Related references
Note: Only part of the references are listed.
Article
Thermodynamics
Wei Zhang et al.
Summary: The study used a real-time measurement database to analyze heat transfer in flue-gas heat recovery units, establishing a semi-experimental formula to address the relationship between dew point temperature and heat transfer coefficient. The research found that the heat transfer coefficient is sensitive to the inlet temperature of cooling water, and also established a dimensionless formula to address the relationship among convection heat transfer coefficient and other operational parameters.
Article
Thermodynamics
Yiyu Men et al.
Summary: By implementing a novel flue gas waste heat recovery system on the boiler, thermal efficiency can be improved and oxynitride emissions reduced, resulting in higher energy utilization efficiency. The system achieves a heat recovery efficiency of 82.6%, increases boiler efficiency by 7-8%, reduces oxynitride emissions by 82.3%, and brings energy savings, emission reduction, and economic benefits.
ENERGY CONVERSION AND MANAGEMENT
(2022)
Article
Thermodynamics
Hao Zhou et al.
Summary: This investigation studied the heat transfer and resistance characteristics of a serrated helical finned tube under steam in tube condition. A bent serrated spiral finned tube was proposed based on the traditional design. The results showed that the bent fins improved heat transfer rate and pressure drop compared to ordinary fins. Increasing steam flow enhanced heat transfer performance without significantly affecting pressure drop. Overall performance evaluation indicated that the bend fin with a small fin pitch outperformed the traditional design by 15.18-17.05%. A correlation for Colburn factor and friction factor was also fitted for practical engineering suggestions.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
(2022)
Article
Thermodynamics
Giovanni A. Longo et al.
Summary: This paper presents the local heat transfer coefficients of R32 and R410A boiling inside a Brazed Plate Heat Exchanger. A new and innovative test section was designed and manufactured for measuring the local heat transfer coefficient in refrigerant two-phase heat transfer. The experimental results show that R32 and R410A exhibit similar boiling heat transfer coefficients, and nucleate boiling is the dominant heat transfer regime. The consolidated correlations for boiling inside BPHE agree well with the experimental data.
APPLIED THERMAL ENGINEERING
(2022)
Article
Energy & Fuels
Huijun Feng et al.
Summary: A marine boiler model composed of major heat transfer components is constructed in this study, and its design and optimization are performed. The results show that by changing the dimensions of the components, the weighted sum function can be minimized. After optimization, the performance of the marine boiler is significantly improved, meeting multiple design requirements for practical boilers.
Article
Environmental Sciences
Cavan McCaffery et al.
Summary: This study evaluated the gaseous and particulate emissions from a Tier 2 oceangoing vessel using two emission control area (ECA) compliant fuels. Results showed that the novel ultra-low sulfur heavy fuel oil (ULSHFO) had slightly higher nitrogen oxide (NOx) emissions for both the main and auxiliary engines, and significantly increased NOx emissions for the auxiliary boiler. Additionally, ULSHFO had higher PM2.5 and black carbon emissions, with little contribution of sulfate due to the low sulfur content in both fuels.
ATMOSPHERIC ENVIRONMENT
(2021)
Article
Thermodynamics
Ahmad Faraj et al.
Summary: Predicting heat exchangers performance is crucial in machine design, especially when industrial environments demand size reduction or cost saving. Traditional empirical methods lack physical meaning, prompting the development of a semi-empirical method presented in this study. Experimental validation shows low relative errors for both the proposed method and mathematical approaches.
CASE STUDIES IN THERMAL ENGINEERING
(2021)
Article
Thermodynamics
Tae-Woo Lim et al.
Summary: Double and added double stage organic Rankine cycle systems are utilized to recover exhaust gas waste heat of dual fuel engines. After energy, exergy, and economic analyses, several working fluid combinations are evaluated to improve system performance. The optimal working fluid combinations are recommended based on power, heat transfer area, and payback period considerations.
ENERGY CONVERSION AND MANAGEMENT
(2021)
Article
Energy & Fuels
Jorn Hinrichs et al.
Summary: Modeling framework was developed for numerical simulations of complex flow-field patterns in condensing gas boilers, using flamelet progress variable model and other models to address challenges like high computational times. The models were validated against resolved simulation results and experimental measurements, showing reasonable agreement.
Review
Thermodynamics
Simone Lion et al.
ENERGY CONVERSION AND MANAGEMENT
(2020)
Article
Thermodynamics
Na Qin et al.
APPLIED THERMAL ENGINEERING
(2020)
Article
Thermodynamics
Zhuojun Xie et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
(2019)
Article
Engineering, Multidisciplinary
A. A. Zhinov et al.
AIN SHAMS ENGINEERING JOURNAL
(2018)
Proceedings Paper
Energy & Fuels
Jiraroch Somjun et al.
2017 INTERNATIONAL CONFERENCE ON ALTERNATIVE ENERGY IN DEVELOPING COUNTRIES AND EMERGING ECONOMIES
(2017)
Review
Thermodynamics
Dig Vijay Singh et al.
ENERGY CONVERSION AND MANAGEMENT
(2016)
Review
Thermodynamics
M. A. Ebadian et al.
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME
(2011)
