85Se nanoparticles embedded in nitrogen-doped carbon nanosheet arrays on carbon cloth as a self-supported host for a sulfur cathode is introduced in the article. This design can effectively improve the cycle performance and discharge specific capacity of lithium-sulfur batteries.

NANO LETTERS (2021)

Article Chemistry, Multidisciplinary

The Dual Functions of Defect-Rich Carbon Nanotubes as Both Conductive Matrix and Efficient Mediator for Li-S Batteries

Jicheng Jiang et al.

Summary: Introducing defects in carbon nanotubes to anchor polysulfides and accelerate electrochemical reactions can dramatically improve cycling and rate performance of Li-S batteries. The defect-rich carbon has a higher binding energy with polysulfides, allowing for cycling stability up to 1000 cycles even under high sulfur loading and lean electrolyte conditions. This new design strategy may lead to mediator-like carbon materials with good conductivity and high catalytic activity for Li-S batteries.

SMALL (2021)

Article Chemistry, Multidisciplinary

MXene-Derived TinO2n-1 Quantum Dots Distributed on Porous Carbon Nanosheets for Stable and Long-Life Li-S Batteries: Enhanced Polysulfide Mediation via Defect Engineering

Heng Zhang et al.

Summary: An effective strategy was developed to confine and promote the conversion of polysulfides by decorating oxygen-vacancy-rich SnO2n-1 quantum dots on porous carbon nanosheets. Using Ti3C2Tx MXene as starting materials, the design enhances the immobilization and conversion of polysulfides, providing high S loading, good rate capability, and excellent long-term cyclability.

ADVANCED MATERIALS (2021)

Article Chemistry, Physical

Tubular CoFeP@CN as a Mott-Schottky Catalyst with Multiple Adsorption Sites for Robust Lithium-Sulfur Batteries

Chaoqi Zhang et al.

Summary: A Mott-Schottky catalyst based on bimetallic phosphide CoFeP nanocrystals supported on carbon nitride tubular nanostructures is proposed to enhance the performance of lithium-sulfur batteries. The CoFeP@CN composites demonstrated superior rate performance and cycling stability, effectively addressing the issues often overlooked in LSBs.

ADVANCED ENERGY MATERIALS (2021)

Article Chemistry, Multidisciplinary

Selective Catalysis Remedies Polysulfide Shuttling in Lithium-Sulfur Batteries

Wuxing Hua et al.

Summary: Selective catalysis is proposed as a fundamental remedy for the shuttle effect of soluble lithium polysulfides in Li-S batteries, benefiting from its ability to decelerate the accumulation of polysulfides and enhance battery performance, as experimentally and theoretically demonstrated in this study.

ADVANCED MATERIALS (2021)

Article Chemistry, Physical

A Nickel-Decorated Carbon Flower/Sulfur Cathode for Lean-Electrolyte Lithium-Sulfur Batteries

Yuchi Tsao et al.

Summary: By designing a flower-shaped porous carbon structure with nickel nanoparticles, the issues of large polarization, low sulfur utilization, and capacity fade in lithium-sulfur batteries have been addressed. The 3D flower-shaped carbon structure enables short ionic transport lengths, while the small pore diameters and sufficient pore volume are ideal for improving charging performance at low electrolyte to sulfur ratios. The use of Ni nanoparticles on the flower-shaped network improves reaction kinetics, leading to successful demonstration of batteries with high mass loading and good cycle retention.

ADVANCED ENERGY MATERIALS (2021)

Review Energy & Fuels

Modulating the lithiophilicity at electrode/electrolyte interface for high-energy Li-metal batteries

Cai-Cai Li et al.

Summary: This review discusses the importance of lithiophilicity at the anode/electrolyte interface for stable and safe operation of high-energy rechargeable batteries, as well as factors and strategies affecting the lithiophilicity of electrolytes. The review explores electrolyte surface energy, roughness, and chemical interactions, shedding light on interfacial chemistry vs. Li metal and guiding interfacial engineering towards practical realization of high-energy rechargeable batteries.

ENERGY MATERIALS (2021)

Article Chemistry, Physical

Revisiting the Role of Conductivity and Polarity of Host Materials for Long-Life Lithium-Sulfur Battery

Byong-June Lee et al.

ADVANCED ENERGY MATERIALS (2020)

Review Chemistry, Multidisciplinary

Chalcogen cathode and its conversion electrochemistry in rechargeable Li/Na batteries

Ya-Hui Wang et al.

SCIENCE CHINA-CHEMISTRY (2020)

Review Chemistry, Multidisciplinary

The Regulating Role of Carbon Nanotubes and Graphene in Lithium-Ion and Lithium-Sulfur Batteries

Ruopian Fang et al.

ADVANCED MATERIALS (2019)

Article Chemistry, Multidisciplinary

Hollow Multi-Shelled Structural TiO2-x with Multiple Spatial Confinement for Long-Life Lithium-Sulfur Batteries

Esmail Husein M. Salhabi et al.

ANGEWANDTE CHEMIE-INTERNATIONAL EDITION (2019)

Article Chemistry, Multidisciplinary

Single Nickel Atoms on Nitrogen-Doped Graphene Enabling Enhanced Kinetics of Lithium-Sulfur Batteries

Linlin Zhang et al.

ADVANCED MATERIALS (2019)

Article Chemistry, Physical

Solvent-Mediated Li2S Electrodeposition: A Critical Manipulator in Lithium-Sulfur Batteries

Zhejun Li et al.

ADVANCED ENERGY MATERIALS (2019)

Article Engineering, Environmental

Sulfur-embedded porous carbon nanofiber composites for high stability lithium-sulfur batteries

Kang Weimin et al.

CHEMICAL ENGINEERING JOURNAL (2018)

Article Electrochemistry

Intrinsic Shuttle Suppression in Lithium-Sulfur Batteries for Pouch Cell Application

Christine Weller et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2017)

Review Chemistry, Physical

Gravimetric and volumetric energy densities of lithium-sulfur batteries

Weijiang Xue et al.

CURRENT OPINION IN ELECTROCHEMISTRY (2017)

Article Nanoscience & Nanotechnology

Steam-Etched Spherical Carbon/Sulfur Composite with High Sulfur Capacity and Long Cycle Life for Li/S Battery Application

Meiri Wang et al.

ACS APPLIED MATERIALS & INTERFACES (2015)

Article Nanoscience & Nanotechnology

In Situ Raman Spectroscopy of Sulfur Speciation in Lithium-Sulfur Batteries

Heng-Liang Wu et al.

ACS APPLIED MATERIALS & INTERFACES (2015)

Article Chemistry, Physical

High Energy Density Lithium-Sulfur Batteries: Challenges of Thick Sulfur Cathodes

Dongping Lv et al.

ADVANCED ENERGY MATERIALS (2015)

Article Chemistry, Physical

The Use of Redox Mediators for Enhancing Utilization of Li2S Cathodes for Advanced Li-S Battery Systems

Stefano Meini et al.

JOURNAL OF PHYSICAL CHEMISTRY LETTERS (2014)

Article Multidisciplinary Sciences

Conductive two-dimensional titanium carbide 'clay' with high volumetric capacitance

Michael Ghidiu et al.

NATURE (2014)

Article Nanoscience & Nanotechnology

Mesoporous Carbon-Carbon Nanotube-Sulfur Composite Microspheres for High-Areal-Capacity Lithium-Sulfur Battery Cathodes

Terrence Xu et al.

ACS APPLIED MATERIALS & INTERFACES (2013)

Article Chemistry, Physical

Sulfur/Carbon Nanotube Composite Film as a Flexible Cathode for Lithium-Sulfur Batteries

Kangke Jin et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2013)

Article Chemistry, Multidisciplinary

Porous Hollow Carbon@Sulfur Composites for High-Power Lithium-Sulfur Batteries

N. Jayaprakash et al.

ANGEWANDTE CHEMIE-INTERNATIONAL EDITION (2011)